Streszczenie treści zawartej na stronie nr. 1
©
MultiSync XV29 Plus
©
MultiSync
Multimedia Monitor
User's Manual
NEC Technologies
©
MultiSync XV29 Plus
NEC Technologies, Inc.
1250 N. Arlington Heights Road, Suite 500
Itasca, Illinois 60143-1248
MultiSync is a registered trademark of NEC Technologies, Inc. in the U.S.A.
Printed in Thailand
NEC is registered trademark of NEC Corporation.
78408751
1993 by NEC Technologies, Inc.
Streszczenie treści zawartej na stronie nr. 2
DOC compliance Notice CAUTION This Class A digital apparatus meets all requirements of the Canadian RISK OF ELECTRIC SHOCK Interference-Causing Equipment Regulations. DO NOT OPEN WARNING CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO This equipment has been tested and found to comply with the limits for NOT REMOVE COVER. NO USER-SERVICEABLE a Class A digital device, pursuant to Part 15 of the FCC Rules. These PARTS INSIDE. REFER SERVICING TO QUALIFIED limits are designed to provide reason
Streszczenie treści zawartej na stronie nr. 3
DOC avis de conformation ATTENTION Cet appareil numérigue de la classe A respecte toutes les exigences du RISQUE D’ELECTROCUTION Réglement sur le Matériel Brouilleur du Canada. NE PAS OUVRIR MISE EN GARDE: AFIN DE REDUIRE LES RISQUES D’ELECTRO- CUTION, NE PAS DEPOSER LE COUVERCLE, IL N’Y A AUCUNE PIECE UTILISABLE A L’INTERIEUR DE CET APPAREIL. NE CONFIER LES TRAVAUX D’ENTRETIEN QU’A UN PERSONNEL QUALIFIE. Ce symbole a pour but de prévenir l’utilisateur de la présence d’une tension dangereuse, n
Streszczenie treści zawartej na stronie nr. 4
unauthorized product modification, or failure to follow instructions supplied with LIMITED WARRANTY the product. NEC Multimedia Monitor Products • Repair or attempted repair by anyone not authorized by NECTECH. NEC Technologies, Inc.(hereafter NECTECH)warrants this product to be free from • Any shipment of the product (claims must be presented to the carrier). defects in material and workmanship under the following terms. • Removal or installation of the product. HOW LONG IS THE WARRANTY • Any o
Streszczenie treści zawartej na stronie nr. 5
CONTENTS 1. Introduction Introduction to the MultiSync XV29 Plus ................................................................................. 1 Feature Highlights ...................................................................................................................... 1 2. Part Names and Functions Front View / Rear View ............................................................................................................. 3 Terminal Board .................................
Streszczenie treści zawartej na stronie nr. 6
1 OSM and IPM are trademarks of NEC Technologies, Inc. exactly how to adjust your screen image. IBM PC/AT, PS/2, VGA, S-VGA, 8514/A and XGA are registered • Flexible inputs trademarks of International Business Machines Corporation. Connect up to four different inputs at once and switch among them Apple and Macintosh are registered trademarks of Apple Computer, with a touch of a button to seamlessly integrate information from a Inc. computer and VCR into one presentation. Microsoft is a registere
Streszczenie treści zawartej na stronie nr. 7
ON 1 2 3 4 56 3 Part Names and Functions 11 Front View Rear View 10 9 8 7 6 5 4 3 2 1 S POWER POWER
VOLUME SOURCE SELECT /STANDBY RGB2 VIDEO2 L (MONO) R
PROCEED EXIT AUDIO AC-IN VIDEO1 L AUDIO1
R (MONO) IN RGB
L R (MONO) AUDIO IN RGB 1 MONITOR
R L S OUT DIP SW POWER POWER
VOLUME SOURCE SELECT /STANDBY RGB2 VIDEO2 L (MONO) R
AUDIO PROCEED EXIT Terminal Board 1 POWER 7 EXIT Press to turn the main power on and off when the AC power is supplied. Press to exit the OSM mode. The OSM screen di
Streszczenie treści zawartej na stronie nr. 8
ON 1 2 3 4 56 5 Terminal Board 12 13 AC-IN VIDEO1 L AUDIO1
R (MONO) IN
L RGB
R ( ) MONO AUDIO IN RGB 1 MONITOR
R L OUT DIP SW 14 16 15 17 12 AC Input 15 MONITOR OUT (R/L) Connect the supplied power cord' s three-pin plug here. Connect additional external speakers here to listen to audio coming from your computer, Video or S-Video audio inputs (R/L). 13 VIDEO 1 16 DIP SWITCH VIDEO 1 IN (RCA type) ........ Connect a VCR or laser disk player here to display the video. This switch sets Sync. Co
Streszczenie treści zawartej na stronie nr. 9
7 NOTE: When not in use the remote control unit is conveniently stowed in the Remote Control Unit holder on the rear panel. 1 POWER ON/OFF Press POWER ON to turn the monitor on when the POWER/STANDBY indicator is lit red. Press POWER OFF to turn the monitor off and the monitor will go into the standby condition. 2 DEGAUSS Press to demagnetize the picture tube in the manual operation. See also page 21. POWER 3 Input Select DEGAUSS OFF ON 1 2 VIDEO 1 ........ Press to select an NTSC, PAL, SECAM
Streszczenie treści zawartej na stronie nr. 10
9 Raster Control 7 WIDTH (+ / –) Adjusts the horizontal size of the image. 8 HEIGHT (+ / –) Adjusts the vertical size of the image. 9 SIDE PIN (+ / –) Adjusts the curvature of the edges of the left and right side of the display image either inward or outward. The image should be adjusted to attain a straight line on the left and right sides. POWER DEGAUSS OFF ON 10 SCAN SELECT Each time this key is pressed, the picture size switches from OVER SCAN VIDEO 1 VIDEO 2 RGB 1 RGB 2 for large size to UN
Streszczenie treści zawartej na stronie nr. 11
11 Battery Installation and Replacement The remote control is powered by two 1.5V AA batteries. 1. Turn the remote control unit upside down. 2. Install the two new batteries, making sure 3. Close the battery compartment cover. Press down on the battery compartment that their polarity matches the (+) (–) grip and slide the compartment in the diagrams inside the battery compartment. direction of the arrow. Incorrect polarity could damage the remote control unit. Remote Control Cautions • Do not dr
Streszczenie treści zawartej na stronie nr. 12
ON 1 2 3 4 56 13 Set the No. 1 pin to the ON/SHORT position when sync on green signals are Functions of DIP SW necessary for synchronization with an external component. The drawing below shows the original factory settings of DIP Switch. When a composite signal is present, the picture may be distorted. If this happens, set the No.2 pin to the OFF/OPEN position. Pin No. 2 (Remote ON/OFF) OFF ON When this switch is set to ON/SHORT, the monitor can be controlled by the wireless remote control. Func
Streszczenie treści zawartej na stronie nr. 13
ON 1 2 3 4 56 15 Installation Wiring Diagram S POWER POWER
VOLUME SOURCE SELECT /STANDBY RGB2 VIDEO2 L (MONO) R
PROCEED EXIT AUDIO S RGB2 VIDEO2 L (MONO) R
AUDIO VCR or Laserdisc player To VIDEO IN R, L, inputs Signal cable (supplied) to D-Sub Mini 15-pin input IBM XGA/SuperVGA/VGA or Compatibles AC Outlet 120V/220–240V VCR, Laser disc player or AC-IN Document camera, Video copy stand or Multimedia VIDEO1 application L AUDIO1
R ( ) MONO IN
RGB
L R (MONO) AUDIO IN RGB 1 MONITOR
R L OUT DI
Streszczenie treści zawartej na stronie nr. 14
17 3. Use the supplied RGB cable to connect your computer to the monitor. For Connecting Your PC or Macintosh Computer Macintosh, use a commercially avalable adapter between the D-Sub mini Connecting your PC or Macintosh computer to your MultiSync XV29 Plus 15-pin connector of the supplied RGB cable and the D-Sub 15-pin will enable you to display your computer's screen image. All of these connector of your Macintosh. following display standards are supported: 4. Turn on the monitor and the compu
Streszczenie treści zawartej na stronie nr. 15
19 D-Sub 15 Pin RGB Signal Composition Pin Assignments and Signal Levels for 15 pin RGB 5 4 3 2 1 10 9 8 7 6 15 14 13 12 11 D-SUB 15pin RGB Input Connector Pin No. Signal to be connected (D-SUB 15 pin) RED 1 GREEN or Sync Green 2 BLUE 3 No Connection 12 H. or Composite sync 13 V.SYNC 14 No Connection 15 GND 4 GND 5 GND 6 GND 7 GND 8 GND 11 No Connection 10 No Connection 9 20
Streszczenie treści zawartej na stronie nr. 16
21 select your video source: “VIDEO 1”, “VIDEO 2”, “RGB 1”, or “RGB Operation 2”. NOTE 1: In the U.S.A. the standard video signal format is NTSC, therefore make Power sure that the AUTO or NTSC is selected on OSM system control menu. See page This section describes how to select a computer or video source and how to 40. adjust the picture and sound. General Controls NOTE 2: Select the over scan mode for VIDEO display. Before you turn on your MultiSync XV29 Plus monitor ensure that the 3. Adjust
Streszczenie treści zawartej na stronie nr. 17
23 c. HEIGHT Direct Control Screen Press to adjust the vertical size of the image. You can adjust the raster, visual and sound using the direct key on the remote control. To switch to another control screen, press any one of the other keys. * To end the OSM display, press EXIT. d. SIDE PIN * If no key operation is made within 3 seconds, the OSM display will Press to adjust the curvature of the edges of the left and right side of the disappear. display image either inward or outward. The image sh
Streszczenie treści zawartej na stronie nr. 18
25 i. NORMAL( visual) j. MUTE Press to reset all the stored adjustment visual data and recall the factory Press to turn off the sound for a short period of time; press again to restore preset data. When a specific control is selected, this key resets the the sound. selected visual adjustments. k. VOLUME Press s to increase the sound: press t to decrease the sound. NOTE: When pressing a key that does not correspond to the function currently in use, the following message will be displayed on the m
Streszczenie treści zawartej na stronie nr. 19
27 V-position/V-height/V-linearity Controls Group H-position/H-width/Pin-cushion Controls Group The V-position/V-height/V-linearity Controls allow you to adjust the vertical The H-position/H-width/Pin-cushion Controls allow you to adjust the horizontal position, vertical size and vertical linearity of the image. position, horizontal size and pin-cushion of the image. V-POSITION : Pressing + or - moves the image vertically up or down. H-POSITION : Pressing + or - moves the image horizontally righ
Streszczenie treści zawartej na stronie nr. 20
29 RGB Controls Group OSM Location/OSM Turn Off Time Control The RGB Controls allow you to adjust the white balance for RGB input. You can choose where you would like OSM image to appear on your screen. Selecting OSM location allows you to manually adjust the OSM menu left, right, up, or down. The OSM menu will stay on as long as it is in use. In the OSM Turn Off Time submenu, you can select how long the monitor waits after the last touch of a key to shut off the OSM menu. The preset choices ar
