Streszczenie treści zawartej na stronie nr. 1
Safe Operation Practices • Set-Up • Operation • Maintenance • Service • Troubleshooting • Warranty
Otreap Or ’s Mlauna
Jet Sweep Blower — JS1150
WARNING
READ AND FOLLOW ALL SAFETY RULES AND INSTRUCTIONS IN THIS MANUAL
BEFORE ATTEMPTING TO OPERATE THIS MACHINE.
FAILURE TO COMPLY WITH THESE INSTRUCTIONS MAY RESULT IN PERSONAL INJURY.
CUB CADET LLC, P.O. BOX 361131 CLEVELAND, OHIO 44136-0019
Printed In USA Form No. 769-06237
(July 1, 2010)
Streszczenie treści zawartej na stronie nr. 2
To The Owner 1 Thank You Thank you for purchasing a Cub Cadet Jet Sweep Blower. It was If you have any problems or questions concerning the machine, carefully engineered to provide excellent performance when phone your local Cub Cadet dealer or contact us directly. Cub properly operated and maintained. Cadet’s Customer Support telephone numbers, website address and mailing address can be found on this page. We want to Please read this entire manual prior to operating the equipment. ensur
Streszczenie treści zawartej na stronie nr. 3
Important Safe Operation Practices 2 WARNING! This symbol points out important safety instructions which, if not followed, could endanger the personal safety and/or property of yourself and others. Read and follow all instructions in this manual before attempting to operate this machine. Failure to comply with these instructions may result in personal injury. When you see this symbol. HEED ITS WARNING! CALIFORNIA PROPOSITION 65 WARNING! Engine Exhaust, some of its constituents, and certain v
Streszczenie treści zawartej na stronie nr. 4
13. If your machine should start making an unusual noise or 4. Remove gas-powered equipment from the truck or vibration, immediately stop the engine, disconnect the trailer and refuel it on the ground. If this is not possible, spark plug wire and move the wire away from the spark then refuel such equipment on a trailer with a portable plug. Allow the machine to stop and perform the following container, rather than from a gasoline dispenser nozzle. steps: 5. Keep the nozzle in contact with the
Streszczenie treści zawartej na stronie nr. 5
11. According to the Consumer Products Safety Commission Spark Arrestor (CPSC) and the U.S. Environmental Protection Agency (EPA), this product has an Average Useful Life of seven (7) years, WARNING! This machine is equipped with an or 70 hours of operation. At the end of the Average Useful internal combustion engine and should not be used Life have the machine inspected annually by an authorized on or near any unimproved forest-covered, brush- service dealer to ensure that all mechanical a
Streszczenie treści zawartej na stronie nr. 6
Assembly & Set-Up 3 Contents of Crate • One Jet Sweep Blower • One Upper Handle • One Chute Attachment • One Jet Sweep Blower Operator’s • One Engine Operator’s Manual Manual NOTE: All references to the left or right side of the jet sweep 2. Place the upper over the lower handle, aligning the upper blower are from the operator’s position. Any exceptions will be holes/metal tabs in the upper handle with the upper holes/ noted. lower holes in the lower handle. See Fig. 3-2. Assembly Attaching th
Streszczenie treści zawartej na stronie nr. 7
Attaching the Chute Attachment Set-Up WARNING! DO NOT operate without shields and Adding Fuel guards (e.g., discharge chute, air intake guard) in Refer to the Engine Operator’s Manual packed with your jet place. sweep for information on adding fuel. To redirect airflow at a 90 degree angle during operation, a chute WARNING! Use extreme care when handling attachment is included with your jet sweep blower. gasoline. Gasoline is extremely flammable and the vapors are explosive. Never fuel
Streszczenie treści zawartej na stronie nr. 8
Controls & Features 4 Blower Housing Blower Direction Lever Discharge Chute Figure 4-1 Jet Sweep Blower controls and features are illustrated in Fig 4-1 Blower Direction Lever and described below. AIR FLOW The air flow can be directed to one WARNING! Read and follow all safety rules and UP of three directions using the blower instructions in this manual, including the entire direction lever to reposition the Operation section, before attempting to operate louvers. this machine. Failure to
Streszczenie treści zawartej na stronie nr. 9
Operation 5 Starting & Stopping the Engine Refer to the Engine Operator’s Manual for instructions on starting and stopping the engine. Adjusting the Blower Direction The air flow can be directed to one of three directions using the blower direction lever to move the louvers. NOTE: The blower direction lever must be in the middle position when operating the blower with the chute attachment to keep it locked in place. 1. Pull the lever out and away from the blower. See Fig. 5-1. B A Blower Di
Streszczenie treści zawartej na stronie nr. 10
Maintenance & Adjustments 6 Maintenance WARNING! Before performing any maintenance or repairs always stop engine. Engine Refer to the Engine Operator’s Manual for all engine maintenance procedures and instructions. Cleaning the Blower Any fuel or oil spilled on the machine should be wiped off promptly. Do NOT allow debris to accumulate around the cooling fins of the engine, the fan intake area or on any other part of the machine. WARNING! If the engine has been recently run, the engine,
Streszczenie treści zawartej na stronie nr. 11
Replacement Parts 7 Component Part Number and Description 951-10292 Spark Plug 951-10794 Air Filter 951-10652 Fuel Filter 734-04278 Wheel, 8.0 x 3.0 941-0706 Flange Bearing, .635 734-04279 Wheel (Rear) 951-10649 Fuel Tank Cap 631-04253 Discharge Chute w/ Label 781-04175 Discharge Chute Base 710-04373A Discharge Chute Screws (3x) 720-04091 Foam Grip Phone (800) 828-5500 or (330) 558-7220 to order replacement parts or a complete Parts Manual (have your full model number and serial number ready
Streszczenie treści zawartej na stronie nr. 12
CUB CADET LLC MANUFACTURER’S LIMITED WARRANTY FOR LOG SPLITTERS & JET SWEEPS The limited warranty set forth below is given by Cub Cadet LLC with c. Cub Cadet does not extend any warranty for products sold or respect to new merchandise purchased and used in the United States, exported outside of the United States and/or Canada, and their its possessions and territories, and by MTD Products Limited with respective possessions and territories, except those sold through respect to new merchandi
