Resumo do conteúdo contido na página número 1
;22/*\"&WCN"*CPFUGV"%QTFNGUU"2JQPG
YKVJ"%CNNGT"+&"CPF"&KIKVCN"#PUYGTKPI"5[UVGO
43-3820
Two Cordless Handsets — allow greater
convenience in placement of handsets.
10 Number Memory Dialing — stores 10
numbers in memory on each handset for easy
dialing. See “Memory Dialing” on Page 17.
Long Battery Life — the supplied battery pack
(when fully charged) provides about seven
hours of talk time or seven days of standby time.
20 Channels — automatically selects a clear
channel when you make or ans
Resumo do conteúdo contido na página número 2
Important Safety Instructions WARNING: To reduce the risk of fire or shock hazard, do not expose this product to rain or moisture. %106'065 CAUTION: TO REDUCE THE RISK OF ELECTRIC Battery Safety Instructions ........ 4 .CAUTION. SHOCK, DO NOT REMOVE COVER OR BACK. NO USER-SERVICEABLE PARTS INSIDE. REFER Introduction ............................... 5 RISK OF ELECTRIC SHOCK SERVICING TO QUALIFIED PERSONNEL. ! DO NOT OPEN Important Caller ID The lightning symbol is intended to alert you to Inf
Resumo do conteúdo contido na página número 3
11. Slots and openings in the telephone’s cabinet %106'065 and the back or bottom are provided for (continued) ventilation. To protect the telephone from Using Speed Dial................22 Deleting a Number in overheating, these openings must not be Memory .............................22 blocked or covered. The openings should Caller ID Operation ................. 22 Reviewing Caller ID never be blocked by placing the product on a Records ............................... 23 bed, sofa, rug,
Resumo do conteúdo contido na página número 4
Battery Safety Instructions • If the product has been exposed to rain or water. • If the product does not operate normally by following the operating instructions. 18. Adjust only those controls that are covered by the operating instructions because improper adjustments of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to normal operation. 19. If the product has been dropped or the cabinet has been damaged. 20. I
Resumo do conteúdo contido na página número 5
• Charge the battery pack provided with or identified for use with this product only in accordance with the instructions and limitations specified in the instruction manual provided for this product. • Observe proper polarity orientation between the battery pack and battery charger. 5#8'"6*'5'" +05647%6+105 +0641&7%6+10 Thank you for purchasing a RadioShack 900 MHz "+/2146#06" # # Cordless Telephone. Your telephone provides Cordless phones such as excellent clarity and range and integrate
Resumo do conteúdo contido na página número 6
Important Caller ID Information • caller’s number only • caller’s name only • caller’s name and number If you subscribe to Call Waiting ID and Caller ID, the system can show you the incoming caller information, even when you are already talking on the phone. 4'#&"6*+5"$'(14'"+056#..#6+10 We have designed your phone to conform to federal regulations and you can connect it to most phone lines. However, each device that you connect to the telephone line draws power from the line. We refer to
Resumo do conteúdo contido na página número 7
+056#..#6+10 /1706+0)"6*'"2*10' You can place the phone on a desk or table, mount ."%#76+10". it on a standard wall plate, or directly on a wall. You must use a Choose a location that is: ! Class 2 power source that • near an AC outlet supplies 9V DC and • near a modular telephone line jack delivers at least 350 mA. Its center tip must be set • out of the way of normal activities to positive and its plug • away from electrical machinery, electrical must fit the phone's DC appliances,
Resumo do conteúdo contido na página número 8
Installation 5. Plug the adapter into a standard AC outlet. 6. Lift the base’s antenna to a vertical position. 1P"C"9CNN"2NCVG"QT"9CNN To mount the phone directly on a wall, you need two DC IN 9V TEL LINE screws (not supplied) with heads that fit into the 15 keyhole slots on the base. Drill two holes 3 /16 inches apart. Thread a screw into each hole, 1 8 leaving the heads extended about / inch. 1. Plug one end of the supplied modular cord (short for a wall plate, long for direct wall TEL L
Resumo do conteúdo contido na página número 9
%100'%6+0)."%*#4)+0)"#0&" "+/2146#06" # # 4'2.#%+0)"6*'"$#66'4;"2#%- Be sure the battery pack is The phone comes with a rechargeable Ni-Cd properly connected before (nickel-cadmium) battery pack installed in each you try to charge it. The handset, but not connected. Before using your CHARGE LED lights when the handset is on the base phone, you must connect the battery packs, then or cradle even if the battery charge them for about 24 hours. pack is not connected 1. Press down and sli
Resumo do conteúdo contido na página número 10
Installation About once a month, fully discharge the battery pack by keeping the handset off the base or cradle until Be Bemý mý88WWjj jj[h [hoo flashes. Otherwise, the battery Be Bemý mý88WWjj jj[h [hoo pack loses its ability to fully recharge. The supplied battery pack should last about a year. If the battery pack does not hold a charge for more than 2 hours after an overnight charge, replace it with a new 3.6V, 600 mAh battery pack with a connector that fits the socket in the battery
Resumo do conteúdo contido na página número 11
display. The handset charged in the cradle must also be registered with the base prior to use. Place the second handset on the base. The base’s CHARGE LED flashes. When the registration is complete >I( >I( appears in the second handset’s >I( >I( display.± 5'66+0)"6*'"&+#.+0)"/1&' ±"016'"±" Your phone comes set for tone dialing. If you have Registering the Second pulse service, you need to change the dialing mode. Handset • Once registered, you If you are not sure which type of service yo
Resumo do conteúdo contido na página número 12
Installation If the battery power is too low, the dial mode might reset to tone. If you are on a pulse line and cannot make a call, try re-setting the dialing mode to pulse. 5'66+0)"6*'"*#0&5'6N5"4+0)'4" 610'181.7/' You can select one of the handsets’ four different ringer tone/volume settings or turn the ringers off. You can also select a different tone/volume for each handset. At any time, except during a call, repeatedly press 8 8 or 9 to select the desired ringer setting. Each 8 8 tim
Resumo do conteúdo contido na página número 13
5'66+0)"#761"6#.- Your phone is preset so you must press TALK/ FLASH to answer a call. With Auto Talk turned on, you can answer a call by just lifting the handset from the baseor cradle. Auto Talk is independent in each handset. You can set each handset differently. 1. Lift the handset and hold down CID/MENU until the setup menu appears. CH/SEL 2. Press to change the Auto Talk setting. Ed Ed or E\ E\\\ appears. Ed Ed E\ E\\\ 3. To clear the screen when you finish, press END or return the
Resumo do conteúdo contido na página número 14
Telephone Operation 1. Lift the handset and hold down CID/MENU until the menu appears. 2. Press 3 or 9 9 twice to selectý7h ý7h[[Wý9eZ[ Wý9eZ[. 9 9 ý7h ý7h[[Wý9eZ[ Wý9eZ[ 3. Press CH/SEL, then enter your three-digit area code. If you make a mistake, repeatedly press ** 6 6/TONE or # #7 ** 6 6 # # to move the cursor over the incorrect digit, then enter the correct number. ±"016'"±" ±ý If an area code is already stored, it appears on the 4. Press CH/SEL to store the area code, then display
Resumo do conteúdo contido na página número 15
number including ** or # #. 9edd 9edd[[YYj_d] j_d], then JW JWbba a and ** # # 9edd 9edd[[YYj_d] j_d] JW JWbba a the current volume setting appears. To end a call, place the handset on the base or END cradle, or press . 5'.'%6+0)"6*'"%*#00'. The phone scans 20 channels (frequency pairs used between the base and the handset) and automatically selects a clear channel when you make or receive a call. If you hear other conversations or excessive noise CH/SEL during a call, press to select a d
Resumo do conteúdo contido na página número 16
Telephone Operation disconnecting the current call. Press TALK/FLASH again to return to the first call. If you do not have any special phone services, TALK/FLASH pressing might disconnect the current call. 75+0)"4'&+#. To quickly dial the last number dialed, lift the handset and press RDL/PAUSE, then press TALK/ FLASH RDL/PAUSE . You can also press after ±"016'"±" pressing TALK/FLASH. ±ý • The redial memory holds up to 32 digits, so you /76+0)"6*'"4+0)'4 can redial long-distance, To te
Resumo do conteúdo contido na página número 17
64#05('44+0)"#"%#.. ±"016'"±" You can transfer an outside call from one handset to the other.± Transferring a Call • You cannot transfer a call Press TRSF/DEL during a call. The call is to the base’s answering automatically put on hold, and the transfer tone machine. sounds. • Only one handset can talk at one time. You cannot Pick up the other handset from the base or cradle accomplish a 3-way TALK/FLASH and press . If auto talk is on, just pick conference call, or make a up the handse
Resumo do conteúdo contido na página número 18
Telephone Operation 1. Lift the handset. MEM C C[[ceho cehoýýI Ijjeeh[ h[ 2. Hold down until C C[[ceho cehoýýI Ijjeeh[ h[ and a list of memory location numbers appear. 3. Select a memory location (1–0) by pressing a 9 8 number or repeatedly pressing or . 4. Press CH/SEL. Ij Ijeh[ýD eh[ýDWWc[ c[ appears. If you do Ij Ijeh[ýD eh[ýDWWc[ c[ not want to enter a name, skip to Step 6. 5. To enter a name, use the number keys. To enter two letters from the same key in a row, press #/7 7 to move t
Resumo do conteúdo contido na página número 19
Line” on Page 16 and “Entering a Pause” on ±ý Page 20). ±"016'"±" Each tone or pause entry 8. Press CH/SEL. The phone beeps and C[ C[c ceehhooýýd dýý C[ C[c ceehhooýýd dýý uses one digit of memory. Ij Ijeh[ eh[ZZ (dd is the memory location number) Ij Ijeh[ eh[ZZ dd appears. C C[[ceho cehoýýIIjjeeh[ h[ reappears. Repeat Steps 3–8 to C C[[ceho cehoýýIIjjeeh[ h[ store more numbers. END 9. When you finish, press . To replace a stored number, store a new one in its place. 'FKVKPI"QT"&GNGVKPI"C"0
Resumo do conteúdo contido na página número 20
Telephone Operation 'PVGTKPI"C"2CWUG Some telephone systems require you to dial an access code (9, for example) and wait for a second dial tone before you can dial an outside number. You can store the access code with the phone number. However, you should also store a pause after the access code to allow the outside line time to connect. To enter a 2-second pause, press RDL/PAUSE. FF FF appears. You can add more pause entries for a longer pause. 4GXKGYKPI"/GOQT["0WODGTU To review your m
