Instrukcja obsługi Impex IGS-06

Streszczenie treści zawartej na stronie nr. 1

NOTE:
Please read all instructions
carefully before using this
product



Table of Content


Safety Notice

IGS-06
Hardware Identifier
CABLE CROSSOVER
Assembly Instruction

Parts List

Warranty

Ordering Parts



Model
IGS-06


Retain This
Manual for
Reference



04-18-02



OWNER'S
IMPEX FITNESS PRODUCTS
MANUAL
14777 DON JULIAN RD., CITY OF INDUSTRY, CA 91746
Tel: (800) 999-8899 Fax: (626) 961-9966
www.impex-fitness.com
info@impex-fitne

Streszczenie treści zawartej na stronie nr. 2

TABLE OF CONTENTS BEFORE YOU BEGIN...................................................................................... 1 IMPORTANT SAFETY NOTICES..................................................................... 2 HARDWARE IDENTIFIER.....…....................................................................... 3 ASSEMBLY INSTRUCTIONS........................................................................... 4 EXPLODED DIAGRAM……………………………………………………………... 8 PARTS LIST………………………………

Streszczenie treści zawartej na stronie nr. 3

IMPORTANT SAFETY NOTICE PRECAUTIONS This exercise machine is built for optimum safety. However, certain precautions apply whenever you operate a piece of exercise equipment. Be sure to read the entire manual before you assemble or operate your machine. In particular, note the following safety precautions: 1. Keep children and pets away from the machine at all times. DO NOT leave children unattended in the same room with the machine. 2. Only one perso

Streszczenie treści zawartej na stronie nr. 4

3

Streszczenie treści zawartej na stronie nr. 5

ASSEMBLY INSTRUCTION Tools Required Assembling the Machine: Adjustable Wrench and Allen Wrench NOTE: It is strongly recommended this machine to be assembled by two or more people to avoid possible injury. STEP 1 (See Diagram 1) A.) Attach a Floor Stabilizer (#6) and a Lower Pivot Bracket (#35) to the Base Frame (#3). Secure it with two M12 x 4” Carriage Bolts (#28), ∅ 1” Washers (#29), and M12 Aircraft Nuts (#30). B.) Insert the Lower Pulley Bracket (#14) into the hole on the

Streszczenie treści zawartej na stronie nr. 6

STEP 2 (See Diagram 2) A.) Attach a Support Frame (#2) to the Floor Stabilizer (#6). Secure it with one Bracket (#16), two M12 x 4” Carriage Bolts (#28), ∅ 1” Washers (#29), and M12 Aircraft Nuts (#30). B.) Insert two Guide Rods (#12) into the holes on top of the Base Frame (#3). Secure each Guide Rod with one M10 x 1” Allen Bolt (#38) and ∅ ¾” Washer (#32) from the bottom. C.) Slide one 1” Thick Rubber Bumper (#22) onto each Guide Rod from top. Note: WD40 or similar lubricant might be

Streszczenie treści zawartej na stronie nr. 7

STEP 3 (See Diagram 3 & Cable Loop Diagram) A.) Attach the horizontal beam on the Crossover Frame (#1) to the top of the two Guide Rods (#12). Note: Help of a second or third person is a must!! Secure the Guide Rods with two M10 x 1” Allen Bolts (#38) and ∅ ¾” Washers (#32). Repeat the same procedure to install the other side. B.) Secure each end of Crossover Frame to each Rear Support Frame (#2) with one Bracket (#16), two M12 x 4” Carriage Bolts (#28), two ∅ 1” Washers (#29), and

Streszczenie treści zawartej na stronie nr. 8

DIAGRAM 3 7

Streszczenie treści zawartej na stronie nr. 9

8

Streszczenie treści zawartej na stronie nr. 10

PARTS LIST KEY NO. DESCRIPTION Q’ty 1 Crossover Frame 1 2 Support Frame 2 3 Base Frame 2 4 Weight Holder 2 5 Guide Rod Sleeve 4 6 Floor Stabilizer 2 7 Allen Bolt 4 8 Small Pulley Bracket 2 9 Large Upper Pulley Bracket 2 10 ∅ 1” x 1 ½” Brass Bushing 2 11 Handle 4 12 Guide Rod 4 13 Olympic Sleeve 4 14 Lower Pulley Bracket 2 15 ∅ 1” x ¾” Brass Bushing 4 16 Bracket 4 17 Chin Up Grip 2 18 6” Pulley 8 19 4 ½” Pulley 2 20 Cable 2 21 M10 x 1” Round Allen Bolt 8 2

Streszczenie treści zawartej na stronie nr. 11

IRON GRIP SPORT By IMPEX FITNESS PRODUCTS LIMITED LIFE TIME WARRANTY IMPEX FITNESS PRODUCTS ("IMPEX") warrants this product to be free from defects in workmanship and material, under normal use and service conditions, for a period of LIFE TIME on the Frame and Weld, 3 YEARS on parts, and 6 MONTHS on upholstery from the date of purchase. This warranty extends only to the original purchaser. IMPEX's obligation under this Warranty is limited to replacing or repairing, at IMPEX's opti