Streszczenie treści zawartej na stronie nr. 1
PFM-510A1WU/510A1WE/510A1WJ
3-867-473-01 (1)
Flat Panel Monitor
GB
Operating Instructions
FR
Mode d’emploi
DE
Bedienungsanleitung
ES
Manual de instrucciones
IT
Istruzioni per l’uso
JP
PFM-510A1WU
PFM-510A1WE
PFM-510A1WJ
ª 1999 by Sony Corporation
Streszczenie treści zawartej na stronie nr. 2
For PFM-510A1WE users WARNING THIS APPARATUS MUST BE EARTHED IMPORTANT The wires in this mains lead are coloured in accordance with Owner’s Record the following code: The model and serial numbers are located on the rear. Green-and-yellow : Earth Record the model and serial numbers in the spaces provided Blue : Neutral below. Refer to these numbers whenever you call upon your Brown : Live Sony dealer regarding this product. As the colours of the wires in the mains lead of this Model No. Serial No
Streszczenie treści zawartej na stronie nr. 3
English Table of Contents Precautions ............................................................... 4 (GB) Features..................................................................... 5 (GB) Location and Function of Parts and Controls ....... 6 (GB) Front / Sides ............................................................. 6 (GB) Control Panel ........................................................... 7 (GB) Right Connector Panel ............................................. 8 (GB) Left Con
Streszczenie treści zawartej na stronie nr. 4
Precautions On repacking Do not throw away the carton and packing materials. Precautions They make an ideal container in which to transport the unit. When shipping the unit to another location, On safety repack it as illustrated on the carton. • Operate the unit on 100 to 120 V AC or 220 to 240 V AC. If you have any questions about this unit, contact your • The nameplate indicating operating voltage, power authorized Sony dealer. consumption, etc. is located on the rear. • Should any solid objec
Streszczenie treści zawartej na stronie nr. 5
Features Other features • Three sets of video inputs with audio inputs: one Features composite video or Y/C inputs, one RGB input, and one RGB/component input. The PFM-510A1W series are 16:9 42-inch flat panel • Displays the HDTV signal with tri-level sync signal. monitor adopting the PDP (Plasma Display Panel) and • Three dimensional comb filter for NTSC Y/C accepts various types of signals with the built-in scan separation. converter. • Line correlation comb filter for PAL Y/C separation. • Au
Streszczenie treści zawartej na stronie nr. 6
Location and Function of Parts and Controls 5 Right connector panel For details on the right connector panel, see “Right Location and Function Connector Panel” on page 8 (GB). of Parts and Controls 6 Right panel cover Open it when using the right connector panel. For details on opening the panel cover, see the below on Front / Sides this page. Front To open the panel cover Loosen the screws counterclockwise and open the cover. 1 2 To take off the panel cover Left side Right side Loosen the screw
Streszczenie treści zawartej na stronie nr. 7
Location and Function of Parts and Controls Control Panel VOL – VOL + MENU mM ENT RGB1 YUV RGB2 LINE Y/C CTRL 1 qd qs qa 0 98765 4 3 2 1 1 Remote control detector 9 RGB1 button Receives the beam from the Remote Commander. Select the RGB signal input from the RGB1 connectors. 2 1 (standby) switch/1 (standby) indicator 0 ENT (enter) button Press to turn the monitor on. Press again to go back to the standby mode. Press to select the desired item in a menu. The 1 (standby) indicator lights up in red
Streszczenie treści zawartej na stronie nr. 8
Location and Function of Parts and Controls 1 RGB1 IN connectors Right Connector Panel R (R-Y)/G (Y)/B (B-Y) IN (BNC-type): Input the analog RGB signal or component signal. Connect to the RGB signal or component (Y/B-Y/R-Y) signal output of a computer or video equipment. This unit also accepts the HD analog component RGB 1 IN OUT (Y/PB/PR) signal. Input the PB signal to the B (B- R R-Y Y) IN connector and PR signal to the R (R-Y) IN connector. G Y HD/COMP IN (BNC-type): Input the H sync signal o
Streszczenie treści zawartej na stronie nr. 9
Location and Function of Parts and Controls 4 RGB1 OUT connectors 6 REMOTE (RS-232C) connector (mini DIN 8- These connectors are used as loop-through outputs of pin) the RGB1 IN connectors 1. This connector allows remote control of the monitor When the plug is connected to the RGB OUT using the RS-232C protocol. For details, see your connectors, the 75-ohms termination of the RGB IN authorized Sony dealer. connectors is released, and the signal input to the RGB IN connectors is output from the t
Streszczenie treści zawartej na stronie nr. 10
Location and Function of Parts and Controls Left Connector Panel Notes • If you connect the CONTROL S IN jack to the other equipment’s CONTROL S OUT jack, you cannot operate the monitor with the Remote Commander. MONITOR OUT AUDIO • You can use the stereo cable with mini plug instead RL 1 of the control S cable. VARIABLE CONTROL S 3 SPEAKERS L/R terminals IN OUT 2 Connect to speakers with 6 to 16 ohms impedance. SPEAKERS (6-16 Ω) Note Do not connect the speaker’s cord to the monitor and + + R– L
Streszczenie treści zawartej na stronie nr. 11
Location and Function of Parts and Controls 1 POWER switch qs DISPLAY button Press to turn on the monitor. Press again to go back to Displays the input signal information on the top of the the standby mode. monitor screen. Press again to clear it. Note qd YUV button When using multiple monitors, press this switch to Selects the component signal input from the RGB1 turn monitors which are already on into the standby connectors. mode, or turn on monitors which are in the standby mode. qf MTS/MPX b
Streszczenie treści zawartej na stronie nr. 12
Location and Function of Parts and Controls / Installation Installing batteries Installation Insert two size AA (R6) batteries in correct polarity. Using the Retractable Feet This section describes the installation arrangements Be sure to install the for installing the projector. negative <– end first. 1 Pull out the knobs and pull down the retractable feet. E e e E 2 Turn the retractable feet outward. • In normal operation, batteries will last up to half a year. If the Remote Commander does not
Streszczenie treści zawartej na stronie nr. 13
Installation Side Caution 7 3.5 (1 /8) • When you install the monitor, make sure there is more space than that shown in the figure below. • The ambient temperature must be 0°C – +35°C Wall (32°F – 95°F). When using the retractable feet Units: cm (inches) Front Hooked on the wall: Vertically Wall Front 7 20 (7 /8) Wall 10 (4) 10 10 Wall Wall (4) (4) 20 25 7 7 (7 /8) (9 /8) Floor Wall Wall 2.5 (1) Make sure that Side the control section is at the bottom. 1 5.5 (2 /4) 10 (4) Wall Side Wall
Streszczenie treści zawartej na stronie nr. 14
Connections Connections Connecting the AC Power Cord 1 Plug the power cord into the AC IN socket. Then, attach the AC plug holder (supplied) to the AC power cord. AC power cord AC IN socket AC plug holder 2 Slide the AC plug holder over the cord until it connects to the AC IN socket cover. AC IN socket cover To remove the AC power cord Squeeze the upper and lower sides and pull out the AC plug holder. Connection Example Before you get started • First make sure that the power to each piece of equ
Streszczenie treści zawartej na stronie nr. 15
Connections Computer Betacam SP video cassette recorder to component signal output * to R(R-Y)/G(Y)/ RGB 1 B(B-Y), HD/COMP, to audio to video to video IN OUT to audio VD IN R output output output R-Y output G Y B B-Y to audio * to R(R-Y)/G(Y)/ output HD/ COMP B(B-Y) IN SYNC VD to AUDIO IN to AUDIO IN L AUDIO R RGB 2 RGB IN L to RGB IN AUDIO IN R to AUDIO IN VIDEO to Y/C or VIDEO IN Y/C L AUDIO R IN OUT to AUDIO IN LINE to video to audio output output VCR, laser disc player, game machine, etc. *
Streszczenie treści zawartej na stronie nr. 16
Using On-screen Menus 4 Press M/m to adjust or select the setting and press ENT to set. Using On-screen Menus The setting is registered and the menu returns to the previous menu. Operating Through Menus To return to the normal screen, press the MENU button repeatedly until the menu disappears. Menu operating buttons Menu Guide There are four buttons on the monitor and the Remote Commander for menu operations. Note Remote Commander Monitor “– – – –” appears n
Streszczenie treści zawartej na stronie nr. 17
Using On-screen Menus • DTV signals for factory setting: PIC SIZE menu 1080/60i, 480/60i, 575/50i, 480/60p • Other DTV signals and their recommended settings: This menu is used for positioning and resizing the picture. HVH V ASPECT SIZE SIZE SHIFT SHIFT 1080/50i + 48 + 11 + 10 – 02 16:9 7 PI C S I Z E HSIZE : 00 1080/48i MAX + 09 + 12 – 02 16:9 8 HSHIFT : 00 9 1152/50i + 33 – 02 + 20 0 16:9 VSIZE : 00 VSHIFT : 00 0 ASPE CT : 4 x 3 qa R ESE T qs CONFIG menu SE L E CT ENTER C A N C E L MENU This m
Streszczenie treści zawartej na stronie nr. 18
Using On-screen Menus wa REMOTE ONLY MEMORY menu Select ON to disable the front control buttons on the monitor. The monitor can only be controlled with the This menu is used for saving or recalling the settings Remote Commander. While REMOTE ONLY is ON, in the PIC CONTROL, PIC SIZE and CONFIG (only the indicators on the front panel go off. for ENHANCE and H FILTER) menus. To cancel the REMOTE ONLY mode, set REMOTE ONLY to OFF with the Remote Commander, or press MEMO R Y LO A D the CTRL button wh
Streszczenie treści zawartej na stronie nr. 19
Using On-screen Menus Note The “TEMPERATURE NG” message may appear when the ventilation holes are blocked or the monitor is installed in a poorly ventilated area. In this case, check that the ventilation holes are not blocked and install the monitor in a good ventilated area. If the message still displayed, contact your authorized Sony dealer. When the 1 indicator flashes or NG indicates, see “Self- diagnosis Function” on page 26 (GB). wj FAN The cooling fans are built in this monitor. This item
Streszczenie treści zawartej na stronie nr. 20
Watching the Picture Note Watching the Picture We recommend the input source video equipment equipped with the TBC (time base corrector). If you Before you start receive the signal without the TBC, the picture may • Turn on the monitor. disappear due to disturbance of the sync signal. • Turn on the connected equipment and play a video source. Input Signal and Monitor Status • To display the input signal information on the screen Information Display when turning on the power or switching the inpu
