Instrukcja obsługi AOC CT500G

Streszczenie treści zawartej na stronie nr. 1

CT500G
User’s
Manual
2 J

Streszczenie treści zawartej na stronie nr. 2

Thank you very much for choosing the AOC Color Monitor. FCC Class B Radio Frequency Interference Statement PRECAUTIONS WARNING: (FOR FCC CERTIFIED MODELS)  Do not use the monitor near water, e.g. near a bathtub, We recommend that you take a few minutes to read carefully NOTE: This equipment has been tested and found to comply washbowl, kitchen sink, laundry tub, swimming pool or in a through this brief but comprehensive manual before installing with the limits for a Class B digital device,

Streszczenie treści zawartej na stronie nr. 3

Plug & Play DDC1/2B Feature TECHNICAL SUPPORT(FAQ) This monitor is equipped with VESA DDC1/2B capabilities Power LED is not on according to the VESA DDC STANDARD. It allows the *Check if the Power Switch is in the ON position monitor to inform the host system of its identity and, *Power Cord should be connected depending on the level of DDC used, communicate additional No Plug & Play information about its display capabilities. The communication channel is defined in two levels, DDC1 and DDC

Streszczenie treści zawartej na stronie nr. 4

Figure 1 Installing and Removing the Swivel Base Figure 3 External Control Knob Figure 4 The OSD Message 536 800 X 600 Figure 2 Connecting Cables EXTERNAL CONTROLS Switch: 1. Power On/Off Switch 2. LED 3. Menu 4 Contrast 5 Brightness. 6 Exit 1. AC Inlet 5 J

Streszczenie treści zawartej na stronie nr. 5

INSTALLATION INSTRUCTIONS OPERATING INSTRUCTIONS SWIVEL BASE GENERAL INSTRUCTIONS To attach the swivel base to the monitor, do the The power switch is located at front panel of the monitor. following: Press the power switch to turn the monitor on or off. The  Carefully turn the monitor on its side or upside down. (see other control knobs are located at the base of the monitor figure 1) (See Figure 3). By changing these settings, the picture can  Locate the cavities at the bottom front o

Streszczenie treści zawartej na stronie nr. 6

ADJUSTING THE PICTURE (See Figure 3) 1. CONTRAST Adjust the picture contrast. Press RECALL to restore the monitor 17. RECALL to factory settings. 2. BRIGHTNESS Adjust the picture brightness. 3. H- CENTER Adjust the horizontal position of the picture. 18. EXIT Close OSD window. H- SIZE Adjust the picture’s horizontal size. SELECT 4. 19. Select the language as you like. LANGUAGE V- CENTER Adjust the vertical position of t

Streszczenie treści zawartej na stronie nr. 7

Factory Preset Timing Table SPECIFICATION HORIZONTAL STANDARD RESOLUTION VERTICAL FREQUENCY CRT 38.1cm(15"), 90º deflection, 29mm neck, FREQUENCY 0.24mm(H), 0.28mm(D) dot pitch Viewable Image Size 35.1cm (13.8"), diagonal 720 x 400 31.47kHz 70Hz IBM Video 0.7Vpp, R, G, B Analog VGA 640 x 480 31.47kHz 60Hz Separate Sync. TTL Level H/V-sync.: Positive/Negative VESA/85 640 x 480 43.3kHz 85Hz Scanning Frequency: VESA/85 800 x 600 53.67kHz 85Hz Horizontal 30kHz to 56kHz automatically VESA/