Streszczenie treści zawartej na stronie nr. 1
More Time
Dry Very
More
Cool down On
Normal Less Time Louder Off
Less Auto Dry Softer
Extend trumble Bulky Items Timed Dry
Damp Rack Dry Off W i l
r nk e
Cycle Care
Permanent Press
Cycles Timed Signal
Cycles
Delicate
Power
On/Off
High Start
Medium Costomized Pause
Normal
Low
Air Only(No Heat)
Dryness
Level Temp
Time Remaining
Cycle completed
Electric Dryer
Seche-linge Genesis
Secadora Electrica
User Manual
Model # RDE400AW/R,RDE200AW,CRDE400AW/R,CRDE200AW
Guide de l Utilisateur
Modele # RDE
Streszczenie treści zawartej na stronie nr. 2
English 1. 2. Do not dry articles that have been previously cleaned in,washed in, soaked in,or spotted with gasoline, dry-cleaning solvents, or other flammable or explosive substances, as they give off vapors that could ignite or explode. 3. Do not allow children to play on or in the appliance. Close supervision of children is necessary when the appliance is used near children. 4. Before the appliance is removed from service or discarded, remove the
Streszczenie treści zawartej na stronie nr. 3
English 16. This dryer must be properly installed in accordance with the installation instructions before it is used. See grounding instructions in the installations sections. 17. Proper grounding must be ensured to reduce the risk of electric shock and force. Check with a qualified electrician or service personnel if you are in doubt as to whether the dryer is properly grounded. 18. Use the dryer only for its intended purpose, drying clothes. 19. Always disconnect
Streszczenie treści zawartej na stronie nr. 4
English Tables Of Contents PAGE Safety Instructions ............................................................................ 1 INSTALLATION INSTRUCTIONS .......................................................4-12 Tools and Materials Required..............................................................4 Electrical Requirements......................................................................4 Unpacking Your Dryer ........................................................................4 E
Streszczenie treści zawartej na stronie nr. 5
English INSTALLATION INSTRUCTIONS Select a suitable location for the dryer on a hard even surface away from direct sunlight or heat sources, baseboard heaters, cooking appliances etc. Any floor unevenness should be corrected with leveling legs located on the bottom of the dryer. Tools and Materials Required Phillips head and flathead screwdrivers Channel-lock adjustable pliers 1/2 inch open end wrench Carpenter s level Measuring tape (12ft. Min.) Duct tape Rigid or flexible metal 4 inch (10.2 cm
Streszczenie treści zawartej na stronie nr. 6
English Exhaust System Connections Requirements and Instructions 1. Do not use plastic flexible duct to exhaustthe dryer. Excessive lint can build up inside system and create a fire hazard and restrict air flow. Restricted airexhaust flow will increase dryer times. If your present system is made up of plastic duct or metal foil duct, replace it with a rigid or flexible metal duct. Ensure present duct is free of any lint prior to installing dryer duct. 2. If the dryer is not exhausted out doors,
Streszczenie treści zawartej na stronie nr. 7
English Materials Use only 4 inch (10.2cm) diameter (minimum) rigid of flexible metal duct and approved vent hood which has a swing-out damper hat open when the dryer is in operation. When the dryer stops, the dampers automatically close to prevent drafts and the entrance of insects and rodents. To avoid restricting the outlet, maintain a minimum of 12 inches (30.5cm) clearance between the vent hood and the ground or any other obstruction. The vent flap should be able to move freely. Although ve
Streszczenie treści zawartej na stronie nr. 8
English Location of Your Dryer Do Not Install Your Dryer: In an area exposed to dripping water or outside weather conditions. In an area where it will come in contact with curtains, thick carpet, or anything that will obstruct the flow of combustion and ventilation air. On carpet. Floor must be solid with a maximum slope of 1inch (2.54 cm). Installation in Mobile Home Dryer must be exhausted outside (outdoors, not beneath the mobile home) using metal ducting that will not support combustion. M
Streszczenie treści zawartej na stronie nr. 9
English Correct Incorrect Correct Incorrect Correct Incorrect 8
Streszczenie treści zawartej na stronie nr. 10
English Electrical Connections Requirements and Instructions 1. This appliance must be properly grounded. Electrical shock can result if the dryer is not properly grounded. Follow the instructions in this manual for Proper grounding. 2. Do not use an extension cord with this dryer. Some extension cords are not designed to withstand the amounts of electrical current this dryer utilizes and can melt, creating electric shock and/or fire hazard. Locate the dryer within reach of the receptacle fo
Streszczenie treści zawartej na stronie nr. 11
English 3-Wire Cord Connections USA only 1. Remove the screws securing the terminal block access cover and the strain relief mounting bracket located on the back of the dryer in the upper corner. 2. Install a U.L. approved strain relief into the power cord entry hole of the mounting bracket. Finger tighten the nut only at this time. 3. Thread a U.L. Approved 30 Amp. Power cord, NEMA 10-30 Type SRDT, through the strain relief. 4. Attach the power cord neutral (center wire) conducto
Streszczenie treści zawartej na stronie nr. 12
English 4-Wire Cord Connections Brass Terminal Green Power Cord Green Ground Ground Wire Screw Terminal Block Green Neutral Ground Wire Black Tighten Nut to These Threads Red Nut Power Cord Strain Relief Mounting Bracket 1. Remove the screws securing the terminal block access cover and the strain relief mounting bracket located on the back of the dryer upper corner . 2. Install a UL approved strain relief into the power cord entry hole of the mounting bracket . Finger tighten the nut only at
Streszczenie treści zawartej na stronie nr. 13
English 4. Thread a U.L. approved 30 Amp power cord. NEMA 14-30 type ST or SRDT through the strain relief. 5. Attach the green power cord ground wire to the cabinet with green ground screw. 6. Attach the white (neutral) power cord conductors to the outer cord and the green ground wire from the dryer harness to the brass-colored center terminal on the terminal block. Tighten the screw securely. 7. Attach the red and black power cord conductors to the outer brass-colored terminals on the
Streszczenie treści zawartej na stronie nr. 14
English OPERATING INSTRUCTIONS Understanding the Control Panel Time Remaining More Time Power Dry Very On/Off More Cool down On Normal High Less Time Louder Cycle completed Start Off Customized Medium Auto Dry Softer Extend tumble Less Pause Normal Bulky Items Low Timed Dry DAMP Off Wrinkle Air Only(No Heat) Rack Dry Care Sensor Cycle Dryness Heavy Permanent Press Timed Signal Level Temp Cycles Cycles Cotton Delicate 12 Time Remaining More Time Power Dry Very On/Off Cool down More On High Le
Streszczenie treści zawartej na stronie nr. 15
English Cycle Signal Button: (4) Used to select buzzing volume or turn off the buzzer. Timed/Cycles Button: (5) "Timed/Cycles" button will let you select your desired dry mode. Auto Dry: automatically set "Sensor Dryness Level", "Temp", "Cycle Signal", "Wrinkle Care" buttons status according to clothes loaded. Timed Dry: you can set status of "Temp", "Cycle Signal" and "Wrinkle Care" buttons and dry time with "More Time" and "Less Time" buttons by yourself. Rack Dry: the program used to dry ar
Streszczenie treści zawartej na stronie nr. 16
English Function Light Indicator: The function "display light" indicates selected feature is "ON" or the cycle is about to begin. During the dry cycle, "flashing light" indicates current running program. Rapidly flashing light indicates that the dryer is not operating properly. Preparations before drying Group the clothes of the same kind (cotton, chemical fibres, woolen) to dry. Dark and light colored clothes shall be separately dried. Fabrics prone to falling lint and those prone to adherin
Streszczenie treści zawartej na stronie nr. 17
English Load clothes into dryer Auto Dry cycle and Timed Dry cycle The appropriate load shall be 1/3 ~ 1/2 of the drum volume. Avoid too much load, for a certain space is needed to allow clothes free rotation for uniform and wrinkle- proof drying. When drying big articles, only 2-3 pieces shall be loaded at a time and supplemented with middle and small articles. For elaborate clothes or less load, two towels without lint falling may be added to get better drying and wrinkle-proof effects. Do
Streszczenie treści zawartej na stronie nr. 18
English Various button initial status for "Normal program" Cycle Signal Softer Wrinkle Care Off Normal Cycles Nixie display Indicate current program remaining time Temp High More Dry Sensor Dryness Level Timed/Cycles Auto-program 2. Press "Cycles" button to select a suitable full automatic cycle The Normal program will be automatically selected after powering on. If other full automatic program is desired, press "Auto-program Selection" button until corresponding indicator turns on.
Streszczenie treści zawartej na stronie nr. 19
English 3. Press "Sensor Dryness Level" button to select a suitable drying time After powering on, the clothes dryer automatically sets dryness at "Very", which means the normal drying time. If other drying time is desired, press "Sensor Dryness Level" button to select a shorter time. 4. Press "Temp" button to set a suitable drying temperature After switching on, the dryer sets corresponding temperature adapting to different program selected. If other drying temperature is wanted, press "Te
Streszczenie treści zawartej na stronie nr. 20
English Timed Dry cycle Time Remaining More Time Power Dry Very On/Off Cool down More On High Less Time Normal Louder Cycle completed Start Off Customized Medium Auto Dry Less Softer Extend tumble Pause Normal Bulky Items Low DAMP Timed Dry Off Wrinkle Air Only(No Heat) Rack dry Sensor Care Cycle Heavy Permanent Press Dryness Timed Signal Level Cycles Temp Cycles Cotton Delicate 4 6 2 5 7 1 3 1. Press "Power On/Off" button to power on 2. Press "Timed/Cycles" button and select "Timed Dry" cycle
