Instrukcja obsługi Vermont Castings LHEC20

Streszczenie treści zawartej na stronie nr. 1

Assembly
Determine which model fireplace insert you have. This
will be important when adjusting the height and width of
the surround.
1. Place the key (30001981) on your work surface with
the threaded holes facing up.
2. Place the column right assembly (30002073) onto
LHEACNSS Contour
the key. (Fig. 1)
3. Place the column left assembly (30002074) onto the
Trim Kit
key. (Fig. 2)
Installation Instructions
Key
Kit: KT1B80
for Models LHEC30,
LHEC20, LHER20
Column Right Assembly
Caution
Always

Streszczenie treści zawartej na stronie nr. 2

5. Fasten the upper mounting bracket to the key with 1/4-20 Wing a 1/4-20 wing screw and 1/4 flat washer finger tight. Screw (Fig. 3) 1/4 Flat Washer 6. Fasten the upper mounting bracket to both column assemblies using (2) 1/4-20 wing screws and (2) 1/4 flat washers per side finger tight. The distance between the insides of the columns should measure: Upper Mounting LHEC30 = 29 ³⁄₁₆” (741mm) Bracket LHEC20 & LHER20 = 25 ⁵⁄₈” (651mm) 7. Adjust the column/boot length (measure from the bo