Instrukcja obsługi Lochinvar NSF SSB-i & s--01

Instrukcja obsługi dla urządzenia Lochinvar NSF SSB-i & s--01

Urządzenie: Lochinvar NSF SSB-i & s--01
Kategoria: Podgrzewacz wody
Producent: Lochinvar
Rozmiar: 2.7 MB
Data dodania: 6/27/2014
Liczba stron: 12
Drukuj instrukcję

Pobierz

Jak korzystać?

Naszym celem jest zapewnienie Ci jak najszybszego dostępu do treści zawartych w instrukcji obsługi urządzenia Lochinvar NSF SSB-i & s--01. Korzystając z podglądu online możesz szybko przejrzeć spis treści i przejść do strony, na której znajdziesz rozwiązanie swojego problemu z Lochinvar NSF SSB-i & s--01.

Dla Twojej wygody

Jeżeli przeglądanie instrukcji Lochinvar NSF SSB-i & s--01 bezpośrednio na tej stornie nie jest dla Ciebie wygodne, możesz skorzystać z dwóch możliwych rozwiązań:

  • Przeglądanie pełnoekranowe - Aby wygodnie przeglądać instrukcję (bez pobierania jej na komputer) możesz wykorzystać tryp przeglądania pełnoekranowego. Aby uruchomić przeglądanie instrukcji Lochinvar NSF SSB-i & s--01 na pełnym ekranie, użyj przycisku Pełny ekran.
  • Pobranie na komputer - Możesz również pobrać instrukcję Lochinvar NSF SSB-i & s--01 na swój komputer i zachować ją w swoich zbiorach. Jeżeli nie chcesz jednak marnować miejsca na swoim urządzeniu, zawsze możesz pobrać ją w przyszłości z ManualsBase.
Lochinvar NSF SSB-i & s--01 Instrukcja obsługi - Online PDF
Advertisement
« Page 1 of 12 »
Advertisement
Wersja drukowana

Wiele osób woli czytać dokumenty nie na ekranie, lecz w wersji drukowanej. Opcja wydruku instrukcji również została przewidziana i możesz z niej skorzystać klikając w link znajdujący się powyżej - Drukuj instrukcję. Nie musisz drukować całej instrukcji Lochinvar NSF SSB-i & s--01 a jedynie wybrane strony. Szanuj papier.

Streszczenia

Poniżej znajdziesz zajawki treści znajdujących się na kolejnych stronach instrukcji do Lochinvar NSF SSB-i & s--01. Jeżeli chcesz szybko przejrzeć zawartość stron znajdujących się na kolejnych strinach instrukcji, możesz z nich skorzystać.

Streszczenia treści
Streszczenie treści zawartej na stronie nr. 1

SSB-i&s--01
INSTALLATION AND SERVICE MANUAL
SPACE SAVER BOOSTER
ELECTRICAL INSTALLATION PLUMBING INSTALLATION
INSTRUCTIONS INSTRUCTIONS
Electric booster water heaters are available for operation on standard
For the most effective operation install the booster heater as close as
power systems. Check the nameplate for the proper power supply.
possible to the dishwasher.
All internal electrical connections have been made at the factory. See
NOTE:
Circuit Breaker and Fuse Sizing Chart for supply wi

Streszczenie treści zawartej na stronie nr. 2

TEMPERATURE/PRESSURE GAUGES CAUTION !! Manufacturer recommends a temperature/pressure gauge be installed For Installing Temperature and Pressure Relief Valves in both the inlet and outlet lines to the booster heater. These gauges in accordance with American National Std. provide an instant visual check of the water temperature and pressure Z21-22 latest edition. Combination temperature and entering the booster heater and leaving the heater. The visual check is pressure relief valves with extensi

Streszczenie treści zawartej na stronie nr. 3

CAUSE B NOTE: If incoming water temperature is correct and it holds through the dishwashing operation, another possible reason for this condition is Do not run a cold water line to the heater. that the water pressure may be too high. Water pressure to the dishwasher must be approximately 20 psi for proper operation of the booster and dishwasher rinse cycle. OUTLET SOLUTION - If pressure exceeds 20 psi with the Using a 3/4 in. union and piping connect the booster heater water outlet dishwasher ri

Streszczenie treści zawartej na stronie nr. 4

CAUSE C (77ºC). Make certain the thermostats are set to their maximum calibration. They are pre-set at the factory to 190ºF (88ºC) to Thermostats may not be functioning correctly or may be improperly set. compensate for heat loss but they may have been turned down to 180ºF (82ºC) by someone overlooking heat loss through the pipes. SOLUTION - Inspect thermostats for proper operation and correct settings. If setting is below the maximum, reset to SOLUTION - The booster should be moved to within 5

Streszczenie treści zawartej na stronie nr. 5

CAUSE B CAUTION !! Control thermostat may be set too high or be defective. Do not overtighten nut, or sleeve inside of bushing SOLUTION - Reset thermostat(s). If condition is not will cut through tubing. corrected, replace thermostat(s). CHATTERING CONTACTOR(S) OR NOISY RELAY. 4. Replace thermostat on bracket. Replace leads CAUSE A on thermostat terminals. Contactors chatter or hum excessively when pulled in. SOLUTION - Accumulation of dirt will prevent proper CAUTION !! seating of armature. R

Streszczenie treści zawartej na stronie nr. 6

HIGH TEMPERATURE LIMIT SWITCH RECALIBRATION If the temperature in the heater exceeds 210ºF (99ºC), the high temperature limit will shut off the power. The switches must be manually reset by pushing the red buttons. The limit switch has been calibrated at the factory and should not require adjusting. If the calibration changes and must be re-adjusted, the procedure is as follows: Models 4-18kW Hold lock nut (F) and turn calibrating screw (G) clockwise 1/8 turn to increase set point 7ºF (3.9ºC),

Streszczenie treści zawartej na stronie nr. 7

CIRCUIT BREAKER AND FUSED DISCONNECT SWITCH SIZES kW VOLTS PH L1 L2 L3 Breaker or Fuse Size Copper Wire Size Conduit Size 6 208 1 29 29 — 40 8 1/2” 208 3 14 25 14 40 8 3/4” 240 1 25 25 — 40 8 1/2” 240 3 13 22 13 30 10 1/2” 480 3 6 11 6 15 14 1/2” 9 208 1 43 43 — 60 6 3/4” 208 3 22 38 22 50 8 3/4” 240 1 38 38 — 50 8 1/2” 240 3 19 33 19 50 8 3/4” 480 3 9 16 9 20 12 1/2” 12 208 1 58 58 — 90 3 1” 208 3 33 33 33 50 8 3/4” 240 1 50 50 — 70 4 1” 240 3 29 29 29 40 8 3/4” 480 3 14 14 14 20 12 1/2” 15 208

Streszczenie treści zawartej na stronie nr. 8

DIMENSIONS HANGING SUPPORT 8

Streszczenie treści zawartej na stronie nr. 9

PLUMBING CONNECTIONS 9

Streszczenie treści zawartej na stronie nr. 10

10

Streszczenie treści zawartej na stronie nr. 11

11

Streszczenie treści zawartej na stronie nr. 12

CP-2M-4/03-Printed in U.S.A.


Podobne instrukcje
# Instrukcja obsługi Kategoria Pobierz
1 Lochinvar 000 - 300 Instrukcja obsługi Podgrzewacz wody 16
2 Lochinvar 150 Instrukcja obsługi Podgrzewacz wody 16
3 Lochinvar 065 Instrukcja obsługi Podgrzewacz wody 2
4 Lochinvar 2072 Instrukcja obsługi Podgrzewacz wody 10
5 Lochinvar 45 Instrukcja obsługi Podgrzewacz wody 2
6 Lochinvar 000 Btu/hr Instrukcja obsługi Podgrzewacz wody 0
7 Lochinvar 000 - 500 Instrukcja obsługi Podgrzewacz wody 3
8 Lochinvar 402 Instrukcja obsługi Podgrzewacz wody 11
9 Lochinvar A07H00123456 Instrukcja obsługi Podgrzewacz wody 1
10 Lochinvar 495 Instrukcja obsługi Podgrzewacz wody 5
11 Lochinvar 999 - 750 Instrukcja obsługi Podgrzewacz wody 5
12 Lochinvar 500 Instrukcja obsługi Podgrzewacz wody 12
13 Lochinvar ARM3072PAB Instrukcja obsługi Podgrzewacz wody 0
14 Lochinvar 90 Instrukcja obsługi Podgrzewacz wody 0
15 Lochinvar ARMOR 150 - 800 Instrukcja obsługi Podgrzewacz wody 5
16 A.O. Smith 000 Instrukcja obsługi Podgrzewacz wody 8
17 A.O. Smith 101 Instrukcja obsługi Podgrzewacz wody 3
18 A.O. Smith 12 40GPC T 100 Instrukcja obsługi Podgrzewacz wody 4
19 A.O. Smith 104 Series Instrukcja obsługi Podgrzewacz wody 3
20 A.O. Smith 104 - 110 Instrukcja obsługi Podgrzewacz wody 6