Instrukcja obsługi Oricom WNS1

Streszczenie treści zawartej na stronie nr. 1

Oricom WNS1

Jumbo Display
Alarm Clock and Shaker



User Guide


Keep this user guide for future reference

Streszczenie treści zawartej na stronie nr. 2

WARNINGS WARNINGS Before installing or changing the battery make sure that the telephone is not connected to the telephone network or the mains power supply. When inserting batteries into this product, observe the proper polarity or direction, failure may result in leakage or explosion. Remove the batteries from this product if it will not be used for a long time (several months or more) since during this time the batteries could leak. Batteries must be disposed of in ac

Streszczenie treści zawartej na stronie nr. 3

LOCATION OF CONTROLS PM 1 AL 2 3 1 – PM LED indicator 2 – Alarm LED indicator 3 – Strobe light and snooze button 9 8 1 2 7 3 6 4 5 1 – Alarm mode switch 6 – Alarm off 2 – Alarm and ring volume 7 – Alarm tone 3 – Set alarm 8 – Alarm + ring / Off / Ring function switch 4 – Set clock 9 – Shaker Lo / Hi switch 5 – Set hours & minutes - 3 -

Streszczenie treści zawartej na stronie nr. 4

INITIAL SETUP PACK CONTENTS Unpack the unit and check to be sure you have all the items below. • 1 Jumbo display /alarm clock (WNS1) • 1 modular line Cord • 1 Double adaptor plug • 1 Shaker • 1 Warranty Card • This User guide Battery Door 4 1 AC Adaptor Double Adaptor Phone Wall socket 3 Shaker Dimmer switch 2 INITIAL SET UP - Connect one end of the phone line cord to the back of the unit (1) and the other end to the double adaptor plug.

Streszczenie treści zawartej na stronie nr. 5

ALARM AND CLOCK FUNCTION SETTING THE TIME ( ) - Press and hold (set clock) button. - Press H (hour) and M (minute) until correct hour and minutes appear on the display. - Release (set clock) button. - For p.m. hours, the p.m. indicator will appear on the display near the inscription PM. SETTING THE ALARM TIME ( ) - Press and hold (set alarm) button. - Press H (hour) or M (minute) until correct hour and minutes appear on the display. - Relea

Streszczenie treści zawartej na stronie nr. 6

RINGER ON/OFF SWITCH (A+T / OFF / T) - A+T (alarm + telephone): for the alarm and telephone ring position. - OFF: alarm and ring off. - T (telephone): for the telephone ring position. HOW TO USE WITH YOUR TELEPHONE - Ensure that your telephone is connected to the WNS1 as shown in the installation section. - Select the ringer On/Off switch on the A+T or T position for the ring. - Choose which of the alarm modes you wish to alert you of your incoming telephone calls (see page

Streszczenie treści zawartej na stronie nr. 7

CARE & WARRANTY CLEANING The surface of the case can be cleaned with a dry, soft, lint-free cloth. Never use cleaning agents, particularly aggressive solvents. Apart from occasional cleaning of the case, no other care is necessary. The rubber feet on the base are not resistant to all cleaning agents. The rubber feet do not normally leave any marks on the surface. However, on account of the multitude of varnishes and surface finishes used, surface marks caused by the feet of the uni