Streszczenie treści zawartej na stronie nr. 1
Installation/Operation
Clothes Dryer
Electric and Gas Models
DRY710C
Keep These Instructions for Future Reference.
(If this machine changes ownership, this manual must accompany machine.)
Part No. 513005R5
www.comlaundry.com August 2011
Streszczenie treści zawartej na stronie nr. 2
Streszczenie treści zawartej na stronie nr. 3
WARNING FOR YOUR SAFETY, the information in this manual must be followed to minimize the risk of fire or explosion or to prevent property damage, personal injury or death. Keep this manual for future reference. If this machine changes ownership, this manual must accompany machine. W755 • Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. • WHAT TO DO IF YOU SMELL GAS: – Do not try to light any appliance. – Do not touch any elect
Streszczenie treści zawartej na stronie nr. 4
Safety Information.............................................................................. 3 Table of Explanation of Safety Messages........................................................... 3 Important Safety Instructions ............................................................... 3 Contents Installation........................................................................................... 5 Dimensions .............................................................................
Streszczenie treści zawartej na stronie nr. 5
Safety Information Explanation of Safety Messages Important Safety Instructions Throughout this manual and on machine decals, you Save These Instructions will find precautionary statements (“DANGER,” “WARNING,” and “CAUTION”) followed by specific WARNING instructions. These precautions are intended for the personal safety of the operator, user, servicer, and To reduce the risk of fire, electric shock, those maintaining the machine. or injury to persons when using your dryer, follow these b
Streszczenie treści zawartej na stronie nr. 6
Safety Information 13. Keep area around the exhaust opening and 22. Install this dryer according to the adjacent surrounding area free from the INSTALLATION INSTRUCTIONS. All accumulation of lint, dust and dirt. connections for electrical power, grounding and gas supply must comply with local codes and be 14. The interior of the dryer and the exhaust duct made by licensed personnel when required. Do should be cleaned periodically by qualified not do it yourself unless you know how! servic
Streszczenie treści zawartej na stronie nr. 7
Installation Dimensions Metered Models *38.19 in. (97 cm) 22.06 in. (56 cm) 8.0 in. 15.4 in. (20.3 cm) (39.1 cm) 0.4 in. 4.0 in. 26.9 in. 23.5 in. 28 in. (1.02 cm) (10.2 cm) (68.3 cm) (59.7 cm) (71.1 cm) ELECTRIC MODELS DRY2353N *With leveling legs turned into base. *38.19 in. (97 cm) 22.06 in. (56 cm) 8.0 in. 2.3 in. (20.3 cm) (6 cm) 0.4 in. 2.8 in. 23.5 in. 28 in. (1.02 cm) 15.4 in. (7 cm) (59.7 cm) (71.1 cm) (39.1 cm) 26.9 in. 1 (68.3 cm) GAS MODELS DRY2254 DRY2354N *With leveling legs turne
Streszczenie treści zawartej na stronie nr. 8
Installation Card Reader Models Before You Start The machine is shipped from the factory with the Tools Electronic Control Diagnostic Harness Assembly For most installations, the basic tools you will need unplugged. To avoid unauthorized manual are: programming or vending perform the following steps. 1. Open service door. Refer to Figure 1. 2 1 2. Locate diagnostic harness on electronic control. 3. Plug connectors for “white/black” wire and “red/ 3 blue” wire together. . 1 4 5 D818I 1 Wrench
Streszczenie treści zawartej na stronie nr. 9
Installation IMPORTANT: In mobile home installations, gas Installing the Dryer dryers MUST be permanently attached to the floor at the time of installation. Order No. 526P3 Hold Step 1: Position and Level the Dryer Down Kit (available at extra cost) for a Install dryer before washer. This allows room for manufactured (mobile) home installation. Follow attaching exhaust duct. the instructions supplied with the kit. Install the four rubber feet (in accessories bag). Installation of unit must
Streszczenie treści zawartej na stronie nr. 10
Installation F 1 B 2 (G) E D A **42 in. (106.7 cm) F 3 AA C FRONT VIEW FRONT VIEW D337I SIDE VIEW (W/O CLOSET DOOR) (CLOSET DOOR) (CLOSET DOOR) D337I Free Standing/Alcove Area Description Closet Installation Installation Dryer sides and rear clearance 0 in. (0 cm) 0 in. (0 cm) A Dryer top clearance 12 in. (30.5 cm) 12 in. (30.5 cm) B Dryer front clearance Not Applicable 2 in. (5.1 cm) C Exhaust duct clearance to 2 in. (5.1 cm) 2 in. (5.1 cm) D combustible material Weather hood to ground clearan
Streszczenie treści zawartej na stronie nr. 11
Installation DO NOT use plastic or thin foil ducting. Rigid Step 2: Connect Dryer Exhaust System metal duct is recommended. WARNING To reduce the risk of fire and combustion gas accumulation the dryer MUST be exhausted to the outdoors. W604 To reduce the risk of fire and the accumulation of combustion gases, DO NOT exhaust dryer air into a window well, gas vent, chimney or enclosed, unventilated area, such as an attic, wall, ceiling, crawl space under a building or concealed space DRY
Streszczenie treści zawartej na stronie nr. 12
Installation Static pressure in exhaust duct should not be Exhaust Direction greater than .6 inches water column (1.5 cm), The dryer can be exhausted to the outdoors through the measured with manometer placed on exhaust back, left, right or bottom of the dryer. EXCEPTION: duct two feet (61 cm) from dryer (check with Gas dryers cannot be vented out the left side dryer running and no load). In multi-dryer because of the burner housing. installations, all dryers connected to the main col
Streszczenie treści zawartej na stronie nr. 13
Installation NOTE: Weather hood should be installed at least Exhaust System 12 inches (30.5 cm) above the ground. Larger For best drying results, recommended maximum clearances may be necessary for installations where length of exhaust system is shown in Table 1. heavy snowfall can occur. To prevent backdraft when dryer is not in operation, outer end of exhaust pipe must have a weather hood with hinged dampers (obtain locally). Weather Hood Type Number of 90° Elbows Recommended Use Only
Streszczenie treści zawartej na stronie nr. 14
Installation Multi-Dryer Installation Exhaust Requirements Figure 6 shows a typical example of a multiple dryer installation. Note how each dryer has its own exhaust system vented to the central exhaust duct. 1 2 24 IN. (61 CM) MINIMUM CLEARANCE TO ROOF/GROUND 3 METERED MODELS ILLUSTRATED DRY2358N 1 58786 Backdraft Damper (Available through 3 Weather Hood or Sweep Elbow your local authorized parts source) (No cap or screen) 2 Clean Out Cover (Must be provided). Inspect monthly. Figure 6
Streszczenie treści zawartej na stronie nr. 15
Installation 1 2 A B C D E F G H I J K 5 3 AIR FLOW 4 EXHAUST AIR FLOW 30° MAXIMUM LENGTH OF DUCT 24 in. (61 cm) 30 feet (9.1 m) MINIMUM EXHAUST CLEARANCE TO OUTLET ROOF/GROUND D686I HORIZONTAL EXHAUST INSTALLATION D686I 1 NOTE: Where the exhaust duct pierces a 3 2 in. (5 cm) Minimum or Clearance per Local combustible wall or ceiling, the opening must be Codes sized per local codes. 4 No Screen or Cap 2 Wall 5 Clean Out Cover – Inspect Monthly Figure 7 2 WARNING 3 To reduce the risk of fi
Streszczenie treści zawartej na stronie nr. 16
Installation 1. Make certain your dryer is equipped for use with Minimum Diameter of Duct Station the type of gas in your laundry room. Dryer is Collector Duct equipped at the factory for Natural Gas with a A 4 inches (10.2 cm) 3/8 inch NPT gas connection. B 8 inches (20.3 cm) NOTE: The gas service to a gas dryer must C 9 inches (22.9 cm) conform with the local codes and ordinances, or in the absence of local codes and ordinances, with the D 10 inches (25.4 cm) latest edition of the Natio
Streszczenie treści zawartej na stronie nr. 17
Installation NOTE: When connecting to a gas line, an equipment shut-off valve must be installed within L.P. Altitude Adjustments 6 feet (1.8 m) of the dryer. An 1/8 in. NPT pipe plug Altitude Orifice Size Part must be installed as shown for checking inlet No. feet m No. inches mm pressure. Refer to Figure 9. 3500 1070 54 0.0550 1.40 503785 7500 2290 55 0.0520 1.32 58755 11000 3355 56 0.0465 1.18 503786 1 Table 3 NOTE: DO NOT connect the dryer to L.P. Gas Service without converting the gas
Streszczenie treści zawartej na stronie nr. 18
Installation Heating elements are available for field installation in dryers which are to be connected to electrical service WARNING of different voltage than that listed on nameplate, such as 208 Volt. Improper connection of the equipment- grounding conductor can result in a risk of NOTE: Branch circuit wire size requirements to electric shock. Check with a qualified laundry room outlet are shown in Table 4. electrician or service person if you are in doubt as to whether the dryer is pro
Streszczenie treści zawartej na stronie nr. 19
Installation IMPORTANT: Use only a new U.L. listed No. 10 (copper wire only) three or four conductor power 1 2 supply cord kit rated 240 Volts (minimum) 30 Amperes and labeled as suitable for use in a clothes 3 8 dryer. 7 1 2 4 3 5 4 6 D275I D679I THREE-WIRE THREE-WIRE CONNECTION D275I D679I 8 2 1 1 3 3 7 1 4 4 FOUR-WIRE 9 10 D006I 1 Typical Receptacle 2 Power Cord 11 6 3 Strain Relief Nut 4 Strain Relief FOUR-WIRE CONNECTION D680I D680I Figure 10 NOTE: DRYER IS SHOWN WITH ACCESS COVER REMOV
Streszczenie treści zawartej na stronie nr. 20
Installation Connecting Power Cord with Three-Wire Plug NOTE: Four-wire cord is required for new branch- circuit installations, mobile homes or where codes do not permit grounding through neutral. NOTE: THE POWER CORD IS NOT SUPPLIED WITH THE ELECTRIC DRYER. TYPE OF POWER CORD AND GAUGE OF WIRE MUST CONFORM TO LOCAL CODES AND INSTRUCTIONS. POWER SUPPLY POWER SUPPLY THE METHOD OF WIRING THE DRYER IS OPTIONAL AND SUBJECT TO LOCAL CODE REQUIREMENTS. 1 NOTE: CONNECT THE DRYER TO THE POWER SUPPL
