Instrukcja obsługi Sioux Tools 5562

Streszczenie treści zawartej na stronie nr. 1

Streszczenie treści zawartej na stronie nr. 2

'On/Off valve to exhaust the air from the¥fee Work Stations hose before fitting, removing or adjusting the The tool should only be used as a hand held hand operated too), li is working attachment fitted to the tool. always recormended hat he too! is used when standing on a solid -Before using the tool make sure that a shut off device floor. It can be used in other positions but before any such use the has been fitted to the supply line and the position operator must be in a secure posi

Streszczenie treści zawartej na stronie nr. 3

20mm Belt Sander fief No Part No 1 Description Ref No 1 Part No 1 Description 1 67313 Motor Housing 67339 1 Shoe 1 2 67314 ISorina 1 35 I 67342 !Tension Arm I 1 36 I 67343 1 Stoooer Pin 1 38 1 67345 1 Cap Screw (2) ç 1 7 1 67316 I Valve Body, 1 1 8 I , 67317 1 Throttle Lever 1 9 66540 Lever Pin 40 67347 Idle Pulley 10 6731 8 Deflector 41 67348 Ball Bearing (21 M 11 6731 9 Air Inlet 42 67349 Idle Shaft 12 67320 Motor Nut 43 67350 Collar -- - 1 44 1 67351 I Wheel Cover Lid 45 I 673

Streszczenie treści zawartej na stronie nr. 4

Dismantling & Assembly Notes Disconnect loo) from air supply Lift cover(44). press down stoppef(28) 10 reduce tension on the abrasive belt and push on idle pulley(40) 10 remove belt. Remove capscrew(38) and washer(37) to remove shoe(32). Take out 2 off scfews(38) and 2 off washers(37) to removs tingaplate(39). Take out ide shaft screw(42) to release ide pulley assembly. "The ide pulley assembly may be dismantled by tapping out the bearings(41) from idle pulley(40) releasing cdlar(43).