Streszczenie treści zawartej na stronie nr. 1
R
SP97/SP97-V
®
Pentium Motherboard
USER’S MANUAL
Streszczenie treści zawartej na stronie nr. 2
USER’S NOTICE No part of this manual, including the products and softwares described in it, may be repro- duced, transmitted, transcribed, stored in a retrieval system, or translated into any language in any form or by any means, except documentation kept by the purchaser for backup pur- poses, without the express written permission of ASUSTeK COMPUTER INC. (“ASUS”). ASUS PROVIDES THIS MANUAL “AS IS” WITHOUT WARRANTY OF ANY KIND, EITHER EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE IMPLIE
Streszczenie treści zawartej na stronie nr. 3
CONTACT INFORMATION ASUSTeK COMPUTER INC. Marketing Info Address: 150 Li-Te Road, Peitou, Taipei, Taiwan 112, ROC Telephone: +886-2-894-3447 Fax: +886-2-894-3449 Email: info@asus.com.tw Technical Support Fax: +886-2-895-9254 BBS: +886-2-896-4667 Email: tsd@asus.com.tw WWW: www.asus.com.tw Gopher: gopher.asus.com.tw FTP: ftp.asus.com.tw/pub/ASUS ASUS COMPUTER INTERNATIONAL Marketing Info Address: 721 Charcot Avenue, San Jose, CA 95131, USA Telephone: +1-408-474-0567 Fax: +1-408-474-0568 Email: in
Streszczenie treści zawartej na stronie nr. 4
CONTENTS I. INTRODUCTION............................................................................ 7 How this Manual is Organized ........................................................ 7 Item Checklist .................................................................................. 7 II. FEATURES ..................................................................................... 8 Features of the ASUS SP97 Motherboard ....................................... 8 Introduction to ASUS SP97 Se
Streszczenie treści zawartej na stronie nr. 5
CONTENTS Load Setup Defaults ................................................................... 52 Supervisor Password and User Password .................................. 53 IDE HDD Auto Detection .......................................................... 54 Save and Exit Setup ................................................................... 55 Exit Without Saving ................................................................... 55 V. SUPPORT SOFTWARE ....................................
Streszczenie treści zawartej na stronie nr. 6
FCC & DOC COMPLIANCE Federal Communications Commission Statement This device complies with FCC Rules Part 15. Operation is subject to the following two conditions: • This device may not cause harmful interference, and • This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provid
Streszczenie treści zawartej na stronie nr. 7
I. INTRODUCTION How this Manual is Organized I. Introduction Contents and checklist II. Features Product information and specifications III. Installation Instructions on setting up the motherboard IV. BIOS Software Instructions on setting up the BIOS software V. Support Software Information on the included support software VI. ASUS SCSI Cards Installation of optional ASUS SCSI cards VII. ASUS Audio Card Installation of an optional 16-bit audio card Item Checklist Check that your package is compl
Streszczenie treści zawartej na stronie nr. 8
II. FEATURES (ASUS SP97) II. FEATURES Features of the ASUS SP97 Motherboard The ASUS SP97 motherboard is carefully designed for the demanding PC user who wants many features in a small package, namely: • SiS Chipset: Features either SiS5582 or SiS5598 chipsets. The SiS5598 chipset has a built-in video controller and supports video shared memory from 1MB to 4MB. ® ™ • Versatile Processor Support: Intel Pentium 75–233MHz (P55C-MMX , P54C/ ® ® ® ® ™ P54CS), IBM /Cyrix 6x86-PR166+ (Rev 2.7 or later
Streszczenie treści zawartej na stronie nr. 9
II. FEATURES Introduction to ASUS SP97 Series of Motherboards Performance • Double the IDE Transfer Speed: ASUS SP97 series of motherboards with SiS 5582 or SiS 5598 (with VGA) improves IDE transfer rate using Bus Master UltraDMA/33 IDE, which can handle data transfers up to 33MB/s. This new technology is compatible with existing ATA-2 IDE specifications so there is no need to upgrade current hard disk drives or cables. • Concurrent PCI: Concurrent PCI allows multiple PCI transfers from PCI mas-
Streszczenie treści zawartej na stronie nr. 10
(This page was intentionally left blank) 10 ASUS SP97 / SP97-V User’s Manual
Streszczenie treści zawartej na stronie nr. 11
II. FEATURES The ASUS SP97 Motherboard USB, PS/2 Mouse, Infrared Parallel Serial Keyboard Super Multi I/O 3 PCI Slots 2 ISA Slots 1 ISA/PCI Shared Slot AT Power Conn. ATX Power Conn. Floppy Connector IDE Connectors 4 SIMM Sockets SiS5582 or 5598 (VGA) Chipset Programmable Flash ROM CPU ZIF Socket 7 Switching Voltage Regulators 512KB/256KB Pipelined Burst L2 Cache ASUS SP97 / SP97-V User’s Manual 11 II. FEATURES (ASUS SP97)
Streszczenie treści zawartej na stronie nr. 12
SIMM Socket 4 (32-bit, 72-pin module) SIMM Socket 3 (32-bit, 72-pin module) SIMM Socket 2 (32-bit, 72-pin module) SIMM Socket 1 (32-bit, 72-pin module) VGA Connector 512KB/256KB Pipelined Burst L2 Cache Floppy Drives Secondary IDE Primary IDE BF2 BF1 PCI Slot 1 BF0 Super Multi-I/O PCI Slot 2 PCI Slot 3 R PCI Slot 4 ISA Slot 1 RTC Clear / Battery Test Feature Connector ISA Slot 2 Flash BIOS ISA Slot 3 Panel Connectors III. INSTALLATION (Motherboard Layout) III. INSTALLATION ASUS SP97 Motherboard
Streszczenie treści zawartej na stronie nr. 13
III. INSTALLATION Jumpers 1) RTCLR p. 15 Real Time Clock RAM (Keep CMOS/Clear CMOS) 2) VID0, VID1, VID2 p. 16 CPU Voltage Output Selection 3) FS0, FS1, FS2, FS3 p. 16 CPU External Frequency (BUS) Selection 4) BF0, BF1, BF2 p. 16 CPU to BUS Frequency Ratio 5) VGA_ SEL/_SEL1 (optional) p. 18 Onboard VGA Setting 6) VGA_INT (optional) p. 18 Onboard VGA Interrupt Selection Expansion Slots 1) System Memory p. 20 System Memory (SIMM) 2) SIMM1, SIMM2, SIMM3, SIMM4 p. 21 72-Pin SIMM Sockets 3) CPU p. 23
Streszczenie treści zawartej na stronie nr. 14
III. INSTALLATION (Jumpers) III. INSTALLATION Installation Steps Before using your computer, you must complete the following steps: 1. Set Jumpers on the Motherboard 2. Install DRAM Modules 3. Install the Central Processing Unit (CPU) 4. Install Expansion Cards 5. Connect Ribbon Cables, Cabinet Wires, and Power Supply 6. Set Up the BIOS Software 1. Jumpers Several hardware settings are made through the use of jumper caps to connect the jumper pins on the motherboard. See layout of motherboard on
Streszczenie treści zawartej na stronie nr. 15
R III. INSTALLATION Jumper Settings 1. Real Time Clock (RTC) RAM (RTCLR) The CMOS RAM is powered by the onboard button cell battery. To clear the RTC data: (1) Turn off your computer and unplug the AC power, (2) Move this jumper to Clear CMOS, (3) Move the jumper back to Normal Set., (4) Turn on your computer, (5) Hold down during bootup and enter BIOS setup to re-enter user preferences. Battery Test Jumper (BAT_TEST) You can test the battery’s current by removing this jumper and attach
Streszczenie treści zawartej na stronie nr. 16
R III. INSTALLATION (Jumpers) III. INSTALLATION Compatible Cyrix CPU Identification The only Cyrix processor that is supported on this motherboard is labeled Cyrix 6x86-P166+, which should be Revision 2.7 or later. Look on the underside of the CPU for the serial number, which should read G8DC6620A or later. 2. CPU Voltage Output Selection (VID0, VID1, VID2) These jumpers set the voltage supplied to the CPU. The voltage regulators will auto- matically detect and switch between Single Power Plane
Streszczenie treści zawartej na stronie nr. 17
BF2 BF1 BF0 BF2 BF1 BF0 BF2 BF1 BF0 BF2 BF1 BF0 BF2 BF1 BF0 BF2 BF1 BF0 R III. INSTALLATION 3. CPU External Frequency (BUS) Selection (FS0, FS1, FS2, FS3) These jumpers tell the clock generator what frequency to send to the CPU. These allow the selection of the CPU’s external frequency (or BUS Clock). The BUS Clock multi- plied by the BUS Ratio equals the CPU’s internal frequency (the advertised CPU speed). When BUS Frequency is set to 75MHz or more, the PCI Frequency Selector (FS3) must be set
Streszczenie treści zawartej na stronie nr. 18
III. INSTALLATION (Jumpers) III. INSTALLATION Set the jumpers according to the internal speed of your processor as follows: (BUS Freq.) (Freq. Ratio) CPU Model Freq. Ratio BUS Freq. FS0 FS1 FS2 FS3 BF0 BF1 BF2 Intel Pentium 233MHz 3.5x 66MHz [2-3] [1-2] [2-3] [1-2] [1-2] [1-2] [1-2] Intel Pentium 200MHz 3.0x 66MHz [2-3] [1-2] [2-3] [1-2] [1-2] [2-3] [1-2] Intel Pentium 166MHz 2.5x 66MHz [2-3] [1-2] [2-3] [1-2] [2-3] [2-3] [1-2] Intel Pentium 150MHz 2.5x 60MHz [1-2] [2-3] [2-3] [1-2] [2-3]
Streszczenie treści zawartej na stronie nr. 19
VGA_SEL VGA_SEL VGA_INT VGA_INT VGA_SEL1 VGA_SEL1 VGA_SEL VGA_SEL VGA_INT VGA_INT VGA_SEL1 VGA_SEL1 R R III. INSTALLATION 5. VGA Selection (VGA_SEL & VGA_SEL1) (with onboard VGA version only) These jumpers allow you to turn the onboard VGA on or off. You need to disable the onboard VGA to use your own add-on VGA expansion card. Enable VGA Disable VGA (Default) Onboard VGA 6. VGA Selection (VGA_INT) (with onboard VGA version only) These jumpers allow you to set the VGA interrupt method. The def
Streszczenie treści zawartej na stronie nr. 20
III. INSTALLATION (System Memory) III. INSTALLATION 2. System Memory (SIMM) This motherboard supports four 72-pin, 32-bit SIMMs (Single Inline Memory Mod- ules) of 4, 8, 16, 32, or 64MB to form a memory size between 8MB to 256MB. The SIMMs can be either 60ns or 70ns Fast Page Mode (FPM) (Asymmetric or Sym- metric), or Extended Data Output (EDO) (BEDO & Parity are not supported). SIMMs must be installed in pairs so that each Row (refer to motherboard layout for Row locations) contains 64-bits of
