Instrukcja obsługi Black & Decker 2187

Streszczenie treści zawartej na stronie nr. 1

LEVEL COMMAND 2097 / 2187 / 2227 / 2233
WITH 9210 COMPRESSOR
60 90
600
400
120
800
30
200
1000
psi
kPa
PSI
0 150
LEVEL COMMAND
INSTALLATION INSTRUCTIONS NOTE ON CONNECTING THE AIR LINE TUBING:
Congratulations on your purchase of a new Level Command Cut the air line tubing as squarely as possible. To connect
kit. This kit was designed to provide inflation control of your the air line tubing to the fittings, push the tubing into the fittings
air helper springs. This kit will be an asset to you

Streszczenie treści zawartej na stronie nr. 2

VEHICLE PANEL 1/4” HOLES TO BE DRILLED #10 FLAT WASHER 10/32” LOCK NUT STRAIGHT AIR FITTING 2227 AIR LINE POSITIVE, 12 VOLT DASHBOARD ILLUMINATION Air Line & Wiring Diagram CIRCUIT RED GROUND BLACK (TO GROUND) FUSE 60 90 600 400 12 VOLT, 20 AMP 120 800 30 MINIMUM IGNITION 200 WHITE ACTIVATED CIRCUIT 1000 psi WHITE kPa PSI 0 150 AIR LINE Compressor Attachment “T” FITTING AIR SPRING AIR SPRING (sold separately) (sold separately) Connectors: Male spade connector Femal spade connector Ring Terminal

Streszczenie treści zawartej na stronie nr. 3

DEL SUP LOCK NUTS WASHERS CONTROL PANEL BRACKET WASHERS MACHINE SREWS STEP 1 - SELECT A MOUNTING LOCATION FOR THE CONTROL PANEL Select a mounting surface under the dashboard or other protected location. Using the control panel as a template, mark each of the mounting points with a center punch. Drill a 3/16" diameter hole on each center mark see Figure "B". Do not attach the control panel at this time. STEP 2 - PREPARE THE COMPRESSOR Install the rubber isolator feet to the compressor from the b

Streszczenie treści zawartej na stronie nr. 4

WIRE FROM PANEL LIGHT CONNECTING WIRE BACK OF GAUGE STEP 6 - ATTACH THE CONTROL PANEL TO THE DASHBOARD Place the air control panel on the dash where the holes were drilled in Step 1. Using the provided machine screws, lock nuts, and washers attach the air control panel to the dashboard or selected mounting surface see Figure "B". STEP 7 - ROUTE THE ELECTRICAL WIRE All necessary 16 gage electrical wire and connectors are enclosed with the kit. Review the electrical schematic before beginning ins