Instrukcja obsługi Aube Technologies TH116 A

Streszczenie treści zawartej na stronie nr. 1

     
  ! 
 "   # $

 
  
Turn the dial to the desired temperature.
FOR A AND AF MODELS ONLY At the rear of the control module are two potentiometers.

 
 
These potentiometers act like a temperature lock. Even TH113: The dial is located on the front of the control
At the rear of the control module is a switch that has been
Thank you for choosing Aube’s non-
when occupants adjust the temperature using the dial on modul

Streszczenie treści zawartej na stronie nr. 2

Installation Instructions MASTER THERMOSTATS SLAVE UNITS TH113-A/F/AF (12VDC) CT230-120GA TH114-A/F/AF (12VDC) CT230-120GB TH115-A/F/AF (12VDC) CT230-240GA TH116-A/F/AF (12VDC) CT230-240GB 3.2 Slave Units - Installation and Wiring 1. Introduction The slave units can operate on different voltages (e.g. 5 units @ 120 V and 5 @ 240 V). This master and slave unit system is specially • Required parts: CT230-120GA, -120GB, -240GA or -240GB designed for large floor heating applications exceeding 15 A.

Streszczenie treści zawartej na stronie nr. 3

3.3 Master Thermostat - Installation and Wiring Technical Specifications WARNING: Make sure all slave units are in STANDBY mode. Temperature: - Operation: 32°F to 122°F (0°C to 50°C) •Required parts: TH113-A/F/AF (12VDC), - Storage: -4°F to 122°F (-20°C to 50°C) TH114-A/F/AF (12VDC), TH113/TH114/TH115/TH116 (A/F/AF-12VDC) TH115-A/F/AF (12VDC) or TH116-A/F/AF (12VDC) Power supply 12 V from remote unit • Location: anywhere easily accessible to users. Maximum up to 10 slave units per Temperature