Instrukcja obsługi Milwaukee 7110-20

Streszczenie treści zawartej na stronie nr. 1

PAGE 1 OF 2
BULLETIN NO.
SERVICE PARTS LIST
54-43-0020
REVISED BULLETIN
SPECIFY CATALOG NO. AND SERIAL NO. WHEN ORDERING PARTS DATE
Feb. 2007
CLIPPED HEAD FRAMING NAILER
WIRING INSTRUCTION
STARTING
CATALOG NO. 7110-20
SERIAL NUMBER A86A
56
57
58
55 60
1
54
30
53
20
2
52
51
99
3
50
86
21
31 59
41
4
32
22
5
8
36
47
33
6
43
35 31 32 33 34 35 36
102
42
34 37 38 39 40 41 50
46
37
23
38
45
7
EXAMPLE:
44
39
00
Component Parts
0
9 40
(Small #) Are Included
48
When Ordering The
Assembly (Large #)

Streszczenie treści zawartej na stronie nr. 2

99 86 94 91 93 90 88 91 90 95 100 92 89 18 61 87 62 74 83 79 101 73 90 96 80 75 85 81 82 77 18 97 105 98 76 84 104 78 75 76 77 78 79 80 103 81 82 83 84 85 87 FIG. PART NO. DESCRIPTION OF PART NO. REQ. FIG. PART NO. DESCRIPTION OF PART NO. REQ. 61 34-40-3145 O-Ring 1 90 05-59-2020 Lock Nut 1 62 30-61-0210 Nose Piece 1 91 05-83-0510 Half Round Hd. Hex. Bolt 1 73 05-84-0870 Bolt Assembly 4 92 44-66-1320 Nail Stop Plate 1 74 43-40-0480 Magazine A 1 93 42-92-1460 Ma

Streszczenie treści zawartej na stronie nr. 3

BULLETIN NO. 54-43-0020 Feb. 2007 PAGE 2 OF 2 Disassembly: 7, 10, 11, 12, 13, 14, 15, Remove valve assembly (10-17) from top cap (7) by removing hex bolt (18) in a counter clockwise direction. 16, 17, 18 Note: Assembly is spring loaded. Hold assembly in place while removing hex bolt (18). 23, 24, 51, 19, 20 Remove driver assembly (23) and cylinder assembly (24) from tool body (51) by turning the tool body (51) upside down and tapping the outside rim of the tool casting against a piece of w

Streszczenie treści zawartej na stronie nr. 4

Lubrication: Type I Grease 49-08-7100 Clean all parts with a dry clean cloth. 7, 10, 11, 12, 13, 14, 15, Place a thin coating of grease into internal bore of top cap (7), coat parts (10-17) and reassemble in order shown. 16, 17 21, 22, 23 Coat o-ring (22) and piston ring (21) prior to installing into groove of driver assembly (23). 24, 25, 27, 28 Coat cylinder o-rings (25, 27) and cylinder ring (28) prior to installing onto cylinder (24). 31, 32 33, 34, 35, 36, 37, Coat all parts of the trigger