Streszczenie treści zawartej na stronie nr. 1
ª
R
37 Xtra 37 Xtra
R
Multimedia Monitor
User's Manual
1
R
Xtra
37 37 Xtra
NEC Technologies, Inc.
MultiSync is a registered trademark of NEC Technologies, Inc. in the U.S.A.
1250 N. Arlington Heights Road, Suite 500
NEC is registered trademark of NEC Corporation.
Printed in Japan
1993 by NEC Technologies, Inc.
Itasca, Illinois 60143-1248
79TH1624
Streszczenie treści zawartej na stronie nr. 2
DOC compliance Notice CAUTION This Class B digital apparatus meets all requirements of the Canadian RISK OF ELECTRIC SHOCK Interference-Causing Equipment Regulations. DO NOT OPEN WARNING CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO This equipment has been tested and found to comply with the limits for a NOT REMOVE COVER. NO USER-SERVICEABLE Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are PARTS INSIDE. REFER SERVICING TO QUALIFIED designed to provide reason
Streszczenie treści zawartej na stronie nr. 3
DOC avis de conformation ATTENTION Cet appareil numérigue de la classe B respecte toutes les exigences du RISQUE D’ELECTROCUTION Réglement sur le Matériel Brouilleur du Canada. NE PAS OUVRIR Mises en garde et précautions de sécurité MISE EN GARDE: AFIN DE REDUIRE LES RISQUES D’ELECTRO- Les moniteurs MultiSync Multimédia XP37 Xtra et XM37 Xtra de NEC ont été CUTION, NE PAS DEPOSER LE COUVERCLE, IL conçus et fabriqués pour assurer une longue durée de service sans N’Y A AUCUNE PIECE UTILISABLE A L
Streszczenie treści zawartej na stronie nr. 4
the product. LIMITED WARRANTY • Repair or attempted repair by anyone not authorized by NECTECH. NEC Multimedia Monitor Products • Any shipment of the product (claims must be presented to the carrier). NEC Technologies, Inc.(hereafter NECTECH)warrants this product to be free from • Removal or installation of the product. defects in material and workmanship under the following terms. • Any other cause which does not relate to a product defect. HOW LONG IS THE WARRANTY • Burns or residual images up
Streszczenie treści zawartej na stronie nr. 5
CONTENTS 1. Introduction Introduction to the MultiSync XP37 Xtra/XM37 Xtra .............................................................. 1 Feature Highlights ...................................................................................................................... 1 2. Part Names and Functions Front View / Rear View ............................................................................................................. 3 Terminal Board ..........................................
Streszczenie treści zawartej na stronie nr. 6
1 OSM and IPM are trademarks of NEC Technologies, Inc. • Flexible inputs IBM PC/AT, PS/2, VGA, S-VGA, 8514/A and XGA are registered Connect up to four different inputs at once and switch among them trademarks of International Business Machines Corporation. with a touch of a button to seamlessly integrate information from a Apple and Macintosh are registered trademarks of Apple Computer, computer and VCR into one presentation. Inc. • Signal loop-through Microsoft is a registered trademark of Micr
Streszczenie treści zawartej na stronie nr. 7
3 Part Names and Functions Front View Rear View POWER PROCEED VIDEO 1 VIDEO 2 RGB 1 RGB 2/DTV DEGAUSS OFF ON VIDEO 1 VIDEO 2 RGB 1 RGB 2 POSITION/CONTROL PROCEED EXIT EXIT SCAN POWER WIDTH HEIGHT SIDE PIN NORMAL NORMAL BRIGHT CONTRAST MUTE VOLUME /STANDBY MULTIMEDIA MONITOR RD-346E 79644641 9 8 6 543 21 7 VIDEO 1 VIDEO 2 RGB AUDIO RGB 1 SPEAKER SELECT REMOTE EXTERNAL CONTROL IN INT EXT EXT SPEAKER IN BNC S BNC S R L () MONO RIGHT LEFT IN IN IN SPEAKRES MUST THROUGH HAVE MORE THAN OUT OUT THR
Streszczenie treści zawartej na stronie nr. 8
5 Terminal Board C BA VIDEO 1 VIDEO 2 RGB AUDIO RGB 1 SPEAKER SELECT REMOTE PC/EXT CTL INT EXT IN IN EXT SPEAKER () R L MONO BNC S BNC S RIGHT LEFT IN IN IN SPEAKRES MUST THROUGH OUT HAVE MORE THAN OUT 5WATT RATING THROUGH INPEDANCE 8 OHM THROUGH THROUGH OUT OUT HIGH 75Ω OUT DIP SW ON RGB 2 R/CR/PR G/Y/Y B/CB/PB H/CS V 12345678 HIGH 75Ω HIGH 75Ω IN AC IN AUDIO AUDIO R L () MONO R L () MONO IN IN THROUGH OUT THROUGH THROUGH OUT OUT HIGH 75Ω HIGH 75Ω D E A PC/ECT CTL IN (D-Sub 15-pin) NOTE: Up to
Streszczenie treści zawartej na stronie nr. 9
7 Terminal Board H F G VIDEO 1 VIDEO 2 RGB AUDIO RGB 1 SPEAKER SELECT REMOTE PC/EXT CTL INT EXT IN IN EXT SPEAKER R () L MONO BNC S BNC S RIGHT LEFT IN IN IN SPEAKRES MUST THROUGH OUT HAVE MORE THAN OUT 5WATT RATING THROUGH THROUGH INPEDANCE 8 OHM THROUGH OUT OUT HIGH 75Ω OUT DIP SW ON RGB 2 R/CR/PR G/Y/Y B/CB/PB H/CS V 12345678 HIGH 75Ω HIGH 75Ω IN AC IN AUDIO AUDIO () L () MONO R L MONO R IN IN THROUGH OUT THROUGH THROUGH OUT OUT HIGH 75Ω HIGH 75Ω F RGB 1 (Mini D-SUB 15 pin) H VIDEO 2 RGB Inpu
Streszczenie treści zawartej na stronie nr. 10
9 Terminal Board I VIDEO 1 VIDEO 2 RGB AUDIO RGB 1 SPEAKER SELECT REMOTE PC/EXT CTL INT EXT IN IN EXT SPEAKER R L () MONO BNC S BNC S RIGHT LEFT IN IN IN SPEAKRES MUST THROUGH OUT HAVE MORE THAN OUT 5WATT RATING THROUGH THROUGH INPEDANCE 8 OHM OUT THROUGH OUT HIGH 75Ω OUT DIP SW ON RGB 2 R/CR/PR G/Y/Y B/CB/PB H/CS V 12345678 HIGH 75Ω HIGH 75Ω IN AC IN AUDIO AUDIO R L () MONO R L () MONO IN IN THROUGH OUT THROUGH THROUGH OUT OUT HIGH 75Ω HIGH 75Ω J I VIDEO 1 J RGB 2 VIDEO 1 IN (BNC type).....Conn
Streszczenie treści zawartej na stronie nr. 11
11 Remote Control Unit NOTE: When not in use the remote control unit is conveniently stowed in the holder on the rear panel. 1 POWER ON/OFF Press POWER ON to turn the monitor on when the POWER/STANDBY indicator is lit amber. Press POWER OFF to turn the monitor off and the monitor will go into the standby condition. POWER DEGAUSS OFF ON 2 DEGAUSS 1 2 Press to demagnetize the picture tube in the manual operation. See also VIDEO 1 VIDEO 2 RGB 1 RGB 2 page 27. 3 POSITION/CONTROL PROCEED 3 Input Sel
Streszczenie treści zawartej na stronie nr. 12
13 Raster Control 7 WIDTH (+ / -) Adjusts the horizontal size of the image. 8 HEIGHT (+ / -) Adjusts the vertical size of the image. 9 SIDE PIN (+ / -) POWER Adjusts the curvature of the edges of the left and right side of the display DEGAUSS OFF ON image either inward or outward. The image should be adjusted to attain a VIDEO 1 VIDEO 2 RGB 1 RGB 2 straight line on the left and right sides. 0 SCAN SELECT POSITION/CONTROL PROCEED Each time this key is pressed, the picture size switches from OVER
Streszczenie treści zawartej na stronie nr. 13
15 Battery Installation and Replacement The remote control is powered by two 1.5V AA batteries. 1. Turn the remote control unit upside 2. Install the two new batteries, making 3. Close the battery compartment cover. down. Press down on the battery sure that their polarity matches the (+) compartment grip and slide the (-) diagrams inside the battery compartment in the direction of the compartment. Incorrect polarity could arrow. damage the remote control unit. Remote Control Cautions • Do not dr
Streszczenie treści zawartej na stronie nr. 14
17 Functions of DIP SW ON ON 12 3 4 5 6 7 8 OFF Functions and Settings of DIP SW This DIP switch is used for Sync. Control, Intelligent Power Manager, External control, wireless control, and OSM control. To change a switch setting use a pointed object, such as a pen or pencil, to push the switch to the desired position. Set all the pins except No.7 to the OFF position during normal operation. The pins nos 2,3 and 5 are not used. Pin No 1 (Sync. Control ) The No. 1 pins set Sync. Control. Set the
Streszczenie treści zawartej na stronie nr. 15
19 Installation Macintosh or Wiring Diagram Compatibles IBM XGA/SuperVGA/VGA or Compatibles or Macintosh G3 series EXTERNAL CONTROL RGB cable (Supplied) To EXTERNAL CONTROL Pin adapter for Macintosh (Mini D-SUB 15 Pin input) To Mini D-SUB 15 Pin input (supplied) RGB cable (Supplied) To Mini D-SUB 15 Pin input XP37 Xtra/XM37 Xtra VIDEO 1 VIDEO 2 RGB AUDIO RGB 1 SPEAKER SELECT REMOTE PC/EXT CTL INT EXT IN IN EXT SPEAKER R () MONO L BNC S BNC S RIGHT LEFT IN IN IN SPEAKERS MUST THROUGH OUT HAVE
Streszczenie treści zawartej na stronie nr. 16
21 NOTE: The new Macintosh computer such as G3 will have the 15-pin HD Connecting Your PC or Macintosh Computer connector. Connecting your PC or Macintosh computer to your MultiSync XP37 Xtra/ The XP37 Xtra/XM37 Xtra’s “Plug and Play” data will be downloaded to XM37 Xtra will enable you to display your computer's screen image. All of the Macintosh. these following display standards are supported: Therefore, the pin adapter will not be necessary. VGA 640 x 480 for graphics, VGA 640 x 400 for grap
Streszczenie treści zawartej na stronie nr. 17
23 3. Connect the external component stereo right channel audio input to R AU- Daisy-chaining Your monitors DIO. The REMOTE IN/OUT terminals allow you to control monitors by one remote 4. Set the 75W /HIGH impedance select switch of the corresponding input signal control. (BNC, S-VIDEO) on all but the last monitor to “HIGH” position. Only the last NOTE: The connection of three XP37 Xtra/XM37 Xtra monitors or more with monitor is set to the “75W ” position. THROUGH OUT (VIDEO 1 or 2) terminals m
Streszczenie treści zawartej na stronie nr. 18
25 External Speaker Connections If non-shielded speakers are used, they must be located a minimum of 4 feet away from the monitor. External speakers may be connected to the monitor to reproduce sound from VIDEO 1, VIDEO 2, RGB 1 or RGB 2 signal sources. SPEAKER SELECT INT EXT External speakers may be connected directly to the EXTERNAL SPEAKERS POWER DEGAUSS VIDEO 1 VIDEO 2 RGB 1 OFF RGB 2 ON POSITION/CONTROL PROCEED EXIT SCAN WIDTH HEIGHT SIDE PIN NORMAL NORMAL terminals or indirectly by con
Streszczenie treści zawartej na stronie nr. 19
27 NOTE 2: Select the over scan mode for VIDEO display. Operation 3. Adjust The Raster or The Picture Control. You can adjust the raster such as the horizontal size, vertical size or side Power pincushion correction, and the brightness and contrast of the image with the This section describes how to select a computer or video source and how to remote control. adjust the picture and sound. 4. Turning Off The monitor. General Controls Press the POWER OFF button on the remote control or press the P
Streszczenie treści zawartej na stronie nr. 20
29 c. HEIGHT Direct Control Screen Press to adjust the vertical size of the image. You can adjust the raster, visual and sound using the direct key on the remote control. To switch to another control screen, press any one of the other keys. d. SIDE PIN *To end the OSM display, press EXIT. Press to adjust the curvature of the edges of the left and right side of the *If no key operation is made within 3 seconds, the OSM display will disappear. display image either inward or outward. The image shou
