Instrukcja obsługi American Standard 2703.XXXW Series

Streszczenie treści zawartej na stronie nr. 1

ELLISSE BUILT-IN™
2703.XXXW
2705.XXXW
SERIES WHIRLPOOL
HIGH GLOSS ACRYLIC
SHOWN LESS ALL FITTINGS
INSTALLATION INSTRUCTIONS
THANK YOU...
for selecting an American Standard bath. Your new
1524mm
(60)
bath is shipped to you after careful inspection. The
229mm
WATER RETENTION
SEE FITTING (9)
FLANGE (3) SIDES whirlpool version is completely assembled with pump,
SPECS FOR
FINISHED
19mm
DIMENSION motor, and system piping. All you need to finish the
WALL LINE
(3/4)
installation are your selec

Streszczenie treści zawartej na stronie nr. 2

FRAMING AND INSTALLATION BATH MAY ONLY BE INSTALLED ABOVE THE FLOOR LINE IN A RECESS TYPE INSTALLATION, AS SHOWN IN RECESS INSTALLATION DIAGRAM. THE FOLLOWING PROCEDURE MUST BE USED FOR ALL INSTALLATIONS: STRINGER OR PIER HEIGHT SHOULD BE AS INDICATED. THE SUMP OF THE BATH IS SUPPORTED BY INTEGRAL FEET AND NO ADDITIONAL SUMP SUPPORT IS REQUIRED. ONCE THE BATH IS IN PLACE, THE FEET SHOULD BE SHIMMED ACCORDINGLY, SO THAT THE RIM OF THE BATH CONTACTS THE STRINGER OR PIER BUT SUPPORTS NO WEIGHT

Streszczenie treści zawartej na stronie nr. 3

ELECTRICAL INSTALLATION INSTRUCTIONS All wiring must be performed by a licensed electrician in accordance with the national electrical code and all other applicable codes. WARNING: When using electrical products, basic precautions should always be observed, including the following: 1. DANGER: RISK OF ELECTRIC SHOCK Connect only to a circuit protected by a ground-fault circuit interrupter. 2. Grounding is required. The unit should be installed by a licensed electrician and grounded. 3. Install

Streszczenie treści zawartej na stronie nr. 4

WIRE SELECTION GUIDE Maximum distance from Motor The sizes shown on this fusebox to motor Hi-Performance chart are recommendations Rating 50' 100' 150' 200' for copper conductors only. Always follow 120V Power Line local and national electrical codes 1.6 12 12 10 8 2.1 10 8 8 12 DRAIN CONNECTION AND SYSTEM TEST Using recommended drain opening, connect whirlpool drain to waste line. Tighten all drain joints securely. Check the pump couplings and make sure they are hand-tight. Clean the whir