Instrukcja obsługi Aquacal 175

Streszczenie treści zawartej na stronie nr. 1

Heat Pump
Quick Start Guide
Models: 035, 055, 075, 110, 120, 121, 155, 156, & 175

For product manuals and further installation / operation procedures
visit www.AquaCal.com
Important
Read This Guide Before Installing or Operating Heat Pump
LTP0055 Rev-3 02/01/2011

Streszczenie treści zawartej na stronie nr. 2

Page 1 SECTION 1 - GENERAL INFORMATION CONTACTING AQUACAL AUTOPILOT Web www.AquaCal.com (727) 823-5642 Phone 8:00 a.m. to 5:00 p.m. Eastern time, Monday through Friday Fax (727) 821-7471 If you should need to call AquaCal AutoPilot for questions, service, or parts, please have your model and serial numbers available. SAFETY For personal safety, and to avoid damage to equipment, follow all safety instructions displayed in this guide. Repair and service of your heat pump must be pe

Streszczenie treści zawartej na stronie nr. 3

Page 2 SECTION 2 - INSTALLATION For commercial or complete installation instructions please, visit www.AquaCal.com for equipment manual. EQUIPMENT CLEARANCES Keep the area immediately adjacent to the heat pump clear of items such as shrubs and bushes, lawn furniture, chemicals containers, etc. These items can prevent air from circulating properly through the heater, and will result in inefficient operation and/or damage to the heat pump. (Rear) Overhang with 12” Clearance for All I

Streszczenie treści zawartej na stronie nr. 4

Page 3 SECTION 3 - OPERATION Pool Desired Temp ° Spa Water Temp 78 Cooling Heating POOL UP DOWN MODE SPA Figure 4 INDICATOR LIGHTS LIGHTS EXPLANATION SUPPLEMENTAL INFORMATION “Pool” Pool Thermostat Selected “Spa” Spa Thermostat Selected “Cooling” Actively Cooling Water Not applicable for Straight Heat models. “Desired Temp” Setting Desired Water Temperature “Water Temp” Actual Water Temperature “Heating” Actively Heating Water Table 3 BUTTONS BUTTONS EXPLANATION SUP

Streszczenie treści zawartej na stronie nr. 5

Page 4 PROGRAMMING Activity Steps Step 1: Select the “POOL / SPA” button to choose the thermostat to adjust. Step 2: Select the “UP” or “DOWN” button to increase or decrease the desired set temperature. Adjusting Step 3: Once set, the current water temperature will be displayed. The Heat Pump will start to operate to meet Temperature the desired temperature. Please note a time delay will be experienced if Heat Pump has just been initialized. This delay is between 4 to 5 minutes. St

Streszczenie treści zawartej na stronie nr. 6

Page 5 SECTION 5 - TROUBLESHOOTING ERROR CODES SYMPTOM RULE OUT RESOLUTION "FLO" Insufficient water flow Step 1: through heater or Insufficient Water Flow Confirm water pump is on and water valves are in the correct position to allow circulation pump is off water to flow through Heat Pump. If error persists, proceed to next step. Step 2: Filtration Dirty Confirm filtration system is clean. Backwash if needed. If error persists, proceed to next step. Possible Water Step 3: Pressur