Streszczenie treści zawartej na stronie nr. 1
Marlborough & Stockton
Log Effect Stove Range
Conventional Flue
With upgradeable control valve
Instructions for Use,
Installation and Servicing
For use in GB, IE (Great Britain and Eire)
This appliance has been certified for use in countries other than those stated. To install this appliance in these countries, it is essential to obtain the
translated instructions and in some cases the appliance will require modification. Contact Gazco for further information.
IMPORTANT
Do not attempt to burn ru
Streszczenie treści zawartej na stronie nr. 2
CONTENTS COVERING THE FOLLOWING MODELS MARLBOROUGH – 8610LUC – P8610LUC STOCKTON – 8617LUC – P8617LUC PAGE APPLIANCE COMMISIONING CHECKLIST 3 USER INSTRUCTIONS 4 INSTALLATION INSTRUCTIONS 8 Technical Specifications 8 Site Requirements 9 Installation 10 Commissioning 14 SERVICING INSTRUCTIONS 15 Servicing Requirements 15 Fault Finding 15 How to replace parts 17 Basic spare parts list 21 Service Record 22 2
Streszczenie treści zawartej na stronie nr. 3
APPLIANCE COMMISSIONING CHECKLIST IMPORTANT NOTICE Explain the operation of the appliance to the end user, hand the completed instructions to them for safe keeping, as the information will be required when making any guaranteed claims. FLUE CHECK PASS FAIL 1. Flue is correct for appliance 2. Flue flow test 3. Spillage test GAS CHECK 1. Gas soundness & let by test 2. Standing pressure test mb 3. Appliance working pressure (on High Setting) mb NB All other gas appliances must be operating on full
Streszczenie treści zawartej na stronie nr. 4
USER INSTRUCTIONS with your local Gazco dealer if you have any questions. In 1. GENERAL all correspondence always quote the Model No. and Serial No. Please ensure the commissioning checklist is completed by your installer, as this is a requirement of your Guarantee. 1.1 Installation and servicing must be carried out by a competent person in accordance with Gas Safety (Installation and Use) Regulations 1998, the relevant British Standards for 2. LIGHTING THE STOVE Installation, appropriate Codes
Streszczenie treści zawartej na stronie nr. 5
USER INSTRUCTIONS 3. TURNING OFF THE STOVE 6. CLEANING THE FIRE 3.1 To turn the stove off, locate the control valve, turn the left- WARNING: DO NOT ATTEMPT TO CLEAN THE hand control knob until it points to off ( ). The main burner STOVE UNTIL IN A COLD CONDITION. THE will go out leaving the pilot burning. STOVE RETAINS ITS HEAT FOR A CONSIDERABLE TIME AFTER SHUTDOWN. 3.2 To turn the pilot off, locate the control valve, turn the right- hand control knob until it points to off ( ), the pilot will
Streszczenie treści zawartej na stronie nr. 6
USER INSTRUCTIONS 7.2 Place log B on the left-hand side of the burner with the 7 location bar on the underside of the log fully located in the long slot of the burner. Make sure the log is as far to the left as possible. See diagram 4. 4 AR1614 7.6 Place the second ash panel to the right of the first, with the pointed end of the panel fitting into the V shape. This panel AR1611 should locate on the screw holes of the burner skin. Ensure that both logs are horizontal to the burner ports. 7.3 Plac
Streszczenie treści zawartej na stronie nr. 7
USER INSTRUCTIONS 7.8 Carefully insert the front coal retainer into the front panel of 10. ‘RUNNING IN’ the firebox. Take care not the scrape/damage the logs. This coal retainer sits in two brackets. Ensure it is fully inserted, leaving approximately a 4 mm gap between the firebox 10.1 The surface coating on your GAZCO fires will "burn off" ledge and the bottom of the coal retainer. during the first 24 hours of use, producing a harmless and temporary odour. This will disappear after the short pe
Streszczenie treści zawartej na stronie nr. 8
INSTALLATION INSTRUCTIONS TECHNICAL SPECIFICATION COVERING THE FOLLOWING MODELS: MARLBOROUGH – 8610LUC – P8610LUC STOCKTON – 8617LUC – P8617LUC Model Gas Gas Working NOX Aeration Injector Gas Rate Input kW (Gross) Country 3 CAT. Type Pressure Class m /h High Low Marlborough 8610LUC I Natural 20 mbar 3 Ø 14.5 375 0.623 6.6 3.6 GB, IE 2H (G20) Gross Gross Marlborough P8610LUC I Propane 37 mbar 3 Ø 11.5 x 2 165 0.232 6.4 3.6 GB, IE 3P (G31) Gross Gross Stockton – 8617LUC I Natural 20mbar 3 Ø 14.5 3
Streszczenie treści zawartej na stronie nr. 9
INSTALLATION INSTRUCTIONS SITE REQUIREMENTS 1. FLUE AND CHIMNEY REQUIREMENTS 4. APPLIANCE LOCATION 1.1 The chimney or flue system must comply with the rules in 4.1 This fire must stand on a non-combustible hearth that is at force and must be a minimum of 127mm in diameter. (5"). least 12mm thick and projects 50mm minimum from the base of the fire in all directions. 1.2 The minimum effect height of the flue or chimney must be 3 metres (10ft). Any horizontal flue run from the rear outlet 4.2 Do no
Streszczenie treści zawartej na stronie nr. 10
INSTALLATION INSTRUCTIONS INSTALLATION allowed before trying to relight. Continued operation of this IMPORTANT: ENSURE THAT THE APPLIANCE IS safety device means that there may be a serious problem CORRECTLY ADJUSTED FOR THE GAS TYPE AND with the flue system; a qualified gas engineer should inspect CATEGORY APPLICABLE IN THE COUNTRY OF this. DO NOT USE THE STOVE UNTIL AN ENGINEER SAYS USE. REFER TO DATABADGE AND TECHNICAL IT IS SAFE TO DO SO. SPECIFICATIONS OF THIS BOOKLET. FOR DETAILS OF CHANGIN
Streszczenie treści zawartej na stronie nr. 11
INSTALLATION INSTRUCTIONS INSTALLATION in and around the appliance before and after working on it. When servicing the appliance it is recommended that the 3.6 The flue system may now be connected to the stove. Ensure replaced items are not broken up, but are sealed within that all joints are sealed with a suitable fire resistant sealant. heavy duty polythene bags and labelled as RCF waste. It is also recommended that a physical retention method be used at the flue spigot joint, self-tapping scre
Streszczenie treści zawartej na stronie nr. 12
INSTALLATION INSTRUCTIONS INSTALLATION 8 5.3 Place log C on the right-hand side of the burner with the location bar on the underside of the log fully located in the long slot in the burner. Make sure the log is as far right as possible. See diagram 5. 5 AR1615 5.7 Place log E across from the rear of log A to log C on the right-hand side. Again, there are cut-outs for location. The front of the log should sit on the front ash panels and should AR1612 fit tight to log C. See diagram 9. 9 5.4 Place
Streszczenie treści zawartej na stronie nr. 13
INSTALLATION INSTRUCTIONS INSTALLATION 5.9 Ensure that the fibreglass seal on the back of the door is intact, locate the door on the four studs and slide back to the firebox. Secure in place using the four dome nuts and tool supplied, do not overtigthen the nuts, see diagram 11. 11 AR0390 NEVER OPERATE THE STOVE WHEN THE DOOR IS REMOVED OR WHEN THE GLASS IS BROKEN. 6. LIGHTING 6.1 Full instructions are given in the User section under Lighting the Stove. 13
Streszczenie treści zawartej na stronie nr. 14
INSTALLATION INSTRUCTIONS COMMISSIONING 1. COMMISSIONING 1.1 Close all openable doors and windows in the room, ignite the stove and operate on maximum for 10 minutes. Remove the plastic sight plug from the right-hand side of the stove. Position a lighted smoke match just inside the draught diverter opening and check that all smoke is drawn into the opening by viewing through the sight hole. See diagram 1. If there is any doubt, run the stove for a further 10 minutes and repeat the test. 1 AR1493
Streszczenie treści zawartej na stronie nr. 15
SERVICING INSTRUCTIONS SERVICING / FAULT FINDING CHARTS 1.4 Correct any faults found during the initial tests and then 1. SERVICING REQUIREMENTS recommission the appliance conducting the usual safety checks. 1.5 Advise the customer of any remedial action taken. This appliance must be serviced at least once a year by a competent person. 1 All tests must be serviced by best practice as described by the current CORGI recommendations. 1.1 Before any tests are undertaken on the appliance, conduct a g
Streszczenie treści zawartej na stronie nr. 16
SERVICING INSTRUCTIONS SERVICING / FAULT FINDING CHARTS 16 FLAME FAILURE FUNCTIONAL CHECK 3 IGNITION FUNCTIONAL CHECK 2 PILOT WILL NOT STAY LIT OR FIRE GOES OUT IN USE NO SPARK Ensure there is no debris around the pilot assembly, (e.g. coal, soot Ensure there is no debris around the pilot assembly, (e.g. coal, soot etc.) which could short the spark, clear the area. etc.) which could short the spark, clear the area. From Ignition Fault Finding Consult the Users Instructions, Light the pilot and k
Streszczenie treści zawartej na stronie nr. 17
SERVICING INSTRUCTIONS REPLACING PARTS 3.3 Remove the main burner. See Section 2 above. 1. GENERAL 3.4 Remove the two fixing screws from the pilot bracket. See Diagram 2. Gently draw the assembly away from the firebox to give access to the nuts and ignition lead. 1.1 All principal components can be replaced without removing the stove from its installation, although it is essential that the gas supply to the appliance is turned off at the isolation 2 device before proceeding further. 2. MAIN BURN
Streszczenie treści zawartej na stronie nr. 18
SERVICING INSTRUCTIONS REPLACING PARTS 3.7 To remove the thermocouple, undo the retaining nut and 4.3 To release the right-hand side of the control cover insert the withdraw the thermocouple. Undo the thermocouple from narrow blade screwdriver into the slot shown in diagram 8. the back of the gas valve. See Diagrams 5 and 6. Reassemble Lever it gently and pull from the right-hand side at the same in reverse order. Do not overtighten. time. The cover will now come off. There is a small cylindrica
Streszczenie treści zawartej na stronie nr. 19
SERVICING INSTRUCTIONS REPLACING PARTS 6.6 Check all joints for gas leaks. Check the operation of the 12 thermocouple and ignition lead. 10 AR0618 AR0943b 8.4 Holding the injector with a spanner, undo the feed pipe. NOTE: THE ORIENTATION OF THE INJECTOR. 8.5 Reassemble in reverse order. Turn on the gas supply and check for any leaks. 7. MAGNETIC SAFETY VALVE 9. GAZCO FLUE SURE SYSTEM 7.1 Turn the gas supply off at the isolation device. Undo the thermocouple connection from the back of the gas v
Streszczenie treści zawartej na stronie nr. 20
SERVICING INSTRUCTIONS REPLACING PARTS 9.3 Undo the two screws at the back of the firebox and carefully withdraw the bracket. 18 15 AR1448 AR1447 AR1607 10. PRIMARY AERATION PLATE 9.4 Disconnect the two slender wires. Undo the two taptite screws and remove the sensor and the two plastic spacers. 10.1 Turn the gas supply off at the isolation device. See diagram 16. 10.2 Refer to Section 2 to remove the main burner. 16 10.3 Remove the two screws on the burner skin to detach the venturi cover from
