Instrukcja obsługi Tamarack Technologies GH.02

Streszczenie treści zawartej na stronie nr. 1

GH.02
GHOST
WHOLE hoUSE VENTILATOR
PRODUCT MANUAL & INSTALLATION GUIDE
Serial Number
Date of Purchase
Point of Purchase
The serial number is located on the shipping carton
and on a label affixed to an insulated door.
Unpacking your GHOST:
When you have unpacked your GHOST
carefully you will find the following:
One (1) GHOST
One (1) White Metal Grille w/(6) Screws
One (1) Hand Held Remote Transmitter
One (1) Remote Receiver w/ line cord & intercon

Streszczenie treści zawartej na stronie nr. 2

Installation Tools and supplies needed: You will need the following items: two pieces of 2x stock to match your existing framing, a saw to cut the hole in the ceiling, a ham- mer or screw gun to attach the blocking to the existing joists, a Phillips head screw driver to attach the grille, weather strip mate- rial and low expansion spray foam sealant. 1. The fan housing will fit either 16” or 24” on center framing. Cut two pieces of 2x stock (2 x 6 or 2 x 8 etc.) Figure 1. of the same dimension

Streszczenie treści zawartej na stronie nr. 3

6. Rotate the upper housing until it lines up with the lower housing. Make sure the edges of the two hous- ings mate all the way around the GHOST (Figure 6) and then pull the black attachment handles down over their attachment posts (Figure 7). 7. If desired, secure the GHOST to the top of the joists. 8. Plug the connector from the GHOST into the Control Box. Plug the Control Box into an unswitched, Figure 6. grounded receptacle. 9. Install the ceiling grille (screws provided). 10. Check the u

Streszczenie treści zawartej na stronie nr. 4

GHOST WHOLE hoUSE VENTILATOR PRODUCT MANUAL & INSTALLATION GUIDE Troubleshooting Programming the If the wireless fails to activate the fan try the following: GHOST Remote • The battery may need replacing. The transmitter uses a type A23/12V battery. Remove the back plate from the transmitter and remove the battery. • Remove the cover from the Following the markings, replace the battery and secure the back plate black box to the transmitter. • Push the Learn button • Check that all the