Streszczenie treści zawartej na stronie nr. 1
User’s Guide
L2323T
Make sure to read the Important Precautions before using the product.
Keep the User's Guide(CD) in an accessible place for furture reference.
See the label attached on the back cover and quote this information to your
dealer when you require service.
Streszczenie treści zawartej na stronie nr. 2
Important Precautions This unit has been engineered and manufactured to ensure your personal safety, however improper use may result in potential e shock or fire hazards. In order to allow the proper operation of all safeguards incorporated in this display, observe the following basic rules for its installation, use, and servicing. On Safety Use only the power cord supplied with the unit. In case you use another power cord, make sure that it is certified by the applicable national standards if
Streszczenie treści zawartej na stronie nr. 3
Important Precautions On Installation Do not allow anything to rest upon or roll over the power cord, and do not place the display where the power cord is subject to damage. Do not use this display near water such as near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool. Displays are provided with ventilation openings in the cabinet to allow the release of heat generated during operation. If these openings are blocked, built-up heat can cause failures wh
Streszczenie treści zawartej na stronie nr. 4
Unpacking Your Display Please make sure the following items are included with your monitor. If any items are missing, contact your dealer. TV/AV I/II PR PR AUTO SWAP TEXT SLEEP MODE M UPDATE LIST TIME X SIZE Q.VIEW MIX HOLD APC REVEAL ? INDEX i Display Media Station Remote control / Batteries (AAA x 2) P&D cable Power Cord DVI-D Signal Cable 15-pin D-Sub Signal Cable CD-Rom/Cards S-Video Cable Audio Cable (PC) RCA Cable SCART Cable Half SCART Cable Speakers Please see the Speaker User Manual (
Streszczenie treści zawartej na stronie nr. 5
Using the Remote Control For detailed instructions of each button on the remote control, refer to the appropriate pages of this manual. Remote Control MUTE To select mute on or off. POWER Use this button to turn the display on or off. TV/AV I/II SOURCE Use this button to select an input signal. TV/AV : TV/AV button * I/II : Bilingual choice and sound mode selection Press this button to switch from Stereo to Mono sound in case of stereo transmission, or from Nicam PR Stereo to Nicam Mono, in c
Streszczenie treści zawartej na stronie nr. 6
Using the Remote Control Remote Control * PR ( ) Buttons VOL ( ) Buttons OK Button PR OK VOL VOL PR Number buttons AUTO Button •This function is to automatically search the available channels. It is available to the TV signal inputs only. •This function is to automatically adjust your AUTO SWAP display image to the ideal settings for the current screen resolution size (display mode). It is available to the PC analog signal input only. TEXT SLEEP MODE SWAP function To switch t
Streszczenie treści zawartej na stronie nr. 7
Using the Remote Control Remote Control SLEEP : SLEEP Timer You can set a time period after which the * HDTV/S-VIDEO/AV1/AV2 /TV should switch itself to standby. Press the key repeatedly to select the number of minutes. LIST : Programme list To display the programme list (0~ 99). PR OK 0 5 VOL VOL 1 C 01 6 2 C 04 7 PR 3 C 25 8 4 9 Note: TV channels displayed in blue have been setup to skipped in the PR. EDIT menu Q.VIEW : QUICK VIEW Button To display the previously selected TV channel. APC (Auto
Streszczenie treści zawartej na stronie nr. 8
Using the Remote Control Remote Control - PIP/POP function PIP (Picture in Picture) The sub-screen is changed in the order shown below. : SMALL -> LARGE -> OFF POP (Picture out Picture) The sub-screen is changed in the order shown below. : POP1 -> POP2 -> POP3 -> POP4 -> OFF AUTO SWAP POP2 POP1 800x600 480x360 256x192 TEXT SLEEP MODE 1024x768 M UPDATE LIST TIME POP3 POP4 X Q.VIEW SIZE MIX 640x768 640x768 640x480 640x480 APC REVEAL HOLD ? The POP4 menu will not be supported if the input INDE
Streszczenie treści zawartej na stronie nr. 9
Using the Remote Control Remote Control - Using the Teletext function TEXT * To select the teletext on or off. The main index page or the last selected page appears on the screen together with an information headline and an option line at the bottom of the screen. PR UPDATE OK Press the button to appear the TV programme. At VOL VOL the top of screen indicates that you are still in the teletext mode. Before interrupting teletext, you PR may select a page number. When the page has been found, the
Streszczenie treści zawartej na stronie nr. 10
Using the Remote Control Remote Control - Using the Teletext function MODE The mode will be switched in the Teletext mode. TIME When viewing a TV programme, press this AUTO SWAP button to display the time at the top right hand corner of the screen. Press this button again to remove the display. In the teletext mode, press this button to select a sub page number. The TEXT SLEEP MODE sub page number is displayed at the bottom of M the screen. To hold or change the sub page, press the RED/GREEN,
Streszczenie treści zawartej na stronie nr. 11
Using the Remote Control Insert the batteries into the remote This section shows you how to use control to operate the monitor. the remote control. Preparing the Remote Operating with the Remote Control Control 1. Open the battery cover. Point the remote control at the remote sensor and press the buttons. 2. Insert batteries (AAA size). Make sure to match the + and - on the batteries to the marks inside the battery compartment. 3. Close the cover. Within about 23ft (about 7m) TV/AV I/II * Distan
Streszczenie treści zawartej na stronie nr. 12
Connecting the Display Media Station Rear Fan: Should the temperature of the media station rise above a preset level, the fan will start up automatically to cool down the unit. Connect the P&D cable Connect to the speaker including a built- in amplifier(AMP) AV Input ports PC signal inputs Connect the audio cable to the *LINE OUT jack of the PC sound card. Connect the SCART cable Power cut-off switch of the monitor Connect various cables and the power cord and turn on before using the monitor.
Streszczenie treści zawartej na stronie nr. 13
Connecting the Display Before setting up the monitor, ensure that the power to the monitor, the computer system, and other attached devices is turned off. Using the Computer 1. Connect the P&D (Plug and Display) cable. When attached, tighten the thumbscrews to secure the connection. Media Station Rear P&D cable 2. Connect the signal cable A When connecting D-SUB signal cable Media Station Rear PC MAC Mac adapter (not included) For Apple Macintosh use, a separate plug adapter is needed to chan
Streszczenie treści zawartej na stronie nr. 14
Connecting the Display 3. Connect the power cord into a proper power outlet that is easily accessible and close to the display. Media Station Rear 4. Turn the media station power on. Media Station Rear 5. Select an input signal. Press the SOURCE button on the remote control to select an input. When connecting D-SUB signal cable A • DSUB ANALOG: 15-pin D-sub analog signal When connecting DVI-D signal cable B • DVI-D DIGITAL: DVI-D digital signal STEP A13
Streszczenie treści zawartej na stronie nr. 15
Connecting the Display Connecting the Speakers Connect the audio cable. A14 AV2 AV1 (Video)
Streszczenie treści zawartej na stronie nr. 16
Connecting the external equipment Connecting the VCR/DVD When connecting RCA cable 1. A Connect the each audio/video output jack of the VCR/DVD to the corresponding input port as shown on the Display (or Media station). Media Station Rear VCR/DVD Red RCA cable White Yellow When connecting S-Video cable B If you connect the S-Video input port to external equipment, you can have an improved definition image. Media Station Rear VCR/DVD S-Video cable Red White When connecting SCART cable C Media S
Streszczenie treści zawartej na stronie nr. 17
Connecting the external equipment Watching HDTV (720p/1080i) 1. Connect both HDTV cable (Y/Pb/Pr) and audio cable (Audio L/R) to the Display (or Media station) jack and the Set-top box jack. Media Station Rear HDTV Set-Top (Optional) Red Audio cable (not included) White Red HDTV cable (not included) Blue Green 2. Select an input signal. Press the SOURCE button on the remote control to select an input. • HDTV YPbPr STEP A16
Streszczenie treści zawartej na stronie nr. 18
Connecting the external equipment Connecting the HDTV/DVD(576i only) Take these connection steps if the HDTV/DVD player has a RCA jack and the output is 576i only. 1. Connect half of the SCART cable. Media Station Rear HDTV/DVD(576i) Red White Red Blue Green 2. Select an input signal. Press the SOURCE button on the remote control to select an input. • AV1 STEP A17
Streszczenie treści zawartej na stronie nr. 19
Connecting the external equipment Watching TV Before setting up the monitor, ensure that the power to the monitor, the computer system, and other attached devices is turned off. 1. Connect the antenna. Media Station Rear TV tuner jack Antenna (not included) 2. Select an input signal. Press the SOURCE button on the remote control to select an input. • TV STEP AUTO AV switching If your VCR is connected to the euroconnector and the VCR is switched to playback, the TV will automatically change to A
Streszczenie treści zawartej na stronie nr. 20
Control Panel Functions Front Panel Controls Control Function Source Selection: Use this button to select an input signal. • DSUB ANALOG: 15-pin D-sub analog signal • DVI-D DIGITAL: DVI-D digital signal • HDTV YPbPr: HDTV • S-VIDEO: S video • AV1 : SCART • AV2 : CVBS • TV: TV PIP (Picture in Picture) function The sub-screen is changed in the order shown below. : SMALL -> LARGE -> OFF The positions of SOURCE 1 and SOURCE 2 can be transposed by selecting SWAP on the remote control. POP (Picture ou
