Instrukcja obsługi Metra Electronics 99-3009

Streszczenie treści zawartej na stronie nr. 1

KIT FEATURES
Shaft and
DIN unit
provisions
99-3009
KIT COMPONENTS INSTALLATION
INSTRUCTIONS
Radio Housing
APPLICATIONS
CAR PAGE
CHEVROLET
Camaro 1993-96..........................................................1
PONTIAC
Spacer
Bonneville 1994-99......................................................1
Firebird 1993...............................................................4
(1) Keps Nut Firebird 1994-02........................................................ 5
G

Streszczenie treści zawartej na stronie nr. 2

4 5 CHEVROLET Camaro 1993-96 A B 1 2 "A" C Fig. A D A) Strip wire ends back ½" B) Twist ends together C) Solder D) Tape Fig. B Locate the factory wiring harness in the Disconnect the negative battery terminal to dash. Metra recommends using the prevent an accidental short circuit. Remove Cut and remove all mounting tabs on the proper mating adaptor and making (2) Phillips screws from the top of the driver's Radio Housing EXCEPT tabs "A". The connections as shown. (Isolate and side

Streszczenie treści zawartej na stronie nr. 3

PONTIAC Trans Am / Firebird 1994-02 PONTIAC Grand Am 1996-98 1 2 1 2 "C" "C" Disconnect the negative battery terminal to Cut and remove all mounting tabs on the Disconnect the negative battery terminal to Cut and remove all mounting tabs on the prevent an accidental short circuit. Unclip Radio Housing EXCEPT tabs "C". The prevent an accidental short circuit. Remove Radio Housing EXCEPT tabs "C". The the radio trim bezel. Remove (4) 7mm hex- mounting tabs can be identified by the (2) Phi

Streszczenie treści zawartej na stronie nr. 4

PONTIAC Grand Prix 1994-02 PONTIAC Sunfire 1995-99 1 2 1 2 "C" Fig. A "C" Disconnect the negative battery terminal to Cut and remove all mounting tabs on the Disconnect the negative battery terminal to prevent an accidental short circuit. Using a Radio Housing EXCEPT tabs "C". The prevent an accidental short circuit. Open Fig. B small set of pliers, grasp the retaining clip on mounting tabs can be identified by the the glove box and remove (2) Phillips screws the back of the gear shif