Instrukcja obsługi Desa Wall Mantel and Base W26LC

Streszczenie treści zawartej na stronie nr. 1

W26LC WaLL ManteL and Base
asse MBLY ad n Is n ta LLat IOn Is n t RUCt IOs n
Important: Read entire instruction sheet before
WARNING: Use only 1/2" screws to attach metal
assembling or installing mantel kit.
angle brackets. Damage to mantel will result if other
screws are used for this purpose.
this mantel is only approved for use with any DesA
Heating Products 26" gas or electric fireplace system.
AssemblING mANtel
Do not use mantel with any other product.
ImPORt ANt : more than one pers

Streszczenie treści zawartej na stronie nr. 2

leG Assembly 4. Place right side/leg assembly on base and align threaded holes with brackets. Start 1/2" screws through brackets 1. Lay right side panel (#2) face down on a soft surface to into threaded holes in side/leg assembly. Back of side/ avoid marking finish. Attach right front corner (#8) to side 1 leg assembly should be flush with back of base. Assure panel with three 1 / " screws with washers as shown in 4 alignment is correct and spaces are at a minimum and Figure 1. Attach leg

Streszczenie treści zawartej na stronie nr. 3

mANtel tOP Assembly GAs FIRePlAce INst AllA tION 1. Fireplace should be fully assembled. See Assembling Place mantel top (#7) on mantel assembly. Align back of top 1 with back of sides. Using four 1 / " screws with washers, Fireplace in fireplace owner’s manual. 4 place two in each mantel side assembly (see Figure 4). With 2. Place mantel base close to installation location. See fire- 1 one 1 / " screw with washer, attach top to header. Make sure 4 place owner’s manual for installation clear

Streszczenie treści zawartej na stronie nr. 4

AssemblING PeRImeteR tRIm Slot Set Screws 1. Remove packaging from three pieces of metal trim. Top Trim 2. Locate two adjusting plates with set screws, and two Adjusting shims in the hardware packet. Plate Mitered Edge 3. Align shim under adjusting plate as shown in Figure 7. 4. Slide one end of adjusting plate/shim in slot on mitered Side Trim Shim edge of top trim (see Figure 7). 5. Slide other end of adjusting plate/shim in slot on mitered edge of side trim (see Figure 7). Slot 6. While