Streszczenie treści zawartej na stronie nr. 1
DO NOT
DISCARD
Owner’s Manual
Installation and Operation
Models:
Dakota 42
Dakota 42H
CAUTION
DO NOT DISCARD THIS MANUAL
• Read, understand • Leave this
• Important operating
and follow these manual with party
and maintenance
instructions for safe responsible for use
instructions included.
installation and and operation.
operation.
WARNING WARNING
HOT! DO NOT TOUCH.
If the information in these instruc-
SEVERE BURNS MAY RESULT.
tions is not followed exactly, a
CLOTHING IGNITION MAY RESULT.
Streszczenie treści zawartej na stronie nr. 2
Read this manual before installing or operating this appliance. Please retain this owner’s manual for future reference. Congratulations Congratulations on selecting a Heat-N-Glo LifeStyle Collection This owner’s manual should be retained for future reference. gas appliance—an elegant and clean alternative to wood We suggest you keep it with your other important documents burning appliances. The Heat-N-Glo LifeStyle Collection gas and product manuals. appliance you have selected is designed to
Streszczenie treści zawartej na stronie nr. 3
Table of Contents 1 Listing and Code Approvals 9 Appliance Setup A. Appliance Certifi cation . . . . . . . . . . . . . . . . . . . . . . . . . 4 A. Remove the Shipping Materials . . . . . . . . . . . . . . . . 15 B. Glass Specifi cations . . . . . . . . . . . . . . . . . . . . . . . . . . 4 B. Clean the Appliance . . . . . . . . . . . . . . . . . . . . . . . . . 15 C. BTU Specifi cations . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 C. Accessories . . . . . . . . . . . . . . . . . . . .
Streszczenie treści zawartej na stronie nr. 4
Listing and Code Approvals 1 A. Appliance Certifi cation C. BTU Specifi cations Maximum Orifi ce Size MODELS: Dakota 42, Dakota 42H Models Input BTUH (DMS) LABORATORY: Underwriters Laboratories, Inc. (UL) Dakota 42 (NG) 61,000 25 TYPE: Vented Gas Appliance Dakota 42 (LP) 52,000 44 STANDARD: ANSI Z21.50-2000—CSA2.22-M00 This product is listed to ANSI standards for “Vented Gas Fireplaces” and applicable sections of “Gas Burning Heating D. High Altitude Installations Appliances for Manuf
Streszczenie treści zawartej na stronie nr. 5
Getting Started 2 2 A. Design and Installation Considerations C. Inspect Appliance and Components Note: This appliance must be installed outside. WARNING Inspect appliance and components for damage. Damaged parts may impair safe operation. CAUTION • Do NOT install damaged components. • Do NOT install incomplete components. Check building codes prior to installation. • Do NOT install substitute components. • Installation MUST comply with local, regional, state and national codes and regu
Streszczenie treści zawartej na stronie nr. 6
Framing and Clearances 3 3 Note: WARNING • Illustrations refl ect typical installations and are FOR DESIGN PURPOSES ONLY. Fire Risk • Illustrations/diagrams are not drawn to scale. Provide adequate clearance: • Actual installation may vary due to individual design • Around air openings. preference. • To combustibles. • For service access. Locate appliance away from traffi c areas. A. Select Appliance Location Note: For actual appliance dimensions refer to When selecting a location for your ap
Streszczenie treści zawartej na stronie nr. 7
Framing Dimensions AB CC in. 24-1/8 43-7/8 49 43-7/8 mm 613 1114 1245 1114 D B Header height. Use only noncombustible C material below the top of the top standoffs. A Figure 3.2 Framing Dimensions B. Clearances C. Mantel Projections Free Standing Installation WARNING Minimum Fire Risk Clearance * Odor Risk • Install appliance on hard metal or wood surfaces extending full width and depth of appliance. • Do NOT install appliance directly on COMBUSTIBLE carpeting, vinyl, tile or any combustibl
Streszczenie treści zawartej na stronie nr. 8
Termination Locations 4 4 A. Vent Termination Minimum Clearances O P G N R FP FP A H D Q (See Note 2) E B L B FP B FP F M FP FP I X FP A J or K X = FIREPLACE OPENING = AIR SUPPLY INLET = AREA WHERE FIREPLACE IS NOT PERMITTED FP A = 0 in. . . . . . . . . . clearances above grade, J = 9 in. (USA) veranda, porch, deck or 12 in. (Canada) . clearance to non-mechanical air balcony. supply inlet to building or the B = 12 in. . . . . . . . . . clearances to window or door combustion air inlet to a
Streszczenie treści zawartej na stronie nr. 9
Appliance Preparation 5 B. Securing and Leveling Appliance CAUTION WARNING Sharp Edges • Wear protective gloves Fire Risk and safety glasses during • Prevent contact with sagging, loose installation. insulation. • Do NOT install against vapor barriers or exposed insulation. A. Remove Logs, Ember Bed and Shipping The diagram shows how to properly position, level, and se- Cover cure the appliance (see Figure 7.3). Nailing tabs are pro- vided to secure the appliance to the framing members.
Streszczenie treści zawartej na stronie nr. 10
Gas Information 6 A. Fuel Conversion C. Gas Connection Before making gas connections ensure appliance being in- stalled is compatible with the available gas type. Note: Have the gas supply line installed in accordance with local building codes, if any. If not, follow ANSI Any natural or propane gas conversions necessary to meet 223.1. Installation should be done by a qualifi ed installer the appliance and locality needs must be made by a quali- approved and/or licensed as required by the l
Streszczenie treści zawartej na stronie nr. 11
D. High Altitude Installations WARNING U.L. listed gas appliances are tested and approved without requiring changes for elevations from 0 to 2000 ft in the USA Fire Risk and Canada. Explosion Risk When installing this appliance at an elevation above 2000 ft, • Gas build-up during line purge may it may be necessary to decrease the input rating by chang- ignite. ing the existing burner orifi ce to a smaller size. Input rate • Purge should be performed by qualifi ed should be reduced by 4% for
Streszczenie treści zawartej na stronie nr. 12
E. Valve Access Figure 6.1 Loosen Refractory Retaining Strip Figure 6.4 Remove Exterior Valve Access Panel • The gas valve can be accessed behind the cement • Use a phillips screwdriver to remove the exterior valve refractory panel on the right side of the fi replace. Use a access panel. phillips screwdriver to remove the two screws securing the refractory retaining strip. Figure 6.2 Lift Out Doors Figure 6.5 Connect Manometer • Lift doors out and set aside. Remove the refractory side • Use a m
Streszczenie treści zawartej na stronie nr. 13
Electrical Information 7 A. Recommendation for Wire C. Intellifi re Ignition System Wiring • This appliance requires two “D” size batteries (3V) supply Note: This appliance must be electrically wired and to the appliance valve for operation. A wiring diagram is grounded in accordance with local codes or, in the absence shown in Figure 7.1. of local codes, with National Electric Code ANSI/NFPA • This appliance is equipped with an Intellifi re control valve 70-latest edition or the Canadian
Streszczenie treści zawartej na stronie nr. 14
Finishing 8 A. Mantel Projections B. Facing Material Figure 8.1 shows the minimum vertical dimension of appli- ance mantels or other combustible projections above the top WARNING front edge of the appliance. Fire Risk Do NOT obstruct air inlet or outlet grilles. Do NOT modify grilles. Free Standing Installation • Modifying or covering grilles could cause Minimum temperature rise and fi re hazard. Clearance * Finishing materials must not interfere with: • Air fl ow through grilles or louvers. •
Streszczenie treści zawartej na stronie nr. 15
Appliance Setup 9 • Raise grate and place ember bed on fl oor of fi rebox (see A. Remove the Shipping Materials Figure 9.1). Ensure ember bed does not cover burner. Remove shipping materials from inside or underneath the • Ensure burner tube is positioned on raised burner fi rebox. supports. B. Clean the Appliance • Ensure grate assembly is over burner assembly ember bed. Center from left to right. Place back legs in grate Clean/vacuum any sawdust that may have accumulated in- brackets (see
Streszczenie treści zawartej na stronie nr. 16
E. Positioning the Logs Figure 9.3 Rear Log Figure 9.6 Left Center Log • Place rear log on the grate against the appliance back • Place the left center log on the grate behind the front left wall. log. Figure 9.4 Front Right Log Figure 9.7 Right Center Log • Place front right log on the grate against the grate front • Place right center log on top of front right log and the rear tines. log. Figure 9.5 Front Left Log • Place front left log on the grate with the left side of the log against the
Streszczenie treści zawartej na stronie nr. 17
F. Glass Assembly G. Grilles and Trim Install optional marble and brass trim surround kits as de- sired. Marble, brass, brick, tile, or other non-combustible materials can be used to cover up the gap between the non- WARNING combustible facing and the appliance. Handle glass with care. Do not obstruct or modify the air inlet/outlet grilles. • Inspect the gasket to ensure it is undamaged. • Inspect the glass for cracks, chips or scratches. • Do NOT strike, slam or scratch glass. • Do NOT opera
Streszczenie treści zawartej na stronie nr. 18
Operating Instructions 10 A. Before Lighting Appliance WARNING Before operating this appliance, have a qualifi ed Improper installation, adjustment, alteration, service or technician: maintenance can cause injury or property damage. Refer • Remove all shipping materials from inside and/or to the owner’s information manual provided with this underneath the fi rebox. appliance. For assistance or additional information consult • Review proper placement of logs, rockwool, lava rock and a qual
Streszczenie treści zawartej na stronie nr. 19
B. Lighting the Appliance Intellifi re Ignition FOR YOUR SAFETY LIGHTING READ BEFORE LIGHTING INSTRUCTIONS WARNING: If you do not follow these instructions 1. Turn off wall switch. exactly, a fi re or explosion may result causing property damage, personal injury or loss of life. 2. This appliance is equipped with an igni- tion device which automatically lights the A. This appliance is equipped with • Do not touch any electric switch; do burner. Do not try to light the burner by an intermitte
Streszczenie treści zawartej na stronie nr. 20
C. After the Appliance is Lit CAUTION Initial Break-in Procedure When you light the appliance, you may notice that it pro- • Prevent accidental appliance operation when not duces heat which does have an associated odor or smell. If attended. you feel this odor is excessive it may require the initial three • Unplug or remove batteries from remote control if to four hour continuous burn on high followed by a second absent or if appliance will not be used for an extended burn up to 12 hours t
