Instrukcja obsługi Harbor Freight Tools 47078

Streszczenie treści zawartej na stronie nr. 1

QUICK ACTION
8-POSITION WORKBENCH
47078
ASSEMBLY & OPERATING INSTRUCTIONS
®
3

Streszczenie treści zawartej na stronie nr. 2

THANK YOU for choosing a HARBOR FREIGHT TOOLS product. For future reference, please complete the owner’s record below: Model___________ Serial No._____________ Purchase Date_____________ Save This Manual You will need the manual for the safety warnings and precautions, assembly instructions, operating and maintenance procedures, parts list and diagram. Keep your invoice with this manual. Write the invoice number on the inside of the front cover. Keep the manual and invoice in a safe and dry

Streszczenie treści zawartej na stronie nr. 3

8. Use eye and ear protection. Always wear ANSI approved impact safety goggles. 9. Do not exceed products maximum load capacity. Make certain that the Workbench can support all tools and accessories, as well as any workpiece. 10. Avoid Sharp edges when assembling. 11. Always check hardware and assembled parts after assembling. Place in an area that is flat and level. All connections should be tight and hardware tightened. 12. Do not allow children to play on, stand upon or climb upon the Wor

Streszczenie treści zawartej na stronie nr. 4

Figure 2 Washer (#15) with Hex Nut (#14) U-Frame Channel (#10) Washer (#19) Hex Nut (#18) Cross Head Bolt (#16) Grip (#28) Hex Bolt (#29) Washer (#19) Hex Nut (#18) Step 5) Through the center hole in the extension, insert Hex Bolt (#29), slide on Washer (#19) and fasten with Nut (#18)-see Figure 2. Step 6) Set the U-Frame Channel (#10) on top of the Right Leg Stand Frame (#27) as shown in Figure 2. Attach the U-Frame Channel (#10) to the Right Leg Stand Frame (#27) with Cross Head Bolt (#16); s

Streszczenie treści zawartej na stronie nr. 5

Step 9) Lay the Table Top Back (#6) on top of the Connecting Parts (#7). Through the inside hole, insert Cross Head Bolt (#3) with Washer (#4) so that it threads down through the Connecting Part (#7) and into the Check Pawl (#11) and Sliding Locking Block (#13). Step 10) Through the outside holes in the Table Top Back (#6), thread the Push Button (#2) into the Connecting Part (#7) and into the Check Pawl (#11) and Sliding Locking Block (#12). Step 11) Lay the TableTop (front) (#23) onto the Thr

Streszczenie treści zawartej na stronie nr. 6

Unpacking When unpacking your Quick Action 8-Position Workbench, check to make sure the following parts are included. If any parts are missing or broken, please call HARBOR FREIGHT TOOLS at 1-800-444-3353. Parts List- Quick Action 8-Position W\orbench Part # Description Quantity Part # Description Quantity 1 Swivel Peg 4 16 Cross Head Bolt m 8 x 45 2 2 Push Button 2 17 Spacer 9.5 mm 2 3 Cross head Bolt M8 x 65 2 18 Hex Nut 10 4 Washer 8 x 21 mm 4 19 Flat Washer 6 x 12 mm 10 5 Peg Support 2 20 H

Streszczenie treści zawartej na stronie nr. 7

Parts/Assembly Diagram 21 7A 21 7A #47078 Page 7 REV 01/05