Streszczenie treści zawartej na stronie nr. 1
INSTALLATION AND
OPERA TION INSTRUCTIONS
STANDARD SERIES
Unvented Decorative Gas Fireplaces
P/N 903302, REV . N , 04/2010
MODELS
VF5000-CMN-2 VF6000-CMN-2
VF5000-CMP-2 VF6000-CMP-2
FOR USE ONL Y WITH DECORA TIVE TYPE
UNVENTED ROOM HEA TERS.
DO NOT BUILD A WOOD FIRE.
W ARNING: IMPROPER INST ALLA TION, ADJUSTMENT ,
AL TERA TION, SERVICE OR MAINTENANCE CAN CAUSE
Portland
INJUR Y OR PROPER TY DAMAGE. REFER TO THIS MANUAL.
US FOR ASSIST ANCE OR ADDITIONAL INF
Streszczenie treści zawartej na stronie nr. 2
These heaters are manually controlled. Square TABLE OF CONTENTS Piping complying with local codes A spark ignition system (piezo) allows the heater General Information ......................... page 2 Pipe wrench pilot gas to be lit without the use of matches or Tee joint Inventory ......................................... page 2 batteries and permits operation of the heater Pipe compound Tools and Building Supplies ............ page 2 during a power outage. Installation Applications ...........
Streszczenie treści zawartej na stronie nr. 3
• The installation must conform with local Massachusetts: WARNING: ANY CHANGE TO THIS UN- codes or, in the absence of local codes with the These fireplaces are approved for installation VENTED ROOM HEATER OR ITS CON- National Fuel Gas Code, ANSI Z223.1. in the US state of Massachusetts if the follow- TROLS CAN BE DANGEROUS. IMPROPER ing additional requirements are met- INSTALLATION OR USE OF THIS HEATER • The heater and its individual shut-off valve must be disconnected from the gas supply • Ins
Streszczenie treści zawartej na stronie nr. 4
Unusually tight construction is defined as con- 4. Compare the maximum BTU/Hr the space LOCATION OF FIREPLACE struction where: can support with the actual amount of BTU/ Hr used. Carefully select the best location for installation a. wall and ceilings exposed to the outside of your VF5000 and VF6000 series Unvented _________ BTU/Hr atmosphere have a continuous water vapor Room Heater. The following factors should be (max. the space can support) retarder with a rating or one perm or less with tak
Streszczenie treści zawartej na stronie nr. 5
To provide for the lowest possible shelf sur- Combustible Remove wood slats and remove and discard Finished Wall face, combustible materials used to support a the wood slat mount brackets. Loosen and Materials utility shelf directly above these appliances remove the three (3) 1/4"-20 x 1" Phillips pan 12" ( mm) should be positioned just above the appliance head screws at the three (3) tabs located along top spacers. The minimum height from the the door frame top edge. Tilt the glass door 10'' b
Streszczenie treści zawartej na stronie nr. 6
Note: Framing dimensions in Figures 4 - 9 are calculated for a nailing flange depth of ¹⁄₂" (13 mm). INSTALLATION STEPS Built-In Systems Back Wall of Back Wall of WARNING: DO NOT ALLOW FANS TO Chase/Enclosure Chase/Enclosure Including Finishing Including Finishing BLOW DIRECTLY INTO THE FIREPLACE. Outside Wall Outside Wall Materials If Any. Materials If Any. AVOID ANY DRAFTS THAT ALTER BURNER FLAME PATTERNS. 15 1/2" 19 1/2" (394mm) (495mm) WARNING: DO NOT USE A BLOWER IN- SERT, HEAT EXCHANGER IN
Streszczenie treści zawartej na stronie nr. 7
B. Brush all joints and connections with the Gas Flex Line Kit, Model GFLV gas leak test solution to check for leaks. If bubbles are formed, or gas odor is detected, 3/8" NPT x 3/8" 1/2" x 3/8" Flare Flare Fitting turn the gas control knob to the “OFF” posi- Gas Valve Shut-Off Valve tion. Either tighten or refasten the leaking connection and retest as described above. C. When the gas lines are tested and leak free, 3/8" Flex Tubing be sure to rinse off the leak testing solution. D. When the gas
Streszczenie treści zawartej na stronie nr. 8
IMPORTANT: Ground lead must be connected VF5000/VF6000 Series VF5000/VF6000 Series Standard Wiring Diagram to the green screw located on the junction box Optional Wiring Diagram cover plate. Failure to do so will prevent the If any of the original wire as supplied must be replaced, it If any of the original wire as supplied must be replaced, it must be replaced with Type AWM 105°C – 18 GA. wire. must be replaced with Type AWM 105°C – 18 GA. wire. appliance from operating. The appliance must From
Streszczenie treści zawartej na stronie nr. 9
Step 8. Position Heater – Place the heater in WARNING: DO NOT PLACE ANY LAVA WARNING: FAILURE TO POSITION THE desired location. It may be helpful to tempo- ROCK ON LOGS OR BURNERS. THIS MAY PARTS IN ACCORDANCE WITH THESE rarily assemble the surround around the appli- CAUSE SOOTING. DIAGRAMS OR FAILURE TO USE ONLY ance to properly locate the unit. Refer to Figure 16 for floor and platform installations. PARTS SPECIFICALLY APPROVED WITH Step 13. The heater includes a unitized set of If the heater
Streszczenie treści zawartej na stronie nr. 10
In normal operation, at full rate, after 15 min- The pilot flame should be steady, not lifting or OPTIONAL EQUIPMENT utes the following flame appearance should be floating. Flame should be blue in color with observed: traces of orange at the outer edge. An incomparable package of options are avail- able for use with these appliances. These op- The top 3/8" (10 mm) at the pilot generator Rear Burner Flame Characteristics – The tions can both customize the operation of these rear flames should be
Streszczenie treści zawartej na stronie nr. 11
Decorative Volcanic Stone Screen Panel Kit Blower Motor The decorative volcanic stone, Model FDVS, An optional screen panel can be installed on the can be used to enhance the look of your appli- VF5000/VF6000 Series Units. This screen panel ance. Spread the decorative volcanic stone is easy to install. This kit can be retrofitted to Grounded evenly around the bottom of the firebox. previously installed VF5000/VF6000 appliances. to Appliance Refractory Liner Kit One Piece Arch Kit Motor Plug One
Streszczenie treści zawartej na stronie nr. 12
OPERATION AND CARE OF YOUR CLEANING AND SERVICING ACCESSORIES AND COMPONENTS APPLIANCE WARNING: TURN OFF THE UNVENTED 1. Appliance operation may be controlled GAS ROOM HEATER AND ALLOW TO through the optional ON/OFF unit rocker switch, COOL BEFORE CLEANING. located in the lower control compartment, or through a remotely located optional wall switch or wall thermostat. Separate switches may Only limited cleaning will be required under the provide independent control for the forced air normal use
Streszczenie treści zawartej na stronie nr. 13
ACCESSORIES AND COMPONENTS VF5-BRLK VF5-PBH VF5RLK Brass Louver Kits VF6-BRLK Brass Hood Kit VF6-PBH Refractory Liner Kit VF6RLK DAT-5-1 Gas Flex Line Kit FFGC 2-Piece Decorative DAT-5-4 Arch Frame Kits DAT-6-1 VF5GDK Glass Door Panel VF6GDK Wood Surround-Wall SUR-5PW BSK-5 BSK-6 Thermostat WTK Brass Square STK-6-4 Surround Kits STK-5-4 Decorative Volcanic Stone FDVS Wood Surround-Corner SUR-5PC NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE. 13
Streszczenie treści zawartej na stronie nr. 14
VF5000 SPECIFICATIONS VF6000 SPECIFICATIONS 42-1/8" 37" (1070 mm) (940 mm) 36-7/8" 31-1/2" 15" 20" (800 mm) (937 mm) (508 mm) (381 mm) 30" (762 mm) 34" (864 mm) 40" (1016 mm) 36" (914 mm) Front View Front View 5-1/2" 5-1/2" (140 mm) (140 mm) 1/2" 1/2" (13 mm) (13 mm) 36-7/8" 42-1/8" 37" (937 mm) (1070 mm) 31-1/2" (940 mm) (800 mm) 3-3/4" 3-3/4" (95 mm) 11" (95 mm) (279 mm) 8" J Box J Box Gas Line (203 mm) Gas Line Opening Opening Opening Opening (Left Side Only) (Left Side Only) 3-1/2" 3" 3-1/2"
Streszczenie treści zawartej na stronie nr. 15
TROUBLESHOOTING GUIDE FOR UNVENTED GAS PRODUCTS OBSERVED PROBLEM POSSIBLE CAUSE REMEDY 1. When igniter button is A. Igniter electrode positioned wrong. Replace igniter. pressed, there is no spark at ODS/pilot. B. Igniter electrode broken. Replace igniter. C. Igniter electrode not connected to igniter cable. Reconnect igniter cable. D. Igniter cable pinched or wet. Free igniter cable if pinched by any metal or tubing. Keep igniter cable dry. E. Piezo igniter nut is loose. Tighten nut. F. Broken i
Streszczenie treści zawartej na stronie nr. 16
T O O O L I P O N O L T N LIGHTING INSTRUCTIONS – MILLIVOLT FOR YOUR SAFETY READ BEFORE LIGHTING WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. A. This appliance has a pilot which must be lighted by hand. • Do not use any phone in your building. When lighting the pilot, follow these instructions exactly. • Immediately call your gas supplier from a neighbor’s phone. • If your gas supplier cannot b
Streszczenie treści zawartej na stronie nr. 17
NOTES: NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE. 17
Streszczenie treści zawartej na stronie nr. 18
REPLACEMENT PARTS LIST VF5000-CMN VF6000-CMN VF5000-CMP VF6000-CMP No. Description Part No. Qty. Part No. Qty. 1. SIT Valve - Millivolt (Natural) H4173 1 H4173 1 Honeywell Valve - Millivolt (Natural) 24M13 1 24M13 1 SIT Valve - Millivolt (Propane, LPG) H4278 1 H4278 1 Honeywell Valve - Millivolt (Propane, LPG) 67L02 1 67L02 1 2. Injector, Burner (Natural)
Streszczenie treści zawartej na stronie nr. 19
REPLACEMENT PARTS 14 16 15 11 14 13 1 2 (SIT Valve Shown) 12 8 3 4 10 7 6 9 5 NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE. 19
Streszczenie treści zawartej na stronie nr. 20
LHP reserves the right to make changes at any time, without notice, in design, materials, specifications, and prices, and also to discontinue colors, styles and products. Consult your local distributor for fireplace code information. LHP Printed in U.S.A. © 1997 by Lennox Hearth Products 5108 Elm Hill Pike, Suite 108 P/N 903302 REV. N 04/2010 Nashville, TN 37210 20 NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE.
