Streszczenie treści zawartej na stronie nr. 1
SyncMaster 173T/193T/170N/171N/172N/173N/174T
191N/192N/193N/191T plus/153T/150N/151N/152N
Streszczenie treści zawartej na stronie nr. 2
Main Page On-Screen Display Safety Instructions Troubleshooting Notational Check List Power Q & A Installation Self-Test Feature Check Cleaning Other Introduction Specifications Unpacking General Specifications Front PowerSaver Rear Preset Display Modes Setup Information Connecting Your Monitor Service Installing the Monitor Driver Terms Automatic Regulatory Manual Natural Color Installing VESA compliant mounting For Better Display Authority
Streszczenie treści zawartej na stronie nr. 3
Notational Power Installation Clean Other Failure to follow directions noted by this symbol could result in bodily harm or damage to equipment. Prohibited Important to read and understand at all times Do not disassemble Disconnect the plug from the outlet Do not touch Grounding to prevent an electric shock
Streszczenie treści zawartej na stronie nr. 4
When not used for extended periods of time, set your PC to DPMS. If using a screen saver, set it to the active screen mode. Notational Power Do not use a damaged or loose plug. Installation Clean This may cause an electric shock or fire. Other Do not pull the plug out by the wire nor touch the plug with wet hands. This may cause an electric shock or fire. Use only a properly grounded plug and reoeptacle. An improper ground may cause electric shock or equipment damage. Do not
Streszczenie treści zawartej na stronie nr. 5
Do not cover the vents on the monitor cabinet. Bad ventilation may cause a breakdown or fire. Notational Power Installation Clean Put your monitor in a location with low humidity and a minimum of Other dust. An electric shock or fire could result inside the monitor. Do not drop the monitor when moving it. This may cause damage to the product or human body. Place the monitor on a flat and stable surface. The monitor can cause injury by falling. Set down the monitor carefully. I
Streszczenie treści zawartej na stronie nr. 6
When cleaning the monitor case or the surface of the TFT-LCD, wipe with a slightly moistened, soft fabric. Notational Power Do not spray detergent directly on the monitor. Installation Clean Other Use the recommended detergent with a smooth cloth. If the connector between the plug and the pin is dusty or dirty, clean it properly with a dry cloth. A dirty connector can cause an electric shock or fire. Do not set a glass of water, chemicals or any small metal objects on the monitor.
Streszczenie treści zawartej na stronie nr. 7
Do not remove cover(or back). No user serviceable parts inside. This may cause an electric shock or a fire. Refer servicing to qualified service personnel. Notational Power Installation Clean If your monitor does not operate normally - in particular, if there Other are any unusual sounds or smells coming from it - unplug it immediately and contact an authorized dealer or service. This may cause an electric shock or a fire. Do not place any heavy objects on the monitor. This may
Streszczenie treści zawartej na stronie nr. 8
Possible fire hazard. Keep power adaptor away from any other heat source. Possible fire hazard. Remove and discard vinyl bag from power adaptor before use. Possible fire hazard. Always keep power adaptor in well-ventilated area. If you view a fixed screen for an extended period of time, residual image or blurriness may appear. Change the mode to energy save or set a screensaver to moving picture when you need to be away from the monitor for an extended period of time.
Streszczenie treści zawartej na stronie nr. 9
SyncMaster 173T/193T/191T plus/153T/174T Monitor andt Stand Power Cord Unpacking Front Signal Cable Rear DVI Cable(Option) Please make sure the following items are included with your monitor. If any items are missing, contact your dealer. Quick Setup Guide Warranty Card (Not available in all locations) User's Guide and Driver Installation CD Pivot S/W CD(Option) For Multimedia model (Option) Multimedia Speaker Stand Sound Cable
Streszczenie treści zawartej na stronie nr. 10
SyncMaster 170N/171N/172N/173N/191N/192N/193N/150N/151N/152N Monitor and Stand Power Cord Unpacking Front Signal Cable Rear Quick Setup Guide Please make sure the following items are included with your monitor. If any items are missing, contact your dealer. Warranty Card (Not available in all locations) User's Guide and Driver Installation CD Pivot S/W CD(Option) For Multimedia model (Option) Multimedia Speaker Stand Sound Cable
Streszczenie treści zawartej na stronie nr. 11
SyncMaster 173T/193T/191T plus/153T/174T Unpacking Front Rear 1. Auto button Use this button to auto adjustment direct access. Use this button to Exit the active menu or the OSD. 2. Exit button When push the 'Source' button, then Selects the Video signal while the OSD is Source button off. (When the Source button is pressed to change the input mode, a message appears in the center of the screen displaying the current mode -- analog or digital input signal.) Note:If you select the D
Streszczenie treści zawartej na stronie nr. 12
SyncMaster 170N/171N/172N/173N/191N/192N/193N/150N/151N/152N Unpacking Front Rear 1. Auto button Use this button to auto adjustment direct access. Use this button to Exit the active menu or the OSD. 2. Exit button 3. MagicBright button MagicBright is a new feature providing optimum viewing environment depending on the contents of the image you are watching. Currently three different modes are available: Text, Internet, and Entertain. Each mode has its own pre- configured brightness value.
Streszczenie treści zawartej na stronie nr. 13
SyncMaster 173T/193T/191T plus/153T/174T Unpacking Front Rear (The configuration at the back of the monitor may vary from product to product.) 1. Power port Connect the power cord for your monitor to the power port on the back of the monitor. 2. AudioPower - Out (Option) 3. DVI port Connect the DVI Cable to the DVI Port on the back of your Monitor. Connect the signal cable to the 15-pin, D-sub connector on the back of 4. Signal port your monitor. 5. Pin Press the button on the bottom
Streszczenie treści zawartej na stronie nr. 14
SyncMaster 170N/171N/172N/173N/191N/192N/193N/150N/151N/152N Unpacking Front Rear (The configuration at the back of the monitor may vary from product to product.) 1. Power port Connect the DC Adapter for your monitor to the power port on the back of the monitor. 2. AudioPower - Out (Option) 3. Signal port Connect the signal cable to the 15-pin, D-sub connector on the back of your monitor. Press the button on the bottom rear of the stand in order to lock down 4. Pin the stand. N
Streszczenie treści zawartej na stronie nr. 15
SyncMaster 173T/193T/191T plus/153T/174T Setup-General Connecting Your Monitor Installing the Monitor Driver Installing VESA compliant mounting Connect the power cord for your monitor to the power port on the back of the monitor. Plug the 1. power cord for the monitor into a nearby outlet. 2-1. Using the D-sub (Analogue) connector on the video card. Connect the signal cable to the 15-pin, D-sub connector on the back of your monitor. Using the DVI (Digital) connector on the video card.
Streszczenie treści zawartej na stronie nr. 16
Setup-For Multimedia model (Option) 1. Connect the power cord of the multimedia stand to the multimedia stand power port on the back of the monitor. 2. Connect a sound cable from the input source (sound card,computer,CD-ROM drive). 3. To listen in privacy,connect headphones here. Multimedia Speaker Stand 1. Speaker Power Cord 2. On/Off Volume 3. Bass Control 4. Treble Control 5. Stereo Input Jack 6. Headphone Jack
Streszczenie treści zawartej na stronie nr. 17
SyncMaster 170N/171N/172N/173N/191N/192N/193N/150N/151N/152N Setup-General Connecting Your Monitor Installing the Monitor Driver Installing VESA compliant mounting 1. Connect the power cord for your monitor to the power port on the back of the monitor. Plug the power cord for the monitor into a nearby outlet. 2. Connect the signal cable to the 15-pin, D-sub connector on the back of your monitor. 3. Connect the monitor to the Macintosh computer using the D-SUB connection cable. 4. I
Streszczenie treści zawartej na stronie nr. 18
Multimedia Speaker Stand 1. Speaker Power Cord 2. On/Off Volume 3. Bass Control 4. Treble Control 5. Stereo Input Jack 6. Headphone Jack
Streszczenie treści zawartej na stronie nr. 19
Connecting Your When prompted by the operating system for the monitor driver, insert the CD-ROM Monitor included with this monitor. Driver installation is slightly different from one operating Installing the system to another. Follow the directions as appropriate for the operating system you Monitor Driver have. Installing VESA compliant mounting Prepare a blank disk and download the driver program file at the Internet web site shown here. Internet web site : http://www.samsung-
Streszczenie treści zawartej na stronie nr. 20
4. Click the "Install" button in the "Warning" window. 5. If you can see following "Message" window, then click the "Continue Anyway" button. Then click "OK" button. This monitor driver is under certifying MS logo,and this installation don't damage your system.The certified driver will be posted on Samsung Monitor Homepage http://www.samsung-monitor.com/. 6. Monitor driver installation is completed.
