Instrukcja obsługi Dakota Digital LAT-NR402

Streszczenie treści zawartej na stronie nr. 1

INSTALLATION INSTRUCTIONS
LAT-NR402
LED Tail Lights for 1980‐90 Caprice, 1986‐90 Impala 
1983‐84 Pontiac Parisienne 
MAN#650235 rev. B

Kit Includes:

Installation:
1. Remove the original bulb connector from the back side of the housing.
2. Remove the tail light housing from the car.
3. Remove any body trim from the housing so the screws holding the lens on are exposed.
4. Remove the tail light lens.




5. Now is a good time to clean the lens and housing. If lenses are in bad

Streszczenie treści zawartej na stronie nr. 2

7. Insert the new LED assembly through the hole where the original bulb and connector were. Use caution when feeding the wires through to avoid damaging the wire insulation. 8. Feed the wires through the large hole in the back plate and attach the back plate onto the back side of the housing. The flat side of the mounting disk should be toward the outside and the side with the slight raised center should go in toward the housing. This will align the mount in the original housing. 9.

Streszczenie treści zawartej na stronie nr. 3

12. Cut off the existing light socket as it will not be used. Do not strip the wires. Trim the wires from LED assembly to appropriate length once mounted, making sure wires are routed cleanly and securely. 13. Use the supplied moisture resistant pigtail connectors* to attach the wires from the new LED assembly to the existing vehicle harness. Insert appropriate wire from vehicle harness and mating LED assembly wire into a connector and crimp following instructions below. *For the bes