Streszczenie treści zawartej na stronie nr. 1
Series 2200
Series 1100
SST-FLTR
Instant Hot Water Dispenser
Owner’s Manual
Installation, Care & Use
Instalacion, cuidado & uso
Installation, soin et utilisation
Streszczenie treści zawartej na stronie nr. 2
® We are delighted that you have chosen the InSinkErator Instant Hot Water Dispenser to be a part of your home. This unique appliance will save you time and effort in the kitchen, and you’ll enjoy discovering new uses for it each day. That’s exactly why millions of people are now using an InSinkErator Instant Hot Water Dispenser. We are confident that by following our step-by-step instructions, you’ll soon be enjoying the convenience of instant hot water. WHAT YOU SHOULD KNOW BEFORE YOU BEGIN
Streszczenie treści zawartej na stronie nr. 3
Identify the model of your instant hot water dispenser and record it here:________________ F-HC2200 F-GN2200 F-HC2215 F-GN2215 F-HC1100 F-GN1100 HOW TO USE THIS INSTRUCTION MANUAL These instructions are separated into main sections, indicated by numbers, and subsections, indicated by capital letters. The manual is setup this way to allow you to take a break at any point after completing a section or subsection without affecting the installation process. What you’ll see in the INSTALLING THE FA
Streszczenie treści zawartej na stronie nr. 4
COMPONENTS IN THIS PACKAGE F-HC2200 F-GN2200 Rubber O-Ring Hex Nut F-HC2215 F-GN2215 Semi-circular Hex Tool Mounting Plate F-HC1100 F-GN1100 Plug (1) Snap-Connect Quick Connector Filter Head Filter Cartridge Fitting (3 pieces) Filter 3/8" Tubes (2) Discharge Tube Brass Nut / Ferrule / Tube Insert 3/4" Screws (4) SST-FLTR 4
Streszczenie treści zawartej na stronie nr. 5
If installing ONLY new faucet or new tank, see Page 10. PROPER INSTALLATION SHOULD TAKE ABOUT 2-4 HOURS START HERE PREPARATION 1 Required minimum from Identify locations for the dispenser A center of hole to wall faucet, tank and filter. 1 F-HC2215................3 ⁄8" Check to make sure there is proper 7 F-GN2215................3 ⁄8" clearance for dispenser handles to 1 F-HC2200................3 ⁄8" be fully opened. 7 F-GN2200................3 ⁄8" 1 Check to make sure counter
Streszczenie treści zawartej na stronie nr. 6
INSTALLING THE FAUCET 2 Unpack dispenser components. A On a firm, flat surface, carefully straighten the copper tubing. Property Damage: Do not pinch or break copper tubing. Do not distort the last 1 inch of tubing. Ensure that the black O-ring is B properly seated in the base of the dispenser head (the groove on the underside of the dispenser). Make sure to use rubber O-ring to ensure proper seal. Feed tubes down through the hole C in the sink or countertop until the base is
Streszczenie treści zawartej na stronie nr. 7
MOUNTING THE TANK 3 Select a spot under the sink to mount A tank vertically within reach of both Tank must be plumbing and electrical connections. mounted level The tank should be within 16" or less to ensure of faucet water lines and within 30" proper operation. or less of a standard grounded outlet. While holding tank in place on the spot selected for installation, Property Damage: Tank must be located within 16" of use a pencil to mark locations for faucet and within 30" or less
Streszczenie treści zawartej na stronie nr. 8
INSTALLING FILTRATION SYSTEM 5 Screws provided are for use in wood A studs or cabinets only. Use wall anchors (not supplied) for installation into drywall. Mark hole locations for filter head and bracket in a spot that allows for filter replacement. Drill 1/8" starter holes and attach racket to wall with wood screws, turning until snug. Remove red filter cap, insert filter Personal Injury: Do not locate filter above an outlet or other cartridge into filter head and twist electrical device.
Streszczenie treści zawartej na stronie nr. 9
FINAL WATER CONNECTION 6 Install a T-fitting (not included) A Brass Nut onto the cold water supply line. Ferrule Brass Insert Install dedicated water control valve with 3/8" compression fitting. At the end of the white 3/8" tube from the Plastic tube filter or quick-connector, slide the supplied brass nut and ferrule over the tube and then push in the brass tube insert. Insert the white 3/8" tube into the 3/8" Property Damage: Join remaining tube to cold water supply only. comp
Streszczenie treści zawartej na stronie nr. 10
IF INSTALLING ONLY NEW FAUCET A Determine if your existing tank is A, gray Release plastic shell, or B, white metal shell. Ring Release Tab At tank top, depress gray release tab 1/4" 1/4" 5/16" 7/16" 7/16" 5/16" blue blue or clear white white clear copper (if A) or release ring (if B) into quick- connect fitting securing blue or copper 1/4" tube and gently pull line Tank A Tank B out of fitting. Pull white 7/16" tube and clear 5/16" tube off fittings. Property Damage: Do not pinch or b
Streszczenie treści zawartej na stronie nr. 11
Electric Shock Hazard: Using an ungrounded or improperly connected appliance can result in serious injury or death from electrical shock. This appliance must be grounded. This instant hot water dispenser is equipped with a cord that has a grounding conductor and a grounding pin. The plug must be connected to an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances. Do not modify the plug provided with the appliance – if it will not fit the
Streszczenie treści zawartej na stronie nr. 12
CARE AND USE Electric Shock Hazard: To prevent electrical shock, disconnect power before servicing unit. Use only a properly grounded and polarized electric outlet. ADJUSTING THE THERMOSTAT FILTER GUIDE AND REPLACEMENT approx. 200° Factory temperature pre-set is Replace filter cartridge when there is an obvious 200˚F. To reset the thermostat decrease in water flow to the faucet or if there is an to 200°, turn the indicator two objectionable taste or odor to the water. notches to the right of ve
Streszczenie treści zawartej na stronie nr. 13
FILTRATION INFORMATION ® The InSinkErator Instant Hot Water Dispenser Filtration System is intended for use in filtering sediment, chlorine taste and odor from drinking water, and has not been evaluated for other uses. The system is typically installed (near or beneath a sink) where filtered drinking water is desired, and must be installed, operated and maintained as specified in the installation and use instructions. To reduce the risk associated with property damage due to water leakage: • P
Streszczenie treści zawartej na stronie nr. 14
Please read Troubleshooting Guide and/or visit ™ www.insinkerator.com before calling AnswerLine TROUBLESHOOTING PROBLEM POSSIBLECAUSE WHAT TO DO Water and steam spits • Unit is boiling. • Activate faucet lever to release some water from forcefully from spout the tank. May be normal during initial setup. without turning on the • Adjust water temperature using dial on tank front. dispenser faucet. Remember that at higher altitudes, water boils at lower temperatures. Water is not hot. • The unit
Streszczenie treści zawartej na stronie nr. 15
Serie 2200 Serie 1100 SST-FLTR Dispensador de agua caliente instantánea Manual del usuario Instalacion, cuidado & uso Installation, Care & Use Installation, soin et utilisation
Streszczenie treści zawartej na stronie nr. 16
Nos complace que haya elegido el dispensador de agua caliente instantánea ® InSinkErator para formar parte de su hogar. Con este singular electrodoméstico usted ahorrará tiempo y esfuerzo en su cocina, y disfrutará al descubrir un nuevo uso cada día. Es por eso que millones de personas utilizan hoy en día el dispensador de agua caliente instantánea InSinkErator. Confiamos en que al aplicar las instrucciones paso por paso, usted estará disfrutando pronto de los beneficios del agua caliente in
Streszczenie treści zawartej na stronie nr. 17
Identifique el número de modelo de su dispensador y anótelo aquí:________________ F-HC2200 F-GN2200 F-HC2215 F-GN2215 F-HC1100 F-GN1100 CÓMO USAR ESTE MANUAL DE INSTRUCCIONES Estas instrucciones están divididas en apartados principales indicados por números, y apartados secundarios indicados por letras mayúsculas. El manual está organizado en esta forma para permitir al usuario hacer una pausa en cualquier momento después de terminar un apartado principal o secundario sin afectar el proceso de i
Streszczenie treści zawartej na stronie nr. 18
CONTENIDO DE ESTE PAQUETE F-HC2200 F-GN2200 Anillo "O" de caucho Tuerca hexagonal F-HC2215 F-GN2215 Placa de montaje semicircular Herramienta hexagonal F-HC1100 F-GN1100 Tapón (1) Adaptador de encaje Conector rápido Cabeza Del Filtro Cartucho De Filtro a presión (3 piezas) Tubo De la Tubo de 3/8" (2) Descarga Del Filtro Tuerca de latón/Casquillo/ Inserto para tubo Tornillos de 3/4" (4) SST-FLTR 18
Streszczenie treści zawartej na stronie nr. 19
Si va a instalar SÓLO un nuevo grifo o un nuevo tanque consulte la página 24. LA INSTALACIÓN CORRECTA DEBE HACERSE ENTRE 2-4 HORAS COMIENCE AQUÍ PREPARACIÓN 1 Mínimo requerido del Identifique las ubicaciones del A centro del orificio a la pared grifo, tanque y filtro (si es el caso) del dispensador. 1 F-HC2215................3 ⁄8" (8 cm) 7 Compruebe que haya espacio libre F-GN2215................3 ⁄8" (10 cm) suficiente (vea la tabla a la izquierda) para 1 F-HC2200...............
Streszczenie treści zawartej na stronie nr. 20
INSTALACIÓN DEL GRIFO 2 Desempaque los componentes A del dispensador. Enderece con cuidado el tubo de cobre sobre una superficie firme y plana. PRECAUCIÓN Daños materiales: No apriete ni rompa el tubo de cobre. No deforme la última pulgada (2.5 cm) del extremo del tubo de cobre. Compruebe que el anillo "O" quede B sentado correctamente en la base de la cabeza del dispensador (la ranura en la parte inferior del dispensador). Asegúrese de usar una anillo "O" de caucho para obtener
