Instrukcja obsługi Plantronics 50-0230B-003

Streszczenie treści zawartej na stronie nr. 1

KEMCO



FOR
50 - 0230B - 002
50 - 0230B - 003
50 - 0230B - 004
SUBURBAN






















These instructions





1. #2 Phillips screwdriver 2. Powered screwdriver or drill with adapter
3. T - 15 TORX bit driver 4. Razor knife or similar
5. T - river 6.

Streszczenie treści zawartej na stronie nr. 2

Description 4 1 SCREW, # 6 X 1/2" PPH 4 2 SCREW, # 6 X 3/8" PPH 4 3 SCREW, # 8 X 2 1/2" PFH 3 4 SCREW, #8 X 1 1/ 2 5 1 6 1 7 LIGHT 2 8 LIGHT TRIM 2 9 PLYWOOD, 3/8" X 6" X 14" 1 10 , 6 - 6 11 4 12

Streszczenie treści zawartej na stronie nr. 3

head. See Figure 1. four tabs on back of control assembly. See Figure 2. Discard cloth covered trim ring. 3. removing center cover and (2) two screws. 4. 5. 3 FIGURE 3 l

Streszczenie treści zawartej na stronie nr. 4

Caution: Bef Cut only where indicated. contacts rear edge of recessed area. See Fig. 5. # 8 x 3/4" TEK screws. See Figure 6. 4 FIGURE 6 8. Secure bracket to sheet metal frame using (4) four FIGURE 5 roof. Slide bracket rearward until flange the metal inner area. Align the front mounting tabs with the openings in 7. I

Streszczenie treści zawartej na stronie nr. 5

10. Remove and retain the (2) two door scuff 11. nts to the 12. 5 FIGURE 9 nd lay aside. See Figure 9. headliner a side of vehicle. Unsnap upper door trim from head bolt and bracket. Carefully pull panel away from bracket for the seat belt. Remove and retain TORX Unsnap the cover from upper and lower

Streszczenie treści zawartej na stronie nr. 6

6” wide x 8 3/4” long. Make sure that the 6” Caution: Before only where indicated. opening and rotate 90 degrees. See Figure 10. 16. 17. re using (1) one 18. 11. NOTE: Additional assistance in mounting the overhead console in vehicle is advised 6 to prevent damage to console or components. III. INSTALLATION OF

Streszczenie treści zawartej na stronie nr. 7

opening to B - B - instructions included with the antenna. 12 Caution: Do not overtighten screws. Use secured to the vehicle. Failure to do 2 - 32 X 3/4" on console 13 two # 8 x 1 1/4" screws. Make sure console is centered - 2. 14

Streszczenie treści zawartej na stronie nr. 8

c around control head. Insert control 2 1/2" screws at the rear light. Make 29. Ins 1 5 IMPORTANT - TORQUE SEAT BELT BRACKET TO MFG. . 32 . 16 8 FIGURE Install door scuff plates in original position. iginal position. “B” pillar in or 31. Reinstall handle and door trim to top of SPECIFICATION fasteners. secure seat belt bracket us