Instrukcja obsługi Life Fitness LS8500

Streszczenie treści zawartej na stronie nr. 1

Stairclimber
ASSEMBLY INSTRUCTIONS

Streszczenie treści zawartej na stronie nr. 2

Congratulations... and welcome to the world of Life Fitness and the Life Fitness 9500HR / 9100 / 8500 Stairclimbers. The following Parts Identification Listing and the step by step assembly procedures have been assembled to make the set-up of the Stairclimber as quick and easy as possible. Please take special note of the following important points prior to choosing a location and beginning assembly of the Stairclimber.

Streszczenie treści zawartej na stronie nr. 3

IMPORTANT SAFETY INSTRUCTIONS! ⇒ DO NOT locate the Stairclimber outdoors, near swimming pools, or in areas of high humidity. ⇒ DO NOT operate your Stairclimber if it has been dropped, damaged, or even partially immersed in water. If this occurs, contact Life Fitness Customer Support Services at the number in the Operation Manual. ⇒ DO NOT locate the Stairclimber any closer than 30 inches ( 76 cm ) to a television set. ⇒ DO NOT locate additional Stairclimber any closer than a minimum of 42 inches

Streszczenie treści zawartej na stronie nr. 4

TOOLS REQUIRED FOR ASSEMBLY... Phillips Screwdriver, Hex Key Wrench, 3/16 Torx Screwdriver, Socket Set PARTS DESCRIPTION 1 Hex Head Bolt Qty: 2 2 Lock Nut Qty: 2 3 Hex Head Bolt Qty: 2 4 Torx Cap Screw Qty: 4 5 Phillips Cap Screw Qty: 8 6 Flat Head Screw Qty: 6 7 Phillips Cap Screw Qty: 4 8 Phillips Cap Screw Qty: 2 9 Display Console Assembly Qty: 1 10 Monocolumn Qty: 1 11 Accessory Tray Qty: 1 12 Upright Handrail Qty: 2 13 Left Bullhorn Handlebar Qty: 1 14 Right Bullhorn Handlebar Qty: 1 ® 15

Streszczenie treści zawartej na stronie nr. 5

B C 1. Before proceeding, familiarize yourself with the parts of the Stairclimber and make sure that you have received all the items described in the Parts List. A 10 2. Locate the MONOCOLUMN (#10). Position the MONOCOLUMN SHROUD (A) onto the MONOCOLUMN as shown. Position the D MONOCOLUMN near the MONOCOLUMN MOUNTING BRACKET (B) as shown. Detach and feed the CONSOLE WIRE HARNESS (C) through the MONOCOLUMN and out through the DISPLAY CONSOLE MOUNTING BRACKET (D) ACCESS HOLE. Pivot the 10 MONOCOLU

Streszczenie treści zawartej na stronie nr. 6

4. (Model 9500HR / 9100) Locate the TELEMETRY CABLE (#17). D 3P Feed the 3-PIN CONNECTOR (3P) end of the cable through the front of the HANDLEBAR ASSEMBLY (#15). The cable must be 15 routed down the HANDLEBAR BRACKET TUBE (F) and back up the top of the MONOCOLUMN (#10). Feed the 3-PIN CONNECTOR through the DISPLAY CONSOLE MOUNTING 10 BRACKET (D) ACCESS HOLE. (Model 9500HR) Locate the HEART RATE CABLE (#18). In similar fashion, feed the 4-PIN CONNECTOR (4P) end of the cable through the front of

Streszczenie treści zawartej na stronie nr. 7

7. Locate the one of the UPRIGHT HANDRAILS (#12). Carefully insert the top of the UPRIGHT HANDRAIL into the user right end of the HANDLEBAR ASSEMBLY (#15). Align the mounting holes. Secure the UPRIGHT HANDRAIL to the HANDLEBAR 15 ASSEMBLY using two MOUNTING SCREWS (#4). Position the 4 bottom of the UPRIGHT HANDRAIL over the mounting hole in the top of the right FRAME LEG (K). Using one HEX HEAD BOLT (#?), mount the UPRIGHT HANDRAIL to the right FRAME LEG as shown. Tighten the BOLT securely. Repe

Streszczenie treści zawartej na stronie nr. 8

PRE-OPERATION CHECKLIST ü Ensure that all fasteners are tight. ü Make sure the Stairclimber is properly leveled and stable. (Refer to the Operation Manual) ü Ensure that the Leveler Jam Nuts are tight. (Refer to the Operation Manual) ü Read the entire Operation manual before using the Stairclimber. LISTE DES VÉRIFICATIONS À EFFECTUER AVANT LA MISE EN MARCHE ü Vérifiez si tous les dispositifs de fixation sont serrés ü Vérifiez si l'APPAREIL D'EXERCICE POLYVALENT est de niveau et stable. (Référez-

Streszczenie treści zawartej na stronie nr. 9

Polar is a registered trademark of Polar Electro, Inc. M051-00K20-A307 4/02