Streszczenie treści zawartej na stronie nr. 1
How to use this file
Print Vendor
Operator’s Manuals
Instructions
Paper Size: 11x17
Body - 50 lbs brilliant white offset or equivalent
Cover - on pre-printed two tone “Swash” stock.
Press: Body - 1 color, 2-sided
Cover - 1 color, 1 sided
Bindery: Saddle stitch, face trim *if too thick for saddle stitch, tape bind
Covers: FRONT COVER is present at the beginning of the file.
BACK COVER is the page immediately after the front cover.
The part number for this manual (typically a
Streszczenie treści zawartej na stronie nr. 2
THIS PAGE INTENTIONALLY BLANK (FOR PLACEMENT ONLY - DO NOT PRINT)
Streszczenie treści zawartej na stronie nr. 3
OPERATOR’S MANUAL Single Stage Snowthrower 319M Models Mfg. No. Description 1694583 319M, 3HP Snowthrower, Manual Start 319E Models Mfg. No. Description 1694584 319E,3HP Snowthrower, Electric Start Manual No. 1727190 Rev 4/2004 TP 100-4091-00-SW-S
Streszczenie treści zawartej na stronie nr. 4
MANUFACTURING, INC. 500 N Spring Street / PO Box 997 Port Washington, WI 53074-0997 www.simplicitymfg.com © Copyright 2004, Simplicity Manufacturing, Inc. All Rights Reserved. Printed in USA.
Streszczenie treści zawartej na stronie nr. 5
Table of Contents Safety Rules & Information Regular Maintenance Training ...................................................................2 Check Auger Cable & Stopping Time ...................12 Preperation .............................................................2 Check Auger & Flite Shoes...................................12 Operation .............................................................2-3 Check Drive Belt ..................................................12 Children.........
Streszczenie treści zawartej na stronie nr. 6
Safety Rules & Information This machine is capable to amputating hands and feet. Read these safety rules and follow them closely. Failure to obey these rules could result in loss of control of unit, severe personal injury or death to you, or bystanders, or damage to property or equipment. The triangle in text signifies important cautions or warnings which must be followed. TRAINING OPERATION 1. Read, understand, and follow all instructions on the 1. Do not put hands or feet near or und
Streszczenie treści zawartej na stronie nr. 7
Safety Rules 21. Keep in mind the operator is responsible for acci- 8. Always follow the engine manual instructions for stor- dents occurring to other people or property. age preparations before storing the unit for both short 22. Data indicates that operators, age 60 years and and long term periods. above, are involved in a large percentage of power 9. Always follow the engine manual instructions for equipment-related injuries. These operators should proper start-up procedures when returning t
Streszczenie treści zawartej na stronie nr. 8
S SA AM MP PL LE E IDENTIFICATION NUMBERS PRODUCT REFERENCE DATA Model Description Name/Number Unit MFG Number Unit SERIAL Number Mower Deck MFG Number Mower Deck SERIAL Number Date Purchased Dealer Name ID Tag ENGINE REFERENCE DATA When contacting your authorized dealer for replace- Engine Make Engine Model ment parts, service, or information you MUST have these numbers. Engine Type/Spec Engine Code/Serial Number Record your model name/number, manufacturer’s identi- fication numbers, and en
Streszczenie treści zawartej na stronie nr. 9
Safety Decals / Identification Numbers SAFETY DECALS Safety warning decals are placed at strategic locations on the snowthrower as a constant reminder to the operator of the most important safety precautions. All warning, caution and instructional messages on your snowthrower should be carefully read and obeyed. If any of these decals are lost or damaged, replace them at once. They can be pur- chased from your local dealer. 7028315 Part No. 7028315 Part No. 7072883 Control Decal - Primer, Key Co
Streszczenie treści zawartej na stronie nr. 10
Features & Controls All Models Electric Start Models CONTROL LOCATIONS The information below briefly describes the function of individual controls. Starting, stopping, and driving require the combined use of several controls applied in specific sequences. To learn what combination and sequence of controls to use for various tasks see the OPERATION section. NOTE: Throttle - This snowthrower does NOT have a throttle for controlling operating speed of engine. The engine governor maintains operati
Streszczenie treści zawartej na stronie nr. 11
Features & Controls Chute Deflector Control Ignition Switch Controls the distance snow is thrown. Tilting the chute The ignition switch starts and stops the engine, and can deflector UP provides a higher stream and greater dis- be removed to prevent engine starting. It has two posi- tance, while tilting the deflector DOWN provides a lower tions: stream and less distance. Loosen the deflector knob, OFF Stops the engine and shuts off the adjust the deflector, then retighten the knob. electri
Streszczenie treści zawartej na stronie nr. 12
Operation WARNING GENERAL OPERATION OPERATIONAL WARNINGS CHECKS BEFORE EACH START-UP Clearing The Discharge Chute 1. Make sure all safety guards are in place and all nuts, To avoid serious injury, do not put your hands bolts and clips are secure. into the auger housing or discharge chute. If the auger stalls or chute becomes plugged, use the 2. Check the fuel supply. Fill the tank no closer than 1/4 following procedure to remove objects or clear to 1/2 inch of top of tank to provide space for ex
Streszczenie treści zawartej na stronie nr. 13
Operation FUEL AND OIL MIXTURE WARNING The snowthrower uses a two cycle engine that requires a mixture of fuel (gasoline) and oil for lubrication of engine Gasoline is highly flammable and must be bearings and other moving parts. handled with care. Follow these fuel handling precautions: The correct fuel/oil mixture ratio is 50 to 1. Use fuel/oil mixture chart shown. Use an approved fuel container. NOTE: To prevent damage to engine, carefully DO NOT run the unit indoors. DO NOT fill fuel o
Streszczenie treści zawartej na stronie nr. 14
Operation STARTING THE ENGINE A B NOTE: The snowthrower engine is designed to operate at cold temperatures. Avoid operating the snowthrower if air temperature is 40° F or warmer. Engine will be diffi- cult to start in warm weather. WARNING Electric start precautions: Use only with a grounded, polarized 120V AC outlet. Do not modify the plug to fit into any other type of outlet. Use only the power cord supplied with the unit. DO NOT use a damaged cord. E D C Be sure there is no moisture p
Streszczenie treści zawartej na stronie nr. 15
Operation OPERATING THE SNOWTHROWER SNOWTHROWING TIPS Before operating snowthrower, review the CHECKS Discharge chute plugging may occur as the result of BEFORE EACH START UP on page 8 of this manual. snow build up inside the chute. DO NOT use your hands Refer to FEATURES & CONTROLS for control locations. to clear the blockage, only use the clean-out tool. DO NOT place your hands near the auger or discharge chute 1. Rotate the discharge chute to the desired direction. any time the engine is ru
Streszczenie treści zawartej na stronie nr. 16
F F O Regular Maintenance MAINTENANCE SCHEDULE MAINTENANCE ITEMS Before Each Use Every 25 Hours Every 100 Hours Each Season Check Auger Cable & Stopping Time Check Auger & Flite Shoes Check/Adjust Drive Belt** Clean Cooling Fins * Inspect Spark Plug * Replace Fuel Filter * Refer to the Engine Manufacturer’s Owner’s Manual for engine-related information. ** Adjust after the first 5 hours of operation. CHECK AUGER CABLE & STOPPING A TIME 1. Visually check the cable (C, Figure 3) for
Streszczenie treści zawartej na stronie nr. 17
Troubleshooting, Adjustments, & Service TROUBLESHOOTING PROBLEM PROBABLE CAUSE CORRECTIVE ACTION Engine Will Not Start 1. Fuel tank empty. 1. Fill fuel tank with fresh fuel/oil mix. Using Recoil Starter 2. Engine needs choking & priming. 2. Move choke control to "CHOKE" position. Push primer bulb three times. 3. Spark plug fouled or wire disconnected. 3. Replace spark plug. Attach plug wire onto spark plug. Engine Will Not Crank 1. Power extension cord not plugged into 1. Plug power extension co
Streszczenie treści zawartej na stronie nr. 18
Troubleshooting, Adjustments, & Service WARNING Before beginning any repair stop the engine, remove the key, disconnect the spark plug wire, and wait for all moving parts to stop. AUGER CONTROL ADJUSTMENT Inspection B 1. Inspect the auger cable for kinks, wear, or frayed cable strands. Replace if worn or damaged. A 2. Start the engine. 3. Engage the auger control for 5 seconds. Figure 5. Auger Cable Adjustment - Disengaged 4. Disengage the auger control. The auger should stop A. Cable Spring
Streszczenie treści zawartej na stronie nr. 19
F F O Troubleshooting, Adjustments, & Service AUGER DRIVE BELT IDLER PULLEY ADJUSTMENT A If the auger control cable has run out of adjustment, the B D drive belt idler pulley (B) can be adjusted to take up more C belt slack. 1. Turn the engine OFF. 2. Loosen the jam nut (B, Figure 5) at the upper end of the cable. Hold the threaded end of the cable and turn the cable counterclockwise until the adjustment is half way between fully in and fully out. 3. Remove the belt cover to access the idler pu
Streszczenie treści zawartej na stronie nr. 20
F F O Troubleshooting, Adjustments, & Service A A Figure 9. Drive Belt Bracket Figure 8. Drive Belt A. Spring-Loaded Idler Pulley A. Belt Guide AUGER DRIVE BELT REPLACEMENT Equal Clearance C Inspect belt frequently for signs of excessive wear. A B Visually check for cracking, fraying, severed or exposed belt strands. 1. Remove the side belt cover (D, Figure 3). 2. Remove both belt cover retaining studs (D, Figure 7). Equal 3. Remove belt guide (A, Figure 8) Clearance 4. Push the spring-loaded
