Instrukcja obsługi Jeep 50-0284x-015 Series

Streszczenie treści zawartej na stronie nr. 1

FOR
50 - - 015 SERIES 1181313
JEEP GRAND CHEROKEE






















These in








5. 18 GA wire 4' - 6' 6. Scissors
7. 5/16” Hex Socket Bit
ht


NOT FOR VEHICLES EQUIPPED WITH SUN ROOF.


June 2, 1999
-
Printed in the U.S.A
0031A INSTALLATION INSTRUCTION # 44
11. Audiovox Seri

Streszczenie treści zawartej na stronie nr. 2

1 1 4 - 2 6 3 4 2 SCREW, # 8 X 1 1/2" PWH 4 1 2 5 3 1 6 7 1 4 8 1 9 1 10 1 5 11 1 - 0031A June 2, 1999 Printed in the U.S.A.

Streszczenie treści zawartej na stronie nr. 3

I. PR Caution: that the 9" & 7" cuts are centered left to right in vehicle. See Figure 1. 3. 4. 5. Construct a jump wire. Connect the black wire to the O.E. yellow/green wire. See Figure 3. . 3 FIGURE 3 7. Install O.E. conso

Streszczenie treści zawartej na stronie nr. 4

l Note: There is engage tabs of bracket if foam is in that area. unting bracket (Item 7 pg. 2) over rear and edge of bracket with front O.E. brace. Secure using (4) four # 10x 1/2" screws. (Item 1 pg.2) 4 FIGURE 5 See Figure 5.

Streszczenie treści zawartej na stronie nr. 5

- Down the C - pillar to the floor. Route the power lead to an accessory controlled source. nsion, etc.) to the (2) two 6 - 32 x 3/4" screws (item 2 pg. 2) through 4 pg. 2). Make sure console - 32 5 FIGURE 7 screws previously installed. See Figure 7. alignment is straight then tighten (2) two 6 1 1/2" screw (item Loosely secure rea

Streszczenie treści zawartej na stronie nr. 6

Lower video screen to viewing position for acc Note : Make sure wires do not get pinched between video system and console. - Caution : Do not overtighten screws. installed to secure rear of Caution: Do not overtighten screws or damage to 19. 20. (2) # 6 X 1