Streszczenie treści zawartej na stronie nr. 1
C
N
E
R
G
T
I
INSTALLER/CONSUMER
SAFETY INFORMATION
Gas Fireplace
PLEASE READ THIS MANUAL
BEFORE INSTALLING AND
USING APPLIANCE
Insert
WARNING!
IF THE INFORMATION IN THIS
Models: A125
MANUAL IS NOT FOLLOWED
EXACTLY, A FIRE OR EXPLO-
A132
SION MAY RESULT CAUSING
PROPERTY DAMAGE, PER-
SONAL INJURY OR LOSS OF
LIFE.
FOR YOUR SAFETY
Installation and service must
be performed by a qualified
installer, service agency or
the gas supplier.
WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any
Streszczenie treści zawartej na stronie nr. 2
Gas Fireplace Insert Table of Contents PLEASE READ THE INSTALLATION & OPERATING INSTRUCTIONS BEFORE USING THIS APPLIANCE. Thank you and congratulations on your purchase of a CFM Corporation fireplace insert. IMPORTANT - Read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible fire hazard and will void the manufacturers' warranty. Installation & Operating Instruction Important Curing/Burning Instructions ............
Streszczenie treści zawartej na stronie nr. 3
Gas Fireplace Insert Installation & Operating Instructions This gas appliance should be installed by a qualified installer, 11. These appliances are certified for installation in a solid preferably NFI or WETT (Canada) certified, in accordance with fuel burning fireplace unless using the model HEZC Zero local building codes and with current CSA-B149.1 Installation Clearance Kit. When the zero clearance kit is used, and the codes for Gas Burning Appliances and Equipment. For U.S. appliance is in
Streszczenie treści zawartej na stronie nr. 4
Gas Fireplace Insert F B D A G E J H C Zero Clearance Kit Maintain 1” Clear- ance to ‘B’ Vent P M U 4“ Q V K O T S L R N Air Inlet Channel Gas Inlet Knock-out A125 A132 R - Fireplace Opening Width A1 26 ³⁄₄” (680 mm) 26 ⁵⁄₈” (676 mm) Q - Fireplace Opening Height B1 38 ¹⁄₂” (978 mm) 38 ³⁄₈” (957 mm) S - Depth of Insert 2964 T - Firebox Width at Insert Depth (S) A2 29 ¹⁄₄” (743 mm) A125_132 specs 29” (737 mm) U - Firebox Depth at Insert Back Height (V) 10/06 T B2 43 ¹⁄₂” (1105 mm) 41 ¹⁵⁄₁₆” (
Streszczenie treści zawartej na stronie nr. 5
Gas Fireplace Insert Framing & Finishing Locating Your Gas Fireplace Insert with Zero Clearance Kit For Zero Clearance Kit applications, it is important to determine the finished facing material before beginning to frame. This will allow for the thickness of the finishing X A E B material between the frame and the fireplace trim. Similarly, consideration must be given to the 1" inch depth of the air inlet channel sitting on the fireplace C base. Finishing material for the hearth should be flush
Streszczenie treści zawartej na stronie nr. 6
Gas Fireplace Insert Combustion Air High Elevations It is very important that an adequate air supply is Input ratings are shown in BTU per hour and are available when the unit is being operated. Since most certified without deration for elevations up to homes of today are tightly sealed and insulated, addi- 4,500 feet (1,370m) above sea level. tional make-up air is usually necessary. For elevations above 4,500 feet (1,370m) in USA, This fireplace has been designed to operate by drawing insta
Streszczenie treści zawartej na stronie nr. 7
L I P TP TH THTP Gas Fireplace Insert When using copper or flex connector, use only Trim Top approved fittings. Always provide a union when Trim Left Side using black iron pipe so the gas line can be easily disconnected for burner or fan servicing. See gas Wiring Bracket Switch specifications for pressure details and ratings. from Millivolt NOTE: If flex connector is used, it must be kept inside Gas of the heater. Valve Trim Screw 1/2” Gas Supply 1/2” x 3/8” Reducer On/Off Switch 3/8”
Streszczenie treści zawartej na stronie nr. 8
Gas Fireplace Insert WARNING This fireplace has been converted for use with gas only and cannot be used for burning wood or solid fuels unless all original parts have been replaced and the fireplace has been re-approved by the authority having jurisdiction. Cutting any sheet metal parts of the fire- place, in which the gas fireplace insert is to be installed, is prohibited. Ensure there are no obstructions to side air passages of decorative trim once in- Leveling Bar stalled on insert. Set Scr
Streszczenie treści zawartej na stronie nr. 9
Gas Fireplace Insert Test Chimney Draw Common Flue Installations A "Chimney Draw" test must be made before the In some areas it is possible to vent more than one gas installation is complete. fireplace into the same flue. You must ensure the flue being shared has the proper capacity to handle both 1. Close all doors and windows in the home and start fireplaces. Check installation codes for venting capacity exhaust fans in the kitchen and bathroom. information. 2. Light unit and operate for 5 m
Streszczenie treści zawartej na stronie nr. 10
Gas Fireplace Insert Fan Kit Installation Fan Removal Instructions 115 Volt, 60 Hz. 56W 1. Turn off gas and electricity. 2. Remove the front glass. The fan kit includes the following: fan, temperature 3. Remove the logs. sensor, speed control and a 6 ft. cord. The following explains how to start and set the fan for automatic 4. Remove burner assembly and rear log support plate. operation. 5. Remove the fan mounting nuts (2). (Fig. 13) 1. Plug in the electrical cord. 6. Slip off the electric
Streszczenie treści zawartej na stronie nr. 11
Gas Fireplace Insert Operating Instructions General Glass Information Glass Frame Removal Only ceramic glass approved by CFM Cor- 1. Remove the top louvre. (Refer to “Louvre Removal” poration may be used for replacement on section) this unit. 2. Open access door. 1. The use of substitute glass will void all product 3. Remove two (2) machine screws from the bottom of warranties. glass frame. (Fig. 16) 2. Care must be taken to avoid breakage of the glass. 4. Lift up and unhook glass frame
Streszczenie treści zawartej na stronie nr. 12
I �� L Gas Fireplace Insert Front Right Log N14 Figure 17 Right Rear Log Left Rear Log A125 N16 N15 Front Left Log N13 LG479 Ember Material Front Right Log Figure 18 N20 A132 Right Rear Log Left Rear Log N18 N17 Front Left Log N19 � ���� ������� �� ����� LG481 Ember Material Large Lava Rock Placement SIT Valve Turn The large lava rock provided with this fireplace may be Turn clockwise placed on the firebox base on either side of the burner counterclockwise to decrease assembly. to increase � ���
Streszczenie treści zawartej na stronie nr. 13
Gas Fireplace Insert Flame Characteristics First Firing Upon completing the gas line connection, a small It is important to periodically perform a visual check of amount of air will be in the lines. When first lighting unit the pilot and the burner flames. Compare them to the with pilot light, it will take a few minutes to purge them- Figure 21 and Figure 22 or 23. If any of the flames ap- selves of this air. Once the purging is complete, the pear abnormal call a service person. pilot and burn
Streszczenie treści zawartej na stronie nr. 14
O 3 2 ON 1 T O Gas Fireplace Insert Lighting and Operating Instructions FOR YOUR SAFETY READ BEFORE LIGHTING WARNING:If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. A. This heater has a pilot which must be lit manu- instructions. ally. When lighting the pilot follow these instruc- • If you cannot reach your gas supplier, call tions exactly. the Fire Department B. BEFORE LIGHTING smell all around the heater
Streszczenie treści zawartej na stronie nr. 15
Gas Fireplace Insert Troubleshooting the Gas Control System SIT NOVA 820 Millivolt Valve NOTE: Before trouble shooting the gas control system, be sure external gas shut off is in the “On” position. WARNING: Before doing any gas control service work, remove glass front. SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION 1. Spark ignitor will not light A. Defective or misaligned Using a match, light pilot. If pilot lights, turn off electrode at pilot. pilot and push the red button again. If
Streszczenie treści zawartej na stronie nr. 16
Gas Fireplace Insert Troubleshooting the Gas Control System Honeywell Millivolt Valve START CHECK Gas Supply On NO Supply Line Hooked Up Shutoff Valve Open YES Lockout Has Engaged. Wait 60 Seconds And Try Again. For Spark At Electrode While Pilot Lights With Depressing Piezo — 1/8" Gap To NO Piezo Ignitor Pilot Hood Needed. All Wiring Connections Replace Piezo Ignitor YES For Air In The Lines Thermopile Needs A Minimum 325mv. Adjust Pilot Flame Height. All Wiring Connections. Replace Thermo
Streszczenie treści zawartej na stronie nr. 17
Gas Fireplace Insert Maintenance Burner and Burner Compartment It is important to keep the burner and the burner In order to properly clean the burner and pilot assembly, compartment clean. At least once per year the logs and turn off the gas to the unit, remove the window frame lava rock/ember material should be removed and the panel and logs exposing the burner and pilot assembly. burner compartment vacuumed and wiped out. Remove Clean all foreign materials from the top of the burner. and
Streszczenie treści zawartej na stronie nr. 18
� � Gas Fireplace Insert 1 A125 1 A132 4 3 1d 1c 1c 1d 5 19 1b 1a 1b 1a 18 10a/b 21 8a/b 18 9a/b 24 17 13 ��� 16 11a/b 14 25 23a/b 20 22a/b 15 30 26 29 27 14 28 32 34 31 35 33 CFM Corporation reserves the right to make changes in design, materials, specifications, prices and discontinue colors and products at any time, without notice. 2964 A125, A132 Gas Insert A125/132 parts 11/06 Ref. Description A125 A132 1. Log Set Complete 10002906 10002916 1a. Log Front Left N13 N19 1b. Log Front Rig
Streszczenie treści zawartej na stronie nr. 19
Gas Fireplace Insert A125, A132 Gas Insert Ref. Description A125 A132 9a. Orifice Pilot PSE - Nat. 10001822 10001822 9b. Orifice Pilot PSE - Prop. 10001823 10001823 10a. Pilot Assembly SIT Top Convertible - Nat. 10002389 10002389 10b. Pilot Assembly SIT Top Convertible - Prop. 10002390 10002390 11a. Pilot Assembly PSE - Nat. 10001739 10001739 11b. Pilot Assembly PSE - Prop. 10001740 10001740 12. Pilot SIT Top Convertible 10002266 10002266 13. Pilot w/Ignitor and Cable PSE 10001824 1000182
Streszczenie treści zawartej na stronie nr. 20
Gas Fireplace Insert Optional Accessories Follow the instructions supplied with the Zero Clearance Ceramic Refractory Kit carefully for proper installation. Optional for A125 and A132 Remote Controls Model Description Optional remote control units are available to control RHE25CR Ceramic Firebox Liner different functions of the appliance. 1. Remove front glass (Refer to Glass Frame Removal Model Function(s) Controlled section) RC1 ON/OFF 2. Remove logs from unit. RC2 ON/OFF and Temperatu
