Resumo do conteúdo contido na página número 1
Register your product and get support at
www.philips.com/welcome
CD560
CD565
EN User manual
Resumo do conteúdo contido na página número 2
Philips Consumer Lifestyle Glaslaan2 5616LW Eindhoven The Netherlands DECLARATION OF CONFORMITY We, Philips Consumer Lifestyle Glaslaan2 5616LW Eindhoven The Netherlands Declare that product models CD 560 & CD 565 (telecommunications terminal equipments) manufactured in China are in compliance with ANNEX IV of the R&TTE-Directive 1999/5/EC and then with the following essential requirements: Article 3.1 a: (protection of the health & the safety of the user) Safety: EN 60950-
Resumo do conteúdo contido na página número 3
7 Self-defined settings 17 Contents Personalize the phone display 17 Personalize the sounds 17 1 Important 4 Safety instructions 4 8 Call features 19 Philips Consumer Lifestyle Auto hang up 19 Glaslaan2 Auto conference 19 5616LW Eindhoven 2 Your CD560/CD565 6 Dial mode 19 The Netherlands What is in the box 6 Select the recall duration 19 Overview of the phone 7 Auto prefix 20 Display icons 8 First ring 20 ECO mode 20 3 Get started 9 DECLARATION OF CONFORMITY Connect the charger 9 9 Advanced
Resumo do conteúdo contido na página número 4
• Do not drop your phone or allow objects to 1 Important fall on your phone. • Do not use any cleaning agents containing alcohol, ammonia, benzene, or abrasives as these may harm the set. Safety instructions • Do not use the product in places where there are explosive hazards. Power requirements • Do not let small metal objects come into contact with the product. This can deteriorate • This product requires an electrical supply audio quality and damage the product. of 100-240 volts AC. In
Resumo do conteúdo contido na página número 5
Your product is designed and manufactured Use GAP standard compliance with high quality materials and components, which can be recycled and reused. The GAP standard guarantees that all DECT™ GAP handsets and base stations When you see the crossed-out wheel bin comply with a minimum operating standard symbol attached to a product, it means the irrespective of their make. The handset product is covered by the European Directive and base station are GAP compliant, which 2002/96/EC: means
Resumo do conteúdo contido na página número 6
2 Your CD560/ CD565 Guarantee Congratulations on your purchase and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips. com/welcome. User Manual What is in the box Quick start guide R Note • In some countries, you have to connect the line adaptor to the line cord, then plug the line cord to the line socket. Handset Charger Power supply 6 EN
Resumo do conteúdo contido na página número 7
Key Name Descriptions Overview of the phone 1 Earpiece 2 Right soft • Select the function key displayed on the a handset screen p directly above the key. 3 Call Log/Up • Scroll up on the key menu • Increase the earpiece/speaker volume b o • Enter the call log c n d 4 Phonebook/ • Scroll down on the R e Down key menu f m • Decrease the g earpiece/speaker volume • Enter the phonebook 5 End /On/Off • End the call l h key • Exit the menu/ k i operation j • Turn the handset on/off 6 S
Resumo do conteúdo contido na página número 8
Key Name Descriptions 12 Star/Keylock • Lock/unlock keypad key 13 Menu key • Access the main menu 14 Talk/Recall • Make and receive key calls • Send the flash signal 15 Left soft key • Select the function displayed on the handset screen directly above the key. 16 LED indicator 17 Loudspeaker 18 Battery door Display icons In standby mode, the icons shown on the main screen tell you what features are available on your handset. Icon Descriptions The battery is fully charged. The battery
Resumo do conteúdo contido na página número 9
Warning 3 Get started • Check the battery polarity when inserting in the battery compartment. Incorrect polarity may damage the product. Caution a The batteries are pre-installed in the • Ensure you have read the safety instructions in handset. Pull the battery tape off from the “Important” section before you connect the battery door before charging. and install your handset. Connect the charger 1 Connect the output plug of the power socket to the bottom of the charger. b Place the han
Resumo do conteúdo contido na página número 10
Set the date and time Check the signal strength 1 Press menu. • The signal icon displays the link status between the handset and base station. 2 Select [CLOCK & ALARM] > [SET A steady icon means your handset and DATE/TIME], then press [SELECT] to the base station are linked. A flashing confirm. icon means your handset and the base 3 Press the numeric buttons to enter the station are not linked. date, then press [OK] to confirm. • Ensure the handset is linked to the base » On the hands
Resumo do conteúdo contido na página número 11
Redial the most recent number 4 Calls 1 Press . 2 Press redial. 3 Press [SELECT]. Note » The most recent number is then dialed out. • When the power fails, the phone cannot access emergency services. Call from the redial list Tip You can make a call from the redial list. • Check the signal strength before you make a call or when you are in a call. For more Tip information, see “Check the signal strength” in the Get started section. • For more information, see “Redial a call” in the Redia
Resumo do conteúdo contido na página número 12
End a call Mute the microphone 1 Press during a call. You can end a call in these ways: » The handset displays [MUTE ON]. • Press ; or » The caller cannot hear you, but you • Place the handset to the base station can still hear his voice. or charging cradle if the auto hang up is activated. 2 Press again to unmute the microphone. » You can now communicate with the caller. Answer a call When the phone rings. Press or to answer Turn the speaker on or off the call. Press . Warning • When t
Resumo do conteúdo contido na página número 13
Toggle between two calls You can toggle your calls in these ways: 1 Press and ; or 2 Press [OK] and select [SWITCH CALLS], then press [OK] again to confirm. » The current call is put on hold, and you are now connected to the other call. Make a conference call Note • This service is network dependent. Check with the service provider for additional charges. When you are connected to two calls, press [OK], select [CONFERENCE] and then press [SELECT] again to confirm. » The two calls are com
Resumo do conteúdo contido na página número 14
Toggle between calls 5 Intercom and Press int to switch between the outside call conference calls and the intercom call. An intercom call is a call to another handset Transfer a call that shares the same base station. A conference call involves a conversation among you, another 1 Press int during a call. handset user and the outside callers. 2 Select or enter the handset number, then press [SELECT] to confirm. 3 Press when the other side answers Make a call to another handset your call.
Resumo do conteúdo contido na página número 15
Note • Press to join an ongoing conference with another handset if [ADVANCED SET] > [CONFERENCE] is set to [ON]. During the conference call 1 Press int to put the external call on hold and go back to the internal call. » The external call is put on hold. 2 Press int to toggle between the external and internal call. 3 Press and hold int to establish the conference call again. Note • If a handset hangs up during the conference call, the other handset remains connected to the external call.
Resumo do conteúdo contido na página número 16
Key Characters (Lower case) 6 Text and 0 . 0 , / : ; “ ‘ ! ¡ ? ¿ * + - % \ ^ ~ | numbers 1 [Sp] 1 @ _ # = < > ( ) & € £ $ ¥ [ ] { } ¤ § … 2 a b c 2 à â Æ á ã â ä å ą ç ć č You can enter text and numbers for handset 3 d e f 3 ď đ ė ĕ è é ê ë ę Δ Φ name, phonebook records, and other menu 4 g h i 4 ğ í ì î ï l Γ items. 5 j k l 5 Λ ł ĺ ľ 6 m n o 6 ñ ň ń ó ô õ ö ő 7 p q r s 7 ř ş š ś β Π Θ Σ Enter text and numbers 8 t u v 8 ţ ť ù ú û ü ů ű μ 9 w x y z 9 ý ž ź ż ƒ ø Ω Ξ Ψ 1 Press once or several
Resumo do conteúdo contido na página número 17
Personalize the sounds 7 Self-defined Set the handset’s ringtone settings You can select from 15 ringtones. 1 Press menu. Customize the settings to make it your own 2 Select [PERSONAL SET] > [HANDSET phone. TONES] > [RING TONES], then press [SELECT] to confirm. 3 Select a ringtone, then press [SELECT] Personalize the phone display to confirm. » The setting is saved. Name the handset Set the handset’s ringtone volume The name of the handset can be up to 14 characters. It is displayed on the
Resumo do conteúdo contido na página número 18
Enhance the audio quality XHD (Extreme High Definition) sound mode is an exclusive feature which transmits high fidelity signals to the handset. It makes the phone conversations sound like real-life conversations. When you are in standby mode, 1 Press menu. 2 Select [ADVANCED SET] > [XHD SOUND], then press [SELECT] to confirm. 3 Select the new setting, then press [SELECT] to confirm. » The setting is saved. When you are in a call, 1 Press [OPTION] to enter the options menu. 2 Change the
Resumo do conteúdo contido na página número 19
8 Call features Dial mode Note The phone supports a number of call-related features that help you handle and manage the calls. • This feature only applies to models that support both tone and pulse dial. Dial mode is the telephone signal used in your Auto hang up country. The phone supports tone (DTMF) and pulse (rotary) dial. Consult the service provider for detailed information. To end a call, simply place the headset on the base station or charge cradle. Set the dial mode Activate/Deact
Resumo do conteúdo contido na página número 20
Auto pr efix First ring This feature checks and formats your outgoing If you have subscribed for caller ID service with call number before it is dialed out. The prefix your service provider, your phone can suppress number can replace the detect number you the first ring before the caller ID displays on set in the menu. For example, you set 604 as the screen. After the phone is reset, it can the detect number and 1250 as the prefix. detect automatically if the caller ID service When you have
