Instrukcja obsługi Marley Engineered Products PATTON GV 16

Streszczenie treści zawartej na stronie nr. 1

READ AND SAVE THESE INSTRUCTIONS
MODEL GV 16
GABLE MOUNTED
VENTILATOR
READ INSTRUCTIONS CAREFULLY BEFORE ATTEMPTING TO INSTALL, OPERATE OR SERVICE THE
PATTON ATTIC VENTILATOR. FAILURE TO COMPLY WITH INSTRUCTIONS COULD RESULT IN PERSON-
AL INJURY AND/OR PROPERTY DAMAGE!
Dimensions 7”
RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.
9
16 ⁄16”
13
5
32 ⁄16”
8 ⁄8”
Figure 2 — Dimensions
Description
IMPORTANT SAFETY INSTRUCTIONS
The Marley Engineered Products gable mounted attic ventilator is
fully automatic

Streszczenie treści zawartej na stronie nr. 2

3 6. “When cutting or drilling into wall or ceiling, Do Not damage 16 ⁄4” MIN. electrical wiring or other hidden utilities. 7. CAUTION:This unit has an unguarded impeller. Do not use in locations readily accessible to people or animals. 8. CAUTION: For general ventilation use only! Do not use to exhaust hazardous or explosive materials and vapors. 3 16 ⁄4” MIN. INSTALLATION NOTE: For maximum operating efficiency, proper intake air open- ing must be provided to allow replacement of exhaust air. O

Streszczenie treści zawartej na stronie nr. 3

MAINTENANCE 4. See Fig. 7 for wiring dehumidistat to ventilator. WARNING: MOTORS ARE THERMALLY PROTECTED AND AUTOMATICALLY TEMPERATURE CON- 120V, 60 Hz TROLLED AND MAY START WITHOUT WARNING. SUPPLY WHITE THEREFORE, MAKE CERTAIN THAT POWER SOURCE TO FAN IS DISCONNECTED BEFORE ANY ATTEMPT TO SER- GROUND MOTOR VICE OR DISASSEMBLE ANY COMPONENTS! IF BLACK POWER DISCONNECT IS OUT-OF-SIGHT, LOCK IT IN THERMOSTAT & THE OPEN POSITION AND TAG TO PREVENT APPLI- JUNCTION BOX CATION OF POWER. ASSEMBLY Lub

Streszczenie treści zawartej na stronie nr. 4

PARTS LIST REF. NO. DESCRIPTION QTY. 1 FANBLADEASSEMBLY 1 2 SHROUD ASSEMBLY 1 3 + SHROUD 1 4 + POP RIVET, 1/8 X 1/8 STEEL 8 * STANDARD HARDWARE ITEM AVAILABLE 5 * SCREW 1/4”- 20 X 1.5” 2 LOCALLY 6 + MOTOR BAND 1 + NOT AVAILABLE AS A REPLACEMENT PART 7 + MOTOR BRACKET 4 † ITEM NOT SHOWN 8 SPEED NUT, 1/4 X 20 1 9 + RIVET, 1/8 X 5/32 STEEL 8 10 MOTOR, PSC 115V 1/5 HP 1 11 BOOT, CAPACITOR TERMINAL COVER 1 12 CAPACITOR, 4 MFD, 370 VAC 1 13 * KEPS NUT, #8-32 1 14 CUP, BX 1 15 CONDUIT, FLEXIBLE 1 16 T