Streszczenie treści zawartej na stronie nr. 1
PELLET AUXILIARY HEATER
INSTALLATION & OPERATION MANUAL
25‐PAH/55‐SHPAH/55‐TRPAH
Manufactured By:
England’s Stove Works, Inc.
PO Box 206
Monroe, VA 24574
REV. 12/2011
CAUTION
Please read this entire manual before installation and use of this pellet fuel‐
burning appliance. Keep children, furniture, fixtures and all combustibles away
from any heating appliance.
SAFETY NOTICE
Failure to follow these instructions can result in proper
Streszczenie treści zawartej na stronie nr. 2
IMPORTANT: IF YOU HAVE A PROBLEM WITH THIS UNIT, DO NOT RETURN IT TO THE DEALER. CONTACT TECHNICAL SUPPORT @ 1‐800‐245‐6489 Mobile Home Use: This freestanding pellet unit is approved for mobile home or doublewide installation with the outside combustion air hook‐ up. See the “Installation” section of this manual for details pertaining to mobile home installations. Mobile home installation must be in accordance with the Manufactured Home and Safety Standard (HUD), CFR 3280, Part 24
Streszczenie treści zawartej na stronie nr. 3
TABLE OF CONTENTS o Cleaning the Burnpot ..... 24 Introduction Monthly Introduction ................................. 4 o Important Notes............. 25 Specifications o Exhaust Chamber ...... 25‐26 Heating Specifications .................. 5 o Venting Pipe ................... 26 Dimensions ................................... 5 Yearly EPA Compliance ........................... 5 o Important Notes............. 27 o Exhaust Blower .............. 28 Installation o Con
Streszczenie treści zawartej na stronie nr. 4
INTRODUCTION Thank you for purchasing this fine product from England’s Stove Works! England’s Stove Works was started, and is still owned by, a family that believes strongly in a “Do It Yourself” spirit; that’s one reason you found this product at your favorite “Do It Yourself” store. We intentionally design and build our stoves so that any homeowner can maintain their unit with basic tools, and we’re always more than happy to show you how to do the job as easily and as inexpensivel
Streszczenie treści zawartej na stronie nr. 5
SPECIFICATIONS Heating Specifications Heat Output Range** ............................................ 11,000 BTU/hr – 25,000 BTU/hr Approximate Pellet Burn Rate** ............................................... 1.6 lb/hr – 4.0 lb/hr Maximum Burn Time** .............................................................................. 72 hours Approximate Square Footage Heated*** ..................................... 800 ‐ 2000 sq. ft. Hopper Capacity ..............................
Streszczenie treści zawartej na stronie nr. 6
INSTALLATION Installation Overview When choosing a location for your new stove, there are a multitude of factors that should be taken into account before beginning the installation. 1. Traffic Patterns – To help prevent accidents, the stove should be placed in a location where it is out of the way of normal travel through the home. 2. Heat Flow – When deciding on a location for the stove, consider the way heat moves throughout your home. Install the stove where you need the heat;
Streszczenie treści zawartej na stronie nr. 7
INSTALLATION Clearances to Combustibles D B C E A C F Unit to Side Unit to Rear Unit to Unit Top to Min. Ceiling Min. Alcove Max. Alcove Wall Wall Corner Ceiling Height Width Depth A B C D E F Not shown 12 in. 6 in. 6 in. 28.5 in. 60 in. 48.25 in. 24 in. 304.8 mm. 152.4 mm. 152.4 mm. 723.9 mm. 1524 mm. 1225.6 mm. 609.6 mm. CAUTION Keep children away. Supervise children in the same room as this appliance. Alert childr
Streszczenie treści zawartej na stronie nr. 8
INSTALLATION Venting Introduction This pellet stove operates on a negative draft system, which pulls combustion air through the burn pot and pushes the exhaust air through the vent pipe and out of the building. This unit must be installed in accordance with the following detailed descriptions of venting techniques; not installing the stove in accordance with the details listed here can result in poor stove performance, property damage, bodily injury or death. England’s Stove Works is n
Streszczenie treści zawartej na stronie nr. 9
INSTALLATION Additional Venting Information Do not mix and match components from different pipe manufacturers when assembling your venting system (i.e. Do NOT use venting pipe from one manufacturer and a thimble from another). We require a minimum vertical rise of 36 in. (3 ft.) of pipe to create natural draft in the system, which helps evacuate smoke from the stove in the event of a power failure or combustion blower failure. Venting systems 15.0 ft. or shorter may be composed
Streszczenie treści zawartej na stronie nr. 10
INSTALLATION Approved Venting Method 1: Through the Wall Generally the simplest installation method, venting through the wall using our AC‐3000 kit (or similar venting system) is also the preferred venting method. It minimizes horizontal pipe, allows the stove to be installed close to the wall and keeps the clean‐out tee on the outside of the house, for ease of cleaning. When installing any venting system, Type L or Type PL pipe must be used and all clearances to combustible
Streszczenie treści zawartej na stronie nr. 11
INSTALLATION Approved Venting Method 2: Through the Ceiling Venting through the ceiling/roof may be the only feasible venting option in some cases and is a factory recommended installation. When installing any venting system, Type L or Type PL pipe must be used and all clearances to combustibles listed by the pipe manufacturer must be strictly adhered to. Use the pipe manufacturer’s approved ceiling support for passing through a combustible ceiling, as well as the required f
Streszczenie treści zawartej na stronie nr. 12
INSTALLATION Approved Venting Method 3: Existing Chimney System Using an existing masonry or factory built chimney for venting is the only other acceptable method for venting this pellet unit. Use Type L or Type PL venting pipe until entering the existing chimney. Use the appropriately sized adapter when transitioning from the pellet vent pipe to the masonry or factory built thimble and be certain that the adapter is sealed tightly to both the pellet venting system and the exist
Streszczenie treści zawartej na stronie nr. 13
INSTALLATION Mobile Home Installation The England’s Stove Works, Inc. outside air kit MUST be used for installation of this unit in a mobile home. Please see the “Outside Air” section on page 14 for more information regarding outside air connections. The outside air inlet must be kept clear of leaves, ice and other debris. Keeping the outside air inlet free of restriction is crucial to preventing air starvation and smoke spillage. The pellet stove MUST be secured to the floor of th
Streszczenie treści zawartej na stronie nr. 14
OUTSIDE AIR HOOK‐UP The use of outside combustion air is mandatory on this pellet stove. The outside air connection pipe protrudes from the lower rear center of the stove; use the included outside air kit to attach your stove to outside combustion air. Instructions and all the parts needed to make the outside air connection to your pellet stove are included with the outside air kit. If it is not feasible to use the included outside air hookup kit in your stove installation, other
Streszczenie treści zawartej na stronie nr. 15
FLOOR PROTECTION This pellet stove requires a non‐combustible floor protector if the stove is to be installed on a combustible floor. If the floor the stove is to be installed on is already non‐combustible (i.e. a concrete floor in a basement) and has an R value equal to or higher than .2, no floor protection is needed (although a decorative floor protector can still be used for aesthetic reasons). Prefabricated floor protectors which are UL listed or equivalent can be purchased or
Streszczenie treści zawartej na stronie nr. 16
DAILY OPERATION Getting Started Check to see that the hopper is clean and free from foreign materials. Be sure to connect this unit to a working outlet; we recommend using a surge protector to help protect the electronic components from damage. BEFORE your first fire, dry run your unit (no pellet fuel in the hopper) for twenty minutes; pressing the “ON” button with the unit plugged in will initiate the dry run. o Once the “ON” button is pressed, you should immediately hear the ex
Streszczenie treści zawartej na stronie nr. 17
Shortly after pressing the “On” button, the letters “S U” will appear in the heat range and blower speed windows of the control board. This indicates the stove has entered the start‐ up sequence and is operating normally. The fuel feed rate and combustion air during start‐up is determined by the control board, so the stove may be started on any heat range. After approximately fifteen minutes, the fire should be burning brightly and the “S U” should disappear from the control board.
Streszczenie treści zawartej na stronie nr. 18
CONTROL BOARD SETTINGS The control board on this stove allows the user to adjust the heat output and convection blower speed, turn the unit on and off, and test components for function (more on diagnostic mode later). The lower buttons on the control board (Low Fuel Feed, Low Burn Air, and Air on Temp) are not meant to be adjusted during normal operation of the unit. These buttons are factory preset and can not be adjusted by the user. To energize the unit and initiate a fire, press
Streszczenie treści zawartej na stronie nr. 19
ERROR CODES Error codes, or “E‐Codes,” are alphanumeric codes that will appear in the Heat Range and Blower Speed windows of the Control Board if the unit experiences an abnormal condition. Error codes are the control board’s way of telling the user that something isn’t operating correctly within the stove, and that the unit should be carefully inspected before reigniting. See the “Trouble‐Shooting Guide,” page 30, for additional information on error codes. E‐0 When this is displaye
Streszczenie treści zawartej na stronie nr. 20
POWER FAILURE If the power to the unit is interrupted for approximately three minutes or less, the unit will resume operation when power is restored according to the following table: Unit’s State Before Power Loss State When Power Returns ON Start‐Up Start‐Up Start‐Up Shut‐Down Shut‐Down OFF OFF If the power is interrupted for more than (approximately) three minutes, the unit will be “OFF” when power returns. IMPORTANT – Do NOT open the hopper lid or the door to the unit d
