Instrukcja obsługi Monte Carlo Fan Company 4BN44WHD Series

Streszczenie treści zawartej na stronie nr. 1

OWNER’S
MANUAL
Ceiling Fan Installation Instructions
Total fan weight
with light kit
For 4BN44WHD Series Fans
READ AND SAVE THESE INSTRUCTIONS
QUALITY CEILING FANS

Streszczenie treści zawartej na stronie nr. 2

Installation SAFETY TIPS WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: READ AND SAVE THESE INSTRUCTIONS 1. Installation work and electrical wiring must be done by qualified person(s) in accordance with applicable codes ANSI/NFPA 70- 1999), including fire-rated construction. 2. Use this unit only in the manner intended by the manufacturer. If you have any questions contact the manufacturer. 3. After making the wire connections, the wires sh

Streszczenie treści zawartej na stronie nr. 3

7 8 9 Place canopy ring on downrod. Place canopy on downrod. Thread leadwires and safety cable through the downrod. 11 10 12 Insert the Pin through the Yoke and Insert downrod into yoke on top of Install the keeper to pin. Downrod until the point appears on the Fan Body. Align the hole in the the other side. Downrod with the hole in the Yoke. Safety cable installation 13 14 15 Safety Cable Lag Screw safety cable washer lock 3” lag washer screw Fan and light kit combinations over 35 lbs, in b

Streszczenie treści zawartej na stronie nr. 4

20 21 19 Install the 2 thumb nuts to the studs Lift canopy up aligning with the Lift canopy ring up aligning with the and finger tighen. studs from mounting bracket. studs from mounting bracket. 23 24 22 Install blade arm to reversed Check motor for shipping stabilizers Install medallion to one side of the and remove if present. side of blade. Tighten 3 screws blade. It is suggested to use different securely. Repeat for all 4 blades. finishes for medallion and blade so they will not be the same

Streszczenie treści zawartej na stronie nr. 5

32 33 F Fllu us sh h M Mo ou un nt t I In ns st ta alllla at tiio on n 31 Remove the 2 studs from mounting Place glass on fitter by threading pull Install finial nut by threading pull bracket. chains through glass , glass finial chain through hole in finial nut. cap, and knurled nut. Hand tighten Hand tighten finial nut securely. knurled nut securely. 34 35 36 Remove the plastic insert from each Remove every other screw and save Take 4 screws from hardware pack side of canopy. for future use. an

Streszczenie treści zawartej na stronie nr. 6

TROUBLE SHOOTING If you have difficulty operating your new ceiling fan, it may be the result of incorrect assembly, installation, or wiring. In some cases, these installation errors may be mistaken for defects. If you experience any faults, please check this Trouble Shooting Chart. If a problem cannot be remedied, or you are experiencing difficulty in installation, please call our Customer Service Center at the number printed on your parts list insert sheet. Warning: Before servicing or cleani