Instrukcja obsługi Whirlpool 3979171

Streszczenie treści zawartej na stronie nr. 1

Before you start:
✔
Parts supplied: Venting
Your safety and the safety of others
is very important.
Remove parts package from
We have provided many important safety messages
dryer drum. Check that all 4
WARNING
in this manual and on your appliance. Always read legs were included.
and obey all safety messages.
4 leveling legs
This is the safety alert symbol. This
Parts needed:
symbol alerts you to hazards that can kill
or hurt you and others. All safety Check local codes and see electrical and v

Streszczenie treści zawartej na stronie nr. 2

Exhaust dimensions Dimensions shown with feet extended 1” from bottom of dryer. Dryer location back exhaust 11" terminal block cover and dimensions power supply cord/cable strain relief 14" The dryer door extends 14" from the front of the dryer 4" 43-1/8" WARNING when fully 14-1/8" opened. 38-1/4" left or right side exhaust Explosion Hazard Keep flammable materials and vapors, such as gasoline, away from dryer. 4-1/4" Place dryer at least 18 inches above the floor for a garage installation.

Streszczenie treści zawartej na stronie nr. 3

™ Dura Safe venting products are recommended Mobile home installation requirements Exhaust requirements and are available from your dealer. If codes permit, this appliance is suitable for mobile Four-inch diameter vent must be used. home installations. The installation of the dryer must Use a heavy metal vent. Do Not use plastic or metal conform to Manufactured Home Construction and foil vent. Safety Standard, Title 24 CFR, Part 3280 (formerly the Federal Standard for Mobile Homes Construction

Streszczenie treści zawartej na stronie nr. 4

Now start installation (If installing washer and dryer, install dryer first.) ✔ A. Install vent 1. Put on safety glasses and gloves. 3. Connect vent to exhaust hood with 4" clamp. (Exhaust vent MUST fit inside hood.) system (new 2. Install exhaust hood. 4. Run exhaust vent to dryer location. installation) Use caulking compound to seal Use the straightest path possible. (See Panel B.) exterior wall opening around Use clamps to secure vent pieces. Tin snips may be exhaust hood. needed to cut v

Streszczenie treści zawartej na stronie nr. 5

Four-wire connection... 14-30R Four-wire receptacle (required for mobile homes) DIRECT WIRE 4. Remove center terminal block screw. 5. Remove appliance ground wire (green with yellow stripes) from external ground Preparing the wire: connector screw. Fasten under center, silver-colored terminal block screw. 6. Connect the ground wire (bare) of the power supply 3-1/2" cable to the external ground 3/4" U.L.- conductor screw. Tighten 1" of wires listed strain screw. stripped of relief insulation t

Streszczenie treści zawartej na stronie nr. 6

2 1/2" DIRECT WIRE Where local codes Do Not permit 5. Remove the appliance connecting cabinet-ground conductor to neutral wire: ground wire (green with yellow OR POWER SUPPLY CORD stripes) from the external 4. Remove center terminal block screw. ground connector screw. Connect appliance ground wire Three-wire power supply cord must be and the neutral wire (white or 6. Connect the other four feet long and have three, No.-10 center) of the power supply wires to outer terminal copper wires and ma

Streszczenie treści zawartej na stronie nr. 7

Before you start: ✔ Parts supplied: Venting Your safety and the safety of others is very important. Remove parts package from We have provided many important safety messages dryer drum. Check that all 4 WARNING in this manual and on your appliance. Always read legs were included. and obey all safety messages. 4 leveling legs This is the safety alert symbol. This Parts needed: symbol alerts you to hazards that can kill or hurt you and others. All safety Check local codes and see electrical and v