Instrukcja obsługi Siemens CD 3002

Streszczenie treści zawartej na stronie nr. 1

Air Blower
for CD 3002
Your
eye
in
hell

Streszczenie treści zawartej na stronie nr. 2

© Siemens Laser Analytics AB Jan 2001 CD 3002 Air blower manual Document number: CID 3002-1110 Rev. 1A

Streszczenie treści zawartej na stronie nr. 3

LDS 3000 Air blower Content Content 1. Purging of CD 3002 using air blower 1 1.1 General 1 1.2 Installation 1 1.3 Maintanance 4 I

Streszczenie treści zawartej na stronie nr. 4

Content LDS 3000 Air blower II

Streszczenie treści zawartej na stronie nr. 5

LDS 3000 Air blower Purging of CD 3002 using air blower 1. Purging of CD 3002 using air blower 1.1 General In application with high dust load and ash build-up in front of the lens in CD 3002 very high purging flows may be necessary. For these applica- tions an air blower producing flow rates in the 1000 ltr/min. range can be used. A typical application where this is preferable is in MWI (municipal waste incineration). This manual relates to the installation and operation of the air blower se

Streszczenie treści zawartej na stronie nr. 6

Purging of CD 3002 using air blower LDS 3000 Air blower 1000 Maximum Maximum m flow: flow: Q Q 900 9 900 ltr/min ltr/min m n 100 110 Length of tube [m] Flow rate vs length of the tube between the air blower and the sensor. Mechanical The air blower should be monted close to the sensor using bolts of the di- mension M10 on the following positions 226 mm Position of mounting holes. 2 220 mm Air flow [ltr/min]

Streszczenie treści zawartej na stronie nr. 7

LDS 3000 Air blower Purging of CD 3002 using air blower The position of the air blower should either be horizontal with the mount- ing plate facing downwards or vertical with the air exit facing upwards. The figure below shows a good way of setting up the sensor with an air blower. Output air tube Input air filter Air blower Example set-up of CD 3002 with air blower. 3

Streszczenie treści zawartej na stronie nr. 8

Purging of CD 3002 using air blower LDS 3000 Air blower 1.3 Maintanance The major maintanance on the air blower is to change the input filter at a regular interval. The time between changes is totally dependent on the environment in which the air blower operates. The inlet under-pressure (directly after the filter) will reveal the condition of the filter and can be used to monitor this. Siemens Laser Analytics can provide suitable equippment for this. 4