Streszczenie treści zawartej na stronie nr. 1
Streszczenie treści zawartej na stronie nr. 2
Streszczenie treści zawartej na stronie nr. 3
Limited Consumer Warranty For a period of five calendar year from the date of purchase of this device, Directed Electronics, Inc. promises to the ORIGINAL PURCHASER to repair or replace (with a comparable reconditioned model), free of cost, any electronic control module which proves to be defective in workmanship or material under normal use, SO LONG AS THE SYSTEM WAS SOLD, INSTALLED, AND SERVICED BY A PROFESSIONAL AUTO INSTALLER, AND REMAINS IN THE CAR IN WHICH THE SYSTEM WAS ORIGINALLY INSTALL
Streszczenie treści zawartej na stronie nr. 4
TO THE MAXIMUM EXTENT ALLOWED BY LAW, ANY AND ALL WARRANTIES ARE EXCLUD- ED BY THE MANUFACTURER AND EACH ENTITY PARTICIPATING IN THE STREAM OF COM- MERCE THEREWITH. THIS EXCLUSION INCLUDES BUT IS NOT LIMITED TO THE EXCLU- SION OF ANY AND ALL WARRANTY OF MERCHANTABILITY AND/OR ANY AND ALL WAR- RANTY OF FITNESS FOR A PARTICULAR PURPOSE AND/OR ANY AND ALL WARRANTY OF NON-INFRINGEMENT OF PATENTS, IN THE UNITED STATES OF AMERICA AND/OR ABROAD. NEITHER THE MANUFACTURER OR ANY ENTITIES CONNECTED THEREW
Streszczenie treści zawartej na stronie nr. 5
Table of Contents Limited Lifetime LL45 Consumer Warranty. . . . . . . . . . . . . . . . . . . . . . . . . . . i What is Included . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Important Information. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Your Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 FCC/ID Notice . . . . . . . . . . . . . . . . . . . . . . . . . . .
Streszczenie treści zawartej na stronie nr. 6
2 2004 Directed Electronics, Inc. ©
Streszczenie treści zawartej na stronie nr. 7
What is Included ■ The control module ■ An XHF2 receiver/antenna ■ One four-button LCD transmitters ■ The red status LED indicator light ® ■ A push-button Valet switch ■ Your warranty registration ■ A shut-down toggle switch Important Information Congratulations on the purchase of your remote start keyless entry system. Due to the complexity of this system, it must be installed by an authorized dealer only. Installation of this product by any- one other than an authorized dealer voids the warr
Streszczenie treści zawartej na stronie nr. 8
Your Warranty Your warranty registration must be completely filled out and returned within 10 days of purchase. Your product warranty will not be validated if your warranty registration is not returned. Make sure you receive the warranty registration from your dealer. It is also necessary to keep your proof of purchase, which reflects that the product was installed by an authorized dealer. FCC/ID Notice This device complies with Part 15 of FCC rules. Operation is subject to the following condit
Streszczenie treści zawartej na stronie nr. 9
Remote Control Diagram 2004 Directed Electronics, Inc. 5 ©
Streszczenie treści zawartej na stronie nr. 10
Standard Remote Configuration 1. Auxiliary Channel Out 2. Receive Indicator 3. Signal Indicator 4. Transmit Indicator 5. Lock Status Indicator 6. Unlock Status Indicator 7. Not applicable 8. Not applicable 9. Not applicable 10. Not applicable 11. Siren Status Indicator 12. Battery Level Indicator 13. Trigger Response Indicator 14. Not applicable 15. Ignition Switch Input Indicator 16. Not applicable 17. Not applicable 18. Not applicable 19. Not applicable 20. Vibrate Mode Indicator 21. Remote St
Streszczenie treści zawartej na stronie nr. 11
System Maintenance This system needs no specific maintenance beyond remote control battery replacement. The remote is powered by a 1.5V AAA battery. The Battery Level indicator has four level indicators that serve as a visual indication of battery charge. When the battery reaches a low charge level that requires replacement, the remote control will generate a single notification chirp, and the Battery Level indicator will flash continuously. Battery Replacement Gently pull the
Streszczenie treści zawartej na stronie nr. 12
Standard Button Configurations Button Controls the system L Lo oc ck k function by pressing this button for one second. Button Controls the system U Un nllo oc ck k function by pressing this button for one second. Button Controls an optional A Au ux xi illi ia ar ry y function, such as trunk release by pressing this button for 1.5 seconds. The auxiliary output controls __________________________. Button Controls Remote Start feature by pressing this button two times. and Buttons Controls and o
Streszczenie treści zawartej na stronie nr. 13
Icon The receive icon will be displayed while the remote control is receiving a page from the vehicle. Icon The signal icon will be displayed if a command is transmitted to the vehicle but a command page is not received. Icon The locked status icon will be displayed when the system is locked. Icon The unlock status icon will be displayed when the system is unlocked. Icon The disarm icon will flash when the system is unlocking the doors. Icon The arm icon will flash when the system is locking the
Streszczenie treści zawartej na stronie nr. 14
Icon The siren icon will display when a security feature has been trig- gered. This icon will remain displayed until the system’s page is cleared. Icon The vibrate icon will be displayed when the Vibrate Mode is on. Icon The battery level icon is always displayed as an indicator of Battery charge. Icon The start icon will be displayed while the vehicle is remote started. note: If Page Mode has been turned off, the start icon will remain when performing key take over until a button on the transmi
Streszczenie treści zawartej na stronie nr. 15
note: The icons which are ‘not applicable’ are only used when incorporated with a ESP2 Directed Security/Remote Start system. Icon The ignition icon will display if the ignition is turned on when the system (doors) are locked. Icon Not applicable. Number Icons When either of the channel 2 or 4 outputs is activated the appro- priate icon will be displayed for five seconds. Remote Operation and Programming The remote start system operates at 434 MHz and incorporates Directed’s proprietary XHF2 out
Streszczenie treści zawartej na stronie nr. 16
Command Page When a command (lock/unlock, remote start, or auxiliary channel) from the remote control is sent and received, the system will send a command page back to confirm receipt. note: When the system is in Valet mode, the remote con- trol will show the lock (5) and unlock (6) icons, but will not generate a command page. Page Recognition Mode The remote control will leave a zone icon illuminated when it has received a triggered response and will wait for you to recog- nize the violation. P
Streszczenie treści zawartej na stronie nr. 17
Beep Mode Beep Mode includes alarm arm/disarm diagnostic beeps and dis- tinctive two-tone remote start beeps. Vibrate Mode Vibrate Mode makes page notification silent but does not include diagnostic information or distinctive remote start notification. Illumination Illumination for the LCD display can be programmed on or off. When programmed on the LCD will illuminate every time the remote control receives a page or transmits a command. Programming illumination on will decrease the life expecta
Streszczenie treści zawartej na stronie nr. 18
Page Mode On/Off After entering Programming Mode, press within five seconds to toggle on and off. When the Page Mode is on, the remote control will wake up periodically to check for messages from the security module. It will also wake up when any button is pushed. When Page Mode is off, the remote control “sleeps” until a button is pushed, extending the life of the battery. To Exit Programming Mode To exit Programming Mode, take no action for five seconds. The remote control will generate two be
Streszczenie treści zawartej na stronie nr. 19
area or when having the vehicle serviced, the remote start system must be disabled using the installed toggle switch. It is the user's sole responsibility to properly handle and keep out of reach from children all remote control transmitters to assure that the system does not unintentionally remote start the vehicle. THE USER MUST INSTALL A CARBON MONOXIDE DETECTOR IN OR ABOUT THE LIVING AREA ADJACENT TO THE VEHICLE. ALL DOORS LEADING FROM ADJACENT LIV- ING AREAS TO THE ENCLOSED OR PARTIALLY ENC
Streszczenie treści zawartej na stronie nr. 20
■ After the remote start module has been installed, contact your authorized dealer to have him or her test the remote start module by performing the Safety Check outlined in the product installation guide. If the vehicle starts when per- forming the Neutral Safety Shutdown Circuit test, the remote start unit has not been properly installed. The remote start module must be removed or the installer must properly rein- stall the remote start system so that the vehicle does not start in gear. All in
