Resumo do conteúdo contido na página número 1
43-3557.book 1 ページ ２００３年１２月１７日 水曜日 午後４時５４分
2.4 GHz Cordless Telephone
Caller ID/Call Waiting ID
43-3557
Ten-Number Memory Dialing — lets you store up to ten numbers in
memory for easy dialing. (See “Memory Dialing” on page 19.)
Ample Talk and Standby Time —
the supplied battery (when fully
charged) provides about 7 hours of
talk time or 14 days of standby time.
Headset Jack — lets you connect an
optional headset for hands-free
convenience. (See “Headset
Installation” on page 32.)
Auto T
Resumo do conteúdo contido na página número 2
43-3557.book 2 ページ ２００３年１２月１７日 水曜日 午後４時５４分 CONTENTS Introduction ................................... 3 Caller ID ...................................... 28 When the Telephone Rings .............. 28 Important Information ................... 4 Viewing the Caller ID Message List . 29 FCC Statement .................................. 4 Deleting Information from the Caller Surge Protection ................................ 5 ID List ............................................ 29 Important Safety In
Resumo do conteúdo contido na página número 3
43-3557.book 3 ページ ２００３年１２月１７日 水曜日 午後４時５４分 INTRODUCTION Thank you for purchasing a RadioShack 2.4 GHz Cordless Telephone. Your phone uses advanced technology to give you superior audio quality and extended range. The phone’s Caller ID unit records each caller’s telephone number (and name, if available in your area) and the date and time of the call, as provided by your local phone company to Caller ID service subscribers. If you subscribe to Call Waiting with Caller ID, the phone sho
Resumo do conteúdo contido na página número 4
Important Information 43-3557.book 4 ページ ２００３年１２月１７日 水曜日 午後４時５４分 As an ENERGYSTAR Partner, RadioShack Corporation has determined that this product meets the ENERGYSTAR guidelines for energy efficiency. IMPORTANT INFORMATION This telephone has been tested and found to comply with all applicable UL and FCC standards. FCC STATEMENT Your telephone compiles with Part 68 of the FCC Rules.Upon request, you must provide the phone’s FCC registration number and REN to your phone company. These
Resumo do conteúdo contido na página número 5
43-3557.book 5 ページ ２００３年１２月１７日 水曜日 午後４時５４分 ringer operation is impaired, remove a device from the line. In the unlikely event that your phone causes problems on the phone line, the phone company can temporarily discontinue your service. If this happens, the phone company attempts to notify you in advance. If advance notice is not practical, the phone company notifies you as soon as possible and advises you of your right to file a complaint with the FCC. Also, the phone company can ma
Resumo do conteúdo contido na página número 6
Important Safety Instructions 43-3557.book 6 ページ ２００３年１２月１７日 水曜日 午後４時５４分 IMPORTANT SAFETY INSTRUCTIONS When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: 1. Do not use this product near water, for example, near a bathtub, wash bowl, kitchen sink, or laundry tub, in a wet basement or near a swimming pool. 2. Avoid using a telephone (other than a cordless type) duri
Resumo do conteúdo contido na página número 7
43-3557.book 7 ページ ２００３年１２月１７日 水曜日 午後４時５４分 IMPORTANT CALLER ID INFORMATION To use Caller ID and Call Waiting, you must be in an area where those services are available and you must subscribe to those services through your local phone company. Where Caller ID is offered, one or more options are generally available: caller’s number only caller’s name only caller’s name and number If you subscribe to Call Waiting ID and Caller ID, the system can show you the incoming caller informat
Resumo do conteúdo contido na página número 8
Installation 43-3557.book 8 ページ ２００３年１２月１７日 水曜日 午後４時５４分 INSTALLATION Before using your phone, carefully peel the protective film off the display. The film protects the handset window during shipment and is not necessary for use. SELECTING A LOCATION You can place the phone’s base on a desk or table, or mount it on a standard wall plate or directly on a wall. Select a location that is:Ô near an accessible AC outlet near a telephone line jack out of the way of normal activities aw
Resumo do conteúdo contido na página número 9
43-3557.book 9 ページ ２００３年１２月１７日 水曜日 午後４時５４分 ON A DESK TOP 1. Plug one end of the supplied long TEL DC IN 9V modular cord into LINE the TEL LINE jack on the back of the base. 2. Insert the supplied CAUTION AC adapter’s You must use barrel plug into the a Class 2 ! power source DC IN 9V jack on that supplies the back of the 9V DC and delivers at base and route the least 210 mA. Its center adapter’s cord tip must be set to through the strain positive and its plug must fit th
Resumo do conteúdo contido na página número 10
Installation 43-3557.book 10 ページ ２００３年１２月１７日 水曜日 午後４時５４分 2. Plug one end of the supplied modular cord (short for a wall plate, long for direct wall mounting) into the TEL LINE jack on the base’s back. 3. Plug the supplied AC adapter's barrel plug into the DC IN 9V jack. 4. Route the adapter and modular cords through the bracket’s grooves. 5. For a wall plate, align the bracket’s keyhole slots with IMPORTANT ! ! the wall plate The EPA studs and slide the base downward to certifie
Resumo do conteúdo contido na página número 11
43-3557.book 11 ページ ２００３年１２月１７日 水曜日 午後４時５４分 1. Press down and slide off the battery IMPORTANT ! ! compartment cover. Be sure the battery pack is properly connected before 2. Lift the battery pack out of the you try to charge it. The compartment. CHARGE/IN USE indicator lights when the handset is 3. Plug the battery pack’s connector into on the base, even if the the socket in the compartment (the battery pack is not connector fits only one way). Then connected. place the battery
Resumo do conteúdo contido na página número 12
Installation 43-3557.book 12 ページ ２００３年１２月１７日 水曜日 午後４時５４分 The supplied battery pack should last about a year. If the battery pack does not hold a charge for more than two hours after an overnight charge, replace it with a new 3.6V, 600 mAh battery pack with a WARNING o o connector that fits the socket in the battery Dispose of the old battery compartment. You can order a replacement pack promptly and properly. battery pack through your local RadioShack Do not burn or bury it. st
Resumo do conteúdo contido na página número 13
43-3557.book 13 ページ ２００３年１２月１７日 水曜日 午後４時５４分 OPERATION MAKING AND RECEIVING CALLS Action Handset On Base Handset Off Base Pick up the handset Press TALK/ Ô NOTE Ô (Auto Talk: On) Ô FLASH, any To or pick up the number, /TONE/< Refer to page 17 “Setting answer handset and press or #/> keys (Auto Menu Options” to turn On a call TALK/FLASH (Auto Talk: On). the Auto Talk feature if Talk: Off). desired. 1)Pick up the 1)Press TALK/ handset. FLASH. 2)Press TALK/ 2)Listen for the dial FLASH. t
Resumo do conteúdo contido na página número 14
Operation 43-3557.book 14 ページ ２００３年１２月１７日 水曜日 午後４時５４分 ADJUSTING THE HANDSET RINGER AND EARPIECE VOLUME Handset Ringer Tone and Volume Press the volume up key or volume down key (labeled as, VOL or VOL keys) in standby mode to select one of five ringer tones and volume combinations. Ring Type A High, Ring Type A Low, Ring Type B High, Ring Type B Low, or Ringer Off. Earpiece Volume Press the volume up key or volume down key (labeled as, VOL or VOL keys) Ô NOTE Ô during a call to
Resumo do conteúdo contido na página número 15
43-3557.book 15 ページ ２００３年１２月１７日 水曜日 午後４時５４分 TONE DIALING SWITCH-OVER Some telephone companies use equipment that requires pulse dialing (sometimes referred to as rotary dialing). If you need to enter tone dialing digits, you can switch-over to tone dialing during the call. For example, entering your bank Ô NOTES Ô account number after you have called your The tone feature only bank. Ô applies when the dial mode is set to pulse. Initially make your call with the pulse dialing Th
Resumo do conteúdo contido na página número 16
Operation 43-3557.book 16 ページ ２００３年１２月１７日 水曜日 午後４時５４分 PAGE Ô NOTES Ô To locate the handset (while it’s off the Page base), press PAGE on the base. The You can cancel paging by handset beeps for 60 seconds. Paging is pressing the PAGE key on canceled when pressing any handset key or the base. the handset is returned to the base. Ô Flash and Call Waiting You must subscribe through your local telephone FLASH AND CALL WAITING company to receive Call If you have “Call Waiting” service an
Resumo do conteúdo contido na página número 17
43-3557.book 17 ページ ２００３年１２月１７日 水曜日 午後４時５４分 SETTING MENU OPTIONS There are five setup options available. They are Auto Talk, CIDCW (Caller ID on Call Waiting), Area Code, Dial Mode and Language. Auto Talk allows you to answer the phone without pressing the TALK/FLASH button. If the phone rings when Auto Talk is On, simply remove the handset from the base Ô NOTE Ô and the phone automatically answers the The Cordless phone call. If the phone rings when Auto Talk is features include
Resumo do conteúdo contido na página número 18
Operation 43-3557.book 18 ページ ２００３年１２月１７日 水曜日 午後４時５４分 1. When the phone is in the standby mode, press and hold CID. The Caller ID setting screen appears. VOL key twice to select ¨Area 2. Press Code¨. 3. Press SELECT. 4. Use the number keys (0 - 9), or CH/ DELETE to enter the three-digit area code. 5. Press SELECT. A confirmation tone sounds and the displayed area code is entered. 6. Press END or return the handset to the base unit to complete the setting. The handset returns to the s
Resumo do conteúdo contido na página número 19
43-3557.book 19 ページ ２００３年１２月１７日 水曜日 午後４時５４分 If you are not sure of your dialing system, set for tone dialing. Make a trial call. If the call connects, leave the setting as is, otherwise set for pulse dialing. If your phone system requires pulse dialing and you need to send the DTMF tones for certain situations during a call, you may “switch-over” to tone dialing. (Refer to “Tone Dialing Switch-over” on page 15.) Setting the Language 1. When the phone is in the standby mode, press
Resumo do conteúdo contido na página número 20
Memory Dialing 43-3557.book 20 ページ ２００３年１２月１７日 水曜日 午後４時５４分 3. Press MEM or SELECT. 4. Press MEM or SELECT. A cursor flashes indicating that the display is ready for the name to be entered. If “Edit Memory X X” appears, the selected memory location is already stored. Then you must either edit the entry in this location, delete the entry in this location, or select ¨Go Back¨ to choose another location. 5. To enter a name (up to 13 characters), use the number keys. See “Steps for Enteri
