Streszczenie treści zawartej na stronie nr. 1
PLANAR LCD MONITOR PT120/PL120 MANUAL www.planar.com
Streszczenie treści zawartej na stronie nr. 2
Preface PREFACE About this manual This manual is designed to assist you in setting up and using the LCD monitor. Information in this document has been carefully checked for accuracy; however, no guarantee is given to the correctness of the contents. The information in this document is subject to change without notice. This document con- tains proprietary information protected by copyright. All rights are reserved. No part of this manual may be reproduced by any mechanical, electronic or o
Streszczenie treści zawartej na stronie nr. 3
User’s Manual • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and the receiver. • Connect the equipment into an outlet different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. Caution: To comply with the limits for an FCC Class B computing device, always use the shielded signal cord supplied with this unit. The Federal Communications Commission warns that changes or modifica
Streszczenie treści zawartej na stronie nr. 4
Preface Important Safety Instructions Please read the following instructions carefully. This manual should be retained for future use. 1. To clean the LCD Monitor screen, first, make sure the Monitor is in the power off mode. Unplug the Monitor from its power source before cleaning it. Do not spray liquid cleaners directly onto the unit. Stand away from the LCD Monitor and spray cleaning solution onto a rag. Without applying excessive pressure, clean the screen with the slightly damp
Streszczenie treści zawartej na stronie nr. 5
User’s Manual TABLE OF CONTENTS PREFACE ........................................................................................................................................................................I TABLE OF CONTENTS .............................................................................................................................................IV CHAPTER 1............................................................................................................
Streszczenie treści zawartej na stronie nr. 6
Chapter 1 CHAPTER 1 The LCD Monitor Your New LCD Monitor! Your LCD Monitor has been designed to be versatile, ergonomic and user-friendly. The LCD Monitor is capable of displaying most standards, from 640 x 480 VGA to 1024 x 768 XGA. The digital controls lo- cated on the front panel allows the user to easily adjust the Monitor’s display parameters. The LCD Monitor’s small footprint allows you more room in your workspace for other peripherals. Lightweight and compact, the LCD Monitor
Streszczenie treści zawartej na stronie nr. 7
User’s Manual Identifying Components The LCD Monitor has been designed to provide easy access to all controls and peripheral ports. The follow- ing figures will help you identify the LCD Monitor’s controls and ports. The LCD Monitor — Front View Figure 1-1: The LCD Monitor Panel and Controls LCD Screen The LCD Monitor Screen is capable of producing most display standards. Function Control Buttons st nd The 1 button allows you to pop up the OSD Menu and to select the function grou
Streszczenie treści zawartej na stronie nr. 8
Chapter 1 The LCD Monitor — Rear View Figure 1-2: LCD Monitor’s Rear Ports LCD Monitor’s VGA Connector This 1.5 meter cable has two 15-pin D-Sub VGA connectors used to connect the monitor to your PC’s VGA card. AC Power Jack Connect the AC adapter cable to this jack. PS/2 Connector for Optional Touch Screen Connect this PS/2 connector to your PC’s RS232 9-pin serial port connector to use the Op- tional Touch Screen. A PS/2 to RS232 cable is provided with the Optional Touch Screen
Streszczenie treści zawartej na stronie nr. 9
User’s Manual Adjusting the Viewing Angle Your LCD Monitor is designed to allow you to adjust it to a comfortable viewing angle. The LCD Moni- tor’s angle setting range is from -5° to 25°. Please see Figure 1-3. Figure 1-3: Angle Settings • When positioning the equipment, make sure that the main ports and sockets are easily ac- cessible. • Do not place your LCD Monitor close to a heat source. • Do not place the LCD Monitor in direct sunlight or near a window. Moisture and direc
Streszczenie treści zawartej na stronie nr. 10
Chapter 1 Figure 1-5: Connecting Power to the LCD Monitor Connecting Video Turn off your PC and the LCD Monitor before connecting your LCD Monitor to the com- puter. Connect the VGA signal cable to the D-sub VGA connector located at the rear of the monitor. Connect the other end of the signal cable to the PC’s VGA port. Please refer to Figure 1-6. VGA Connector Figure 1-6: Connecting the LCD Monitor to the PC Make sure the signal cable heads are securely connected to the VGA ports
Streszczenie treści zawartej na stronie nr. 11
User’s Manual Connecting the Stereo Speakers (optional) Please refer to the following instructions for connecting the LCD Monitor’s stereo speakers. Connect the 1.5M sound cable to the Line out of your PC’s audio card. Connect the other end of the 1.5M sound cable to the LCD Monitor’s line-in jack. Please re- fer to Figure 1-7. Audio Line out Figure 1-7: Connecting the Stereo Speakers You can adjust the sound volume of the stereo speakers by using the speaker volume control function o
Streszczenie treści zawartej na stronie nr. 12
Chapter 1 Connect the 9-pin RS232 connector end of the PS/2 to RS232 cable provided with the op- tional touch screen package to the 9-pin RS232 serial port at the back of your PC. Please refer to Figure 1-8. Power Management System The LCD Monitor complies with the VESA DPMS (version 1.0p) power management proposal. The VESA DPMS proposal provides four phases of power saving modes by detecting the horizontal or vertical sync signal. When the LCD Monitor is in power saving mode or detec
Streszczenie treści zawartej na stronie nr. 13
CHAPTER 2 The Display Controls The LCD Monitor’s Display Controls This chapter covers the LCD Monitor’s On Screen Display (OSD). Using the OSD, you can adjust the con- trast, brightness, display position, display clarity, and color temperature. You can also adjust the stereo speaker volume and set OSD parameters. Please read this chapter carefully to get the most out of your LCD Monitor. Adjusting the Monitor’s Display The LCD Monitor features an intuitive, menu-driven, On-Screen Displ
Streszczenie treści zawartej na stronie nr. 14
Chapter 2 (Basic Setting) To adjust the contrast level of the display. (CONTRAST) To adjust the brightness level of the display. (BRIGHTNESS) To adjust the speaker audio volume. (VOLUME) (Exclude 12.1 Inch) (POSITION) To automatically adjust the picture quality and alignment. It is recommended that you use this function in (AUTO-ADJUST) the windows (This function does not work in the interlaced modes) or similar environments. To adjust the screen display for focus
Streszczenie treści zawartej na stronie nr. 15
User’s Manual Note: 1. No Signal coming When the monitor is ON and there is no Video signal re- ceived, the following message will be displayed. 2. Signal out of monitor’s supported range (Please refer to tht attached Addendum) When the frequency range is out of the monitor’s specifications, the display will show the following message on two cases: Case 1: The incoming resolution is lower than or equal to1024x768. In this case, the screen display will not be centered and a warnin
Streszczenie treści zawartej na stronie nr. 16
APPENDIX A Technical Information TFT LCD Monitor Specifications Model MT121/MT121T LCD Panel 12.1”SVGA Control Functions Power Software Power switch with LED indicator (Press to turn off, over 1 sec. to turn on) On-Screen Display BASIC SETTING -----CONTRAST / BRIGHTNESS (OSD) POSITION --------------AUTO ADJUST / PHASE / CLOCK / H- POSITION / V- POSITION / GRAPH/TEXT / RESET MISCELLANEOUS ---OSD H-POSITION / OSD V-POSITION/ MENU TIMER
Streszczenie treści zawartej na stronie nr. 17
APPENDIX B Supported Timing Timing for Model PT1212N (SVGA Resolution) Vertical Horizontal Scanning Scanning Item Standards Resolution Dot Clock Frequency Frequency (MHz) (Hz) (kHz) 1 NEC PC98 640x400 25.20 70.15 31.50 2 NEC PC98 640x400 21.05 56.42 24.83 3 MAC 13" mode 640x480 30.24 66.67 35.00 4 MAC 16" mode 832x624 57.28 74.55 49.73 5 MAC 17" mode 1024x768 80.00 75.02 60.24 6 VGA 640x350 25.18 70.09 31.47 7 VESA 640x350 31.5 85.08 37.86 8 VGA 640x400 25.18 70.09 31.47 9 VESA 640x
Streszczenie treści zawartej na stronie nr. 18
APPENDIX C Troubleshooting Troubleshooting Procedures This LCD Monitor was pre-adjusted in the factory with standard VGA timing. Due to output timing differ- ences among various VGA cards, you may initially experience an unstable or unclear display when a new display mode or new VGA card is selected. This LCD Monitor Supports Multiple VGA Modes. Refer to Addendum for a listing of the fac- tory preset modes supported by this LCD Monitor. PROBLEM: Display is Unclear and Unstable To sta
Streszczenie treści zawartej na stronie nr. 19
User’s Manual If the PC doesn’t function with the CRT monitor neither, check BIOS to see if there is a dual scan setting under the display mode item. Set the BIOS display mode to Dual Scan or CRT and try again. If there is still no display, then there may be a problem with your system. Contact technical support. If the power LED is not lit, check to see if the AC power connector is securely connected. Verify that the AC adapter LED is lit. If the AC adapter LED is not lit, please con
Streszczenie treści zawartej na stronie nr. 20
"
F Customer Service E-mail: desktopmonitors@planar.com Tel: 1-866-PLANAR-1 (1-866-752-6271) Hours: M-F, 7am - 6pm Pacific Time © 2002 Planar Systems, Inc. 05/02 Planar is a registered trademark of Planar Systems, Inc. Other brands and names are the property of their respective owners. Technical information in this document is subject to change without notice.
