Instrukcja obsługi Prince Castle 428-A

Streszczenie treści zawartej na stronie nr. 1

OPERATING
INSTRUCTIONS
TABLE OF CONTENTS PAGE
Conveyor Toaster
Installation ..................................................................... 2
Operation ....................................................................... 2
Model No. 428 Series
Preventive Maintenance ............................................... 2
Cleaning ........................................................................ 3
Troubleshooting Chart .................................................. 3
Exploded View .

Streszczenie treści zawartej na stronie nr. 2

7. The toaster fan located on the bottom of the INTENDED USE toaster in the rear draws in cool room air and circulates it through the toaster sides and tops. This toaster is designed to toast breads bagels or To insure adequate heat dissipation do not posi- English muffins.Do not attempt to toast croissants. tion the toaster where the fan would draw in hot Their butter content will cause them to stick to the discharge from another appliance. conveyor. Do not attempt to toast products that have b

Streszczenie treści zawartej na stronie nr. 3

2. Unplug toaster. CLEANING 3. Remove crumb tray and clean toaster and parts The conveyor chain should not touch the top surface by wiping with damp cloth. of the crumb tray holder. If the chain does touch, Note: Some units come with a Teflon coated return retension it by un plugging the unit, remove both chute. Do Not use an abrasive cleaning agent or side covers, loosen the front bearing mounting scrub brush on the Teflon. screws and pivot the bearing until the chain no longer touches. Re-tigh

Streszczenie treści zawartej na stronie nr. 4

EXPLODED VIEW 428-122 Top Cover 428-126 Side Cover 428-108 Rear Cover 428-185S (428-3E) 428-165S(428-B, 4 elements) 421-134S(208-240 Volt) 428-170S (428-B. 6 421-072S 421-133S (120Volt) elements) Idler Sprocket** Speed Control Switch 428-166S(428-C 78-173S 428-167S(428-D&E) 86-256S 428-112 Heat Control Switch 428-385S (428-A) Sprocket** Lead In Ramp 428-411S (428-3B) Heater Assy. 428-138 70-043 Chain Assy. Speed Control Knob 87-018S Motor 428-223 428-142S Crumb Tray Fan 72-159S (428-B&D) 70-042

Streszczenie treści zawartej na stronie nr. 5

WIRING DIAGRAM (428-B, C, D & E) WIRING DIAGRAM (428-A) 5

Streszczenie treści zawartej na stronie nr. 6

6

Streszczenie treści zawartej na stronie nr. 7

7

Streszczenie treści zawartej na stronie nr. 8

8