Instrukcja obsługi Regency Sunrise Gas Fireplace L676S-LP1

Streszczenie treści zawartej na stronie nr. 1

Regency L676-1 Sunrise Gas Fireplace
L676-1 Sunrise Gas Fireplace
Framing Dimensions:
Model L676S-NG1 L676S-LP1
Framing Dimensions Description L676S-1
Fuel Type Natural Gas Propane
J Framing Width 43” (1092mm)
Minimum Supply Pressure 5” W.C. (1.25 kPa) 12” W.C. (2.98 kPa)
K*** Framing Height*** 45-7/8” (1165mm)*** + Hearth
Manifold Pressure - High 3.5” W.C. (0.87 kPa) 10” W.C . (2.49 kPa)
L Framing Depth 24-1/2” (622mm)
M Minimum Height to Combustibles 56-1/4” (1429mm)
Manifold Pressure - Low 1.

Streszczenie treści zawartej na stronie nr. 2

Regency L676-1 Sunrise Gas Fireplace L676-1 Sunrise Gas Fireplace Important: Finishing Requirements: A 3/4" gap must be maintained all around the outer edge of the faceplate and the edge of any fi nishing material thicker than Note: All non-combustible facing material should butt up cleanly 1-1/4"). to the fl anges around the fi rebox opening. This gap is required to facilitate the installation of the faceplate and Rough edges may be visible, from an angle, t

Streszczenie treści zawartej na stronie nr. 3

Regency L676-1 Sunrise Gas Fireplace L676-1 Sunrise Gas Fireplace Vertical Terminations: Clearance Requirements: Installed Installed Close Close to Floor to Ceiling Clearance: Dimension Measured From: A: Mantel Height 16-1/2” (419mm) Minimum B: Sidewall 14-3/4” (375mm) Side of fi replace opening C: Ceiling 52” (1321mm) Top of fi replace opening D: Mantel Depth 13” (330mm) Maximum E: Alcove Width 84” (2134mm) Sidewall to Sidewall (Minimum) F: Alcove Depth 36” (914mm) Front to back wall (Maximum