Instrukcja obsługi Zephyr Adjustable Depth Liners AK088xAS

Streszczenie treści zawartej na stronie nr. 1

AK088xAS Adjustable Depth Liners
WARNING:
When building a custom hood for a power pack, always follow all applicable construction codes and standards.
See the illustrations and table below to locate your liner choice and use corresponding custom hood
base dimensions. For the liner installation, only the bottom of the custom hood is needed. Do not
finalize the entire custom hood yet, because an opening is needed for the power pack.
Recommended
thickness:
3/4'' B
2 1/16''
A
Plywood base thickness:

Streszczenie treści zawartej na stronie nr. 2

AK088xAS Adjustable Depth Liners CAUTION: Before installing, remove any protective film from all parts. The custom hood liner must be installed before the power pack unit. For installation into shallow cabinets (20-1/2”to21-1/2“ inside depth) the power pack must be installed before the liner front panel section. This must be done because the power pack flange must fit under the liner front panel section when an overlap occurs. Refer to power pack instructions for mounting height details. 1 A C A