Instrukcja obsługi Senco PC1130

Streszczenie treści zawartej na stronie nr. 1

PC1130 Electric
Air Compressor
Senco Products Inc.
8485 Broadwell Road
Operating Instructions
Cincinnati, Ohio 45244
by Senco Products, Inc.
© 2006
Warnings for the safe use of this tool are included in this manual.
PC1130 Electric Compressor
Issued Oct. 18, 2006
Questions? Comments?
call SENCO’S toll-free Action-line: 1-800-543-4596
or e-mail: toolprof@senco.com Visit our Website www.senco.com

Streszczenie treści zawartej na stronie nr. 2

2

Streszczenie treści zawartej na stronie nr. 3

3

Streszczenie treści zawartej na stronie nr. 4

4

Streszczenie treści zawartej na stronie nr. 5

5

Streszczenie treści zawartej na stronie nr. 6

6

Streszczenie treści zawartej na stronie nr. 7

7

Streszczenie treści zawartej na stronie nr. 8

COMPRESSORFEATURES COMPRESSOR FEATURES 1) MOTOR/PRESSURE SWITCH: This switch is used to start or stop the air 1 compressor. Moving the switch to the "Auto" (On) position will provide automatic power 3 to the pressure switch which will allow the motor to start when the air tank pressure is below the factory set "cut-in" pressure. When in the On Position, the pressure switch 15 1 stops the motor when the air tank pressure reaches the factory set "cut-out" pressure. For safety purposes, this switch

Streszczenie treści zawartej na stronie nr. 9

COMPRESSORFEATURES 1) MOTOR/PRESSURE SWITCH: This switch is used to start or stop the air 1 compressor. Moving the switch to the "Auto" (On) position will provide automatic power to the pressure switch which will allow the motor to start when the air tank pressure is below the factory set "cut-in" pressure. When in the On Position, the pressure switch stops the motor when the air tank pressure reaches the factory set "cut-out" pressure. For safety purposes, this switch also has a pressure releas

Streszczenie treści zawartej na stronie nr. 10

3. Remove plug from cylinder head port and replace w/ air filter. 10

Streszczenie treści zawartej na stronie nr. 11

OPERATION PRE-START CHECKLIST: 1. Check oil level. Add if necessary. 2. Remove any moisture in the air compressor air tank. Remove excessive pressure with an air tool or by pulling the safety relief valve ring, then open the air tank drain valve in the bottom of the air tank. Close tightly when drained. WARNING: Risk of bodily injury. NEVER attempt to open the drain valve when more than 10 PSI of air pressure is in the air tank! 3. Make sure the air compressor Motor Switch is in the “OFF” pos

Streszczenie treści zawartej na stronie nr. 12

ON position, motor runs continuously. 12

Streszczenie treści zawartej na stronie nr. 13

13

Streszczenie treści zawartej na stronie nr. 14

14

Streszczenie treści zawartej na stronie nr. 15

PC1130 1.0 running, 1.5 peak 13 Amperage 3400 Oil Capacity 7 oz. Foam Insert 2.5 gallon 90 3.5 3.2 38 seconds 10 seconds 39 lbs 42 21”x8”x18.5” Running Duty Type S1 @ 100 psig Noise 79 dBA 15

Streszczenie treści zawartej na stronie nr. 16