Instrukcja obsługi Kenwood KDC 128

Streszczenie treści zawartej na stronie nr. 7

About CDs Handling CDs Removing CDs • Don’t touch the recording surface of the CD. When removing CDs from this unit pull them out horizontally. CDs that can’t be used • CDs that aren’t round can’t be used. • CD-R and CD-RW are easier to damage than a normal music CD. Use a CD-R or a CD-RW after reading the caution items on the package etc. • Don’t stick tape etc. on the CD. • CDs with coloring on the recording surface or that Also, don’t use a CD with tape stuck on it. are dirty can’t be use

Streszczenie treści zawartej na stronie nr. 8

General features Release button Control knob VOL CRSC ATT Q SRC CLK ATT indicator LOUD indicator Power Volume Turning ON the Power Increasing Volume Press the [SRC] button. Turn the [VOL] knob clockwise. Turning OFF the Power Decreasing Volume Press the [SRC] button for at least 1 second. Turn the [VOL] knob counterclockwise. Selecting the Source Attenuator Turning the volume down quickly. Press the [SRC] button. Press the [ATT] button. Source required Display Each time the button is pressed, th

Streszczenie treści zawartej na stronie nr. 9

System Q 5 Exit Audio Control mode Press any button. You can recall the best sound setting preset for Press the button which is not [VOL] knob and different types of music. [ATT] button. 1 Select the source to set Press the [SRC] button. 2 Select the Sound type Audio Setup Press the [Q] button. Setting the Sound system, such as Volume offset Each time the button is pressed, the sound and Loudness. setting switches. Sound setting Display 1 Select the source for adjustment Natural "FLAT" Press

Streszczenie treści zawartej na stronie nr. 10

General features Speaker Setting Adjusting Clock Fine-tuning so that the System Q value is optimal 1 Enter Standby when setting the speaker type. Press the [SRC] button. Select the "STBY" display. 1 Enter Standby Press the [SRC] button. 2 Select the clock display Select the "STBY" display. Press the [CLK] button. 2 Enter Speaker Setting mode 3 Enter clock adjustment mode Press the [VOL] knob. Press the [CLK] button for at least 2 seconds. The clock display blinks. 3 Select the Speaker type Turn

Streszczenie treści zawartej na stronie nr. 11

Theft Deterrent Faceplate The faceplate of the unit can be detached and taken with you, helping to deter theft. Removing the Faceplate Press the Release button. The faceplate is unlocked, allowing you to detach it. • The faceplat e is a precision piece of equipment and can be damaged by shocks or jolts. For that reason, keep the faceplate in its special storage case while detached. • Do not expose the faceplate or its storage case to direct sunlight or excessive heat or humidity. Also avo

Streszczenie treści zawartej na stronie nr. 12

Tuner features Control knob CRSC CRSC 1 – 6 SRC Band display AUTO indicator Preset station number ST indicator Frequency display Tuning Tuning Mode Selecting the station. Choose the tuning mode. Press the control knob. 1 Select tuner source Each time the knob is pressed, the Tuning mode Press the [SRC] button. switches as shown below. Select the "TUnE" display. Tuning mode Display Operation 2 Select the band Auto seek "AUTO 1" Automatic search for a station. Push the Control knob to [FM] or [A

Streszczenie treści zawartej na stronie nr. 13

Station Preset Memory CRSC (Clean Reception System Circuit) Putting the station in the memory. Temporarily have reception switched from 1 Select the band stereo to mono to reduce multi-path noise when Push the Control knob to [FM] or [AM]. listening to the FM station. 2 Select the frequency to put in the memory Press the [CRSC] button for at least 1 second. Push the Control knob to [4] or [¢]. Each time the button is pressed, CRSC turns ON and OFF. 3 Put the frequency in the memory When it’s

Streszczenie treści zawartej na stronie nr. 14

CD player features Control knob 0 CRSC RDM SRC SCAN REP SCN indicator REP indicator IN indicator RDM indicator Track number Playing CD Fast Forwarding and Reversing When a disc is inserted Fast Forwarding Press the [SRC] button. Hold down on [¢] of the Control knob. Select the "CD" display. Release your finger to play the disc at that point. Reversing Hold down on [4] of the Control knob. • When a CD is inserted, the "IN" indicator is ON. Release your finger to play the disc at that point. Paus

Streszczenie treści zawartej na stronie nr. 15

Track Repeat Replaying the song you’re listening to. Press the [REP] button. Each time the button is pressed, the Track Repeat turns ON and OFF. When it's ON, the "REP" indicator is ON. Scan Play Playing the first part of each song on the disc you are listening to and searching for the song you want to listen to. 1 Start Scan Play Press the [SCAN] button. "SCN" indicator is ON. 2 Release it when the song you want to listen to is played Press the [SCAN] button. Random Play Playing all the son

Streszczenie treści zawartej na stronie nr. 16

Accessory of the KDC-1028 Basic Operations of remote SRC VOL SRC ATT ATT VOL 38 AUD AUD 38 FM+ 4 ¢ 4/¢ AM– FM/AM Loading and Replacing the battery Basic operations Use two "AA"-size batteries. [VOL] buttons Slide the cover while pressing downwards to Adjusting the volume. remove it as illustrated. [SRC] button Insert the batteries with the + and – poles aligned Each time the button is pressed, the source properly, following the illustration inside the case. switches. For the source switching

Streszczenie treści zawartej na stronie nr. 17

Audio Control [AUD] button Select the Audio item for adjustment. [VOL] buttons Adjust the Audio item. • Refer to

Streszczenie treści zawartej na stronie nr. 18

Accessories/ Installation Procedure Accessories 2WARNING If you connect the ignition wire (red) and the battery wire (yellow) to the car chassis (ground), you may cause a short 1 circuit, that in turn may start a fire. Always connect those wires to the power source running through the fuse box. ..........1 • If the power is not turned ON (or it is ON, but will be OFF immediately), the speaker wire may have a short-circuit or touched the chasis of the vehicle and the protection 2 function m

Streszczenie treści zawartej na stronie nr. 19

FRONT Connecting Wires to Terminals Front right output (Red) (KDC-1028 only) Front left output (White) (KDC-1028 only) Rear left output (White) Rear right output (Red) FM/AM antenna input Fuse (10A) Wiring harness If no connections are made, do not let the wire come out from the tab. (Accessory1) Power control wire (Blue/White) When using the optional power amplifier, P.CONT connect to its power control terminal. Depending on what antenna you are using, connect either to the control termina

Streszczenie treści zawartej na stronie nr. 20

Installation non-Japanese cars Japanese cars 1 Refer to the section (page 22) and then remove the hard (commercially available) rubber frame. Firewall or metal support 2 Align the holes in the unit (two locations on each side) with the vehicle mounting bracket and secure the unit with the accessory screws. T N T/N N T Bend the tabs of the T: Toyota cars mounting sleeve with a N: Nissan cars screwdriver or similar utensil and attach it i

Streszczenie treści zawartej na stronie nr. 1

KDC-1028
KDC-128
KDC-128CR
CD-RECEIVER
INSTRUCTION MANUAL
AMPLI-TUNER LECTEUR DE CD
MODE D’EMPLOI
REPRODUCTOR DE DISCOS COMPACTOS RECEPTOR DE FM/AM
MANUAL DE INSTRUCCIONES
Take the time to read through this instruction manual.
Familiarity with installation and operation procedures will help you
obtain the best performance from your new CD-receiver.
For your records
Record the serial number, found on the back of the unit, in the spaces
designated on the warranty card, and in the space provided

Streszczenie treści zawartej na stronie nr. 2

Streszczenie treści zawartej na stronie nr. 3

Contents 2Warning 4 Accessories/ Installation Procedure 18 Connecting Wires to Terminals 19 Safety precautions 5 Notes 6Installation 20 Removing the Unit 22 About CDs 7 General features 8 Troubleshooting Guide 23 Power Specifications 25 Selecting the Source Volume Attenuator System Q Audio Control Audio Setup Speaker Setting Clock Display Adjusting Clock Dimmer Control DSI (Disabled System Indicator) Theft Deterrent Faceplate TEL Mute Tuner features 12 Tuning Tuning Mode Station Preset Memory Au

Streszczenie treści zawartej na stronie nr. 4

2Warning 2CAUTION NOTE Use of controls or adjustments or performance of This equipment has been tested and found to procedures other than those specified herein may comply with the limits for a Class B digital device, result in hazardous radiation exposure. pursuant to Part 15 of the FCC Rules. These limits In compliance with Federal Regulations, following are designed to provide reasonable protection are reproductions of labels on, or inside the product against harmful interference in a re

Streszczenie treści zawartej na stronie nr. 5

Safety precautions Lens Fogging 2WARNING Right after you turn on the car heater in cold To prevent injury or fire, take the weather, dew or condensation may form on following precautions: the lens in the CD player of the unit. Called lens • To prevent a short circuit, never put or leave any fogging, CDs may be impossible to play. In such metallic objects (such as coins or metal tools) a situation, remove the disc and wait for the inside the unit. condensation to evaporate. If the unit stil

Streszczenie treści zawartej na stronie nr. 6

Notes • If you experience problems during installation, consult your Kenwood dealer. • If the unit fails to operate properly, press the Reset button. The unit returns to factory settings when the Reset button is pressed. CRSC Reset button • The illustrations of the display and the panel appearing in this manual are examples used to explain more clearly how the controls are used. Therefore, what appears on the display in the illustrations may differ from what appears on the display on th