Streszczenie treści zawartej na stronie nr. 1
SAFETY PRECAUTIONS
OWNER’S/
MOST ACCIDENTS OCCUR BECAUSE OF NEGLECT OR CARELESSNESS.
AVOID NEEDLESS ACCIDENTS BY FOLLOWING ALL OF THE SAFETY PRECAUTIONS LISTED BELOW.
OPERATOR’S
• Machinery should be operated only by those who are • Reduce speed when transporting mounted implements
MANUAL
responsible and are authorized to do so. to avoid bouncing and momentary loss of steering
control.
• Stop the engine, lower all equipment, lock the brakes,
and remove the ignition key before dismounting from th
Streszczenie treści zawartej na stronie nr. 2
SINO LEEINGLES, PIDA AYUDA A TABLE SSPF-3742 & SSPF-3748 AIGUIEN QUE SI LO LEA PARA QUE LE TRADUZCA LAS MEDIDAS DE OF PA RTS LIST SEGURIDAD. CONTENTS STATEMENT SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 OF POLICY It is the policy of Worksaver, Inc. to improve its products SAFETY SIGNS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 where it is possible and practical to do so. Worksaver, Inc. INSTRUCTIONS . . . . . . . . . . . . . . .
Streszczenie treści zawartej na stronie nr. 3
SSPF-3742 & SSPF-3748 PARTS DRAWING LIMITED WARRANTY Worksaver warrants to the original purchaser of any new Pallet Fork (Models SSPF-3742 and SSPF-3748), that the equipment be free from defects in material and workmanship for a period of six (6) months for non- commercial, state, and municipalities. Use sixty (60) days for commercial use from date of retail sale. Replacement or repair parts installed in the equipment covered by this warranty are warranted for sixty (60) days from the date of pu
Streszczenie treści zawartej na stronie nr. 4
INSTRUCTIONS (continued) To the Owner/Operator/Dealer All implements with moving parts are potentially hazardous. There is no substitute for a cautious, safe-minded opera- Carry load low. MAINTENANCE tor who recognizes the potential hazards and follows reasonable safety practices. The manufacturer has designed this implement to be used with all its safety equipment properly attached to minimize the chance of accidents. Check visibility. If visibility is impaired, reduce speed or BEFORE YOU START
Streszczenie treści zawartej na stronie nr. 5
INSTRUCTIONS (continued) SAFETY INSTRUCTIONS (continued) ASSEMBLY – SKID STEER AND CAUTION! TRACTOR LOADERS (CONTINUED) EQUIPMENT SAFETY GUIDELINES Beware of lift clearance when raising loader to max- imum height. Install the pallet forks on the main frame. The forks go on in the center of the main frame and then are slid to the right or left side. Safety of the operator is one of the main concerns in designing and developing a new piece of equipment. Make sure all operators have read the Owner’
Streszczenie treści zawartej na stronie nr. 6
SAFETY INSTRUCTIONS (continued) INSTRUCTIONS The Skid Steer Pallet Fork is designed for skid steer W ARNING! SAFETY TRAINING power units or tractor loaders having the universal bucket attach system (same as original Bobcat design). A heavy load can cause instability in driving a trac- Skid steer units must have rated lifting capacity greater tor or skid steer. Make sure the rear of the tractor or than or equal to the loads to be handled. skid steer is properly counter-balanced with weights. Safe
Streszczenie treści zawartej na stronie nr. 7
SAFETY INSTRUCTIONS (continued) SAFETY SIGNS SAFETY SIGNS Keep safety signs clean and legible at all times. Replace safety signs that are missing or have become illegible. REPLACE Replaced parts that displayed a safety sign should also display the current sign. SAFETY DECALS Safety signs are available from your Distributor or Dealer Parts Department or the factory. IF DAMAGED How to Install Safety Signs: OR MISSING! Be sure that the installation area is clean and dry. Be sure temperature is abov
Streszczenie treści zawartej na stronie nr. 8
SAFETY INSTRUCTIONS (continued) SAFETY INSTRUCTIONS (continued) OPERATIONAL SAFETY MAINTENANCE SAFETY (continued) The use of this equipment is subject to certain hazards which cannot be protected against by mechanical After servicing, be sure all tools, parts and service equipment are removed. means or product design. All operators of this equipment must read and understand this entire manual, paying particular attention to safety and operating instructions, prior to using. If there is somethin
Streszczenie treści zawartej na stronie nr. 9
SAFETY INSTRUCTIONS (continued) SAFETY INSTRUCTIONS (continued) OPERATIONAL SAFETY (continued) MAINTENANCE SAFETY Before you operate any equipment, check over all pins, bolts and connections to be sure all are securely in Good maintenance is your responsibility. Poor maintenance is an invitation to trouble. place. Replace any damaged or worn parts immediately. Follow good shop practices. Do not work under a raised loader unless it is securely blocked or held in position. Do not depend on the pow
Streszczenie treści zawartej na stronie nr. 10
SAFETY INSTRUCTIONS (continued) SAFETY INSTRUCTIONS (continued) TRANSPORT SAFETY OPERATIONAL SAFETY (continued) Comply with state and local laws governing highway safety and movement of farm machinery on public roads. When maneuvering close to buildings or passing through narrow areas, be sure to allow sufficient clearance for the power unit, loader, and load. Drive slowly. The use of flashing amber lights is acceptable in most localities. However, some localities prohibit their use. Local laws
Streszczenie treści zawartej na stronie nr. 11
SAFETY INSTRUCTIONS (continued) SAFETY INSTRUCTIONS (continued) TRANSPORT SAFETY OPERATIONAL SAFETY (continued) Comply with state and local laws governing highway safety and movement of farm machinery on public roads. When maneuvering close to buildings or passing through narrow areas, be sure to allow sufficient clearance for the power unit, loader, and load. Drive slowly. The use of flashing amber lights is acceptable in most localities. However, some localities prohibit their use. Local laws
Streszczenie treści zawartej na stronie nr. 12
SAFETY INSTRUCTIONS (continued) SAFETY INSTRUCTIONS (continued) OPERATIONAL SAFETY (continued) MAINTENANCE SAFETY Before you operate any equipment, check over all pins, bolts and connections to be sure all are securely in Good maintenance is your responsibility. Poor maintenance is an invitation to trouble. place. Replace any damaged or worn parts immediately. Follow good shop practices. Do not work under a raised loader unless it is securely blocked or held in position. Do not depend on the pow
Streszczenie treści zawartej na stronie nr. 13
SAFETY INSTRUCTIONS (continued) SAFETY INSTRUCTIONS (continued) OPERATIONAL SAFETY MAINTENANCE SAFETY (continued) The use of this equipment is subject to certain hazards which cannot be protected against by mechanical After servicing, be sure all tools, parts and service equipment are removed. means or product design. All operators of this equipment must read and understand this entire manual, paying particular attention to safety and operating instructions, prior to using. If there is somethin
Streszczenie treści zawartej na stronie nr. 14
SAFETY INSTRUCTIONS (continued) SAFETY SIGNS SAFETY SIGNS Keep safety signs clean and legible at all times. Replace safety signs that are missing or have become illegible. REPLACE Replaced parts that displayed a safety sign should also display the current sign. SAFETY DECALS Safety signs are available from your Distributor or Dealer Parts Department or the factory. IF DAMAGED How to Install Safety Signs: OR MISSING! Be sure that the installation area is clean and dry. Be sure temperature is abov
Streszczenie treści zawartej na stronie nr. 15
SAFETY INSTRUCTIONS (continued) INSTRUCTIONS The Skid Steer Pallet Fork is designed for skid steer W ARNING! SAFETY TRAINING power units or tractor loaders having the universal bucket attach system (same as original Bobcat design). A heavy load can cause instability in driving a trac- Skid steer units must have rated lifting capacity greater tor or skid steer. Make sure the rear of the tractor or than or equal to the loads to be handled. skid steer is properly counter-balanced with weights. Safe
Streszczenie treści zawartej na stronie nr. 16
INSTRUCTIONS (continued) SAFETY INSTRUCTIONS (continued) ASSEMBLY – SKID STEER AND CAUTION! TRACTOR LOADERS (CONTINUED) EQUIPMENT SAFETY GUIDELINES Beware of lift clearance when raising loader to max- imum height. Install the pallet forks on the main frame. The forks go on in the center of the main frame and then are slid to the right or left side. Safety of the operator is one of the main concerns in designing and developing a new piece of equipment. Make sure all operators have read the Owner’
Streszczenie treści zawartej na stronie nr. 17
INSTRUCTIONS (continued) To the Owner/Operator/Dealer All implements with moving parts are potentially hazardous. There is no substitute for a cautious, safe-minded opera- Carry load low. MAINTENANCE tor who recognizes the potential hazards and follows reasonable safety practices. The manufacturer has designed this implement to be used with all its safety equipment properly attached to minimize the chance of accidents. Check visibility. If visibility is impaired, reduce speed or BEFORE YOU START
Streszczenie treści zawartej na stronie nr. 18
SSPF-3742 & SSPF-3748 PARTS DRAWING LIMITED WARRANTY Worksaver warrants to the original purchaser of any new Pallet Fork (Models SSPF-3742 and SSPF-3748), that the equipment be free from defects in material and workmanship for a period of six (6) months for non- commercial, state, and municipalities. Use sixty (60) days for commercial use from date of retail sale. Replacement or repair parts installed in the equipment covered by this warranty are warranted for sixty (60) days from the date of pu
Streszczenie treści zawartej na stronie nr. 19
SINO LEEINGLES, PIDA AYUDA A TABLE SSPF-3742 & SSPF-3748 AIGUIEN QUE SI LO LEA PARA QUE LE TRADUZCA LAS MEDIDAS DE OF PA RTS LIST SEGURIDAD. CONTENTS STATEMENT SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 OF POLICY It is the policy of Worksaver, Inc. to improve its products SAFETY SIGNS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 where it is possible and practical to do so. Worksaver, Inc. INSTRUCTIONS . . . . . . . . . . . . . . .
Streszczenie treści zawartej na stronie nr. 20
SAFETY PRECAUTIONS OWNER’S/ MOST ACCIDENTS OCCUR BECAUSE OF NEGLECT OR CARELESSNESS. AVOID NEEDLESS ACCIDENTS BY FOLLOWING ALL OF THE SAFETY PRECAUTIONS LISTED BELOW. OPERATOR’S • Machinery should be operated only by those who are • Reduce speed when transporting mounted implements MANUAL responsible and are authorized to do so. to avoid bouncing and momentary loss of steering control. • Stop the engine, lower all equipment, lock the brakes, and remove the ignition key before dismounting from th
